部分相干电磁光束在湍流介质中传输的偏振变化

 从推广的惠更斯-菲涅尔原理出发，推导出了部分相干电磁光束的偏振态在湍流介质中传输的表达式。并以电磁高斯-谢尔模型(EGSM)光束为例，研究了湍流对电磁高斯-谢尔模型光束偏振态的影响。研究结果表明，对于轴上点，湍流介质的折射率结构常数越大，偏振度趋于最大值的速度越快，达到的最大值越小；光斑越大，偏振度达到最大值的位置离光源越远，在光斑增大的过程中，偏振度所达到的极大值会先增大后减小，最后保持与光源相同的偏振度不变。对于轴外点，一个固定的z，光的偏振度随着离轴距离的增大而逐渐下降，并最终等于零。折射率结构常数越大，偏振度随离轴距离的增大而下降得越缓慢；光斑越大，偏振度随离轴距离的增大下降得越快。     

Total Variation and Multisymplectic Structure for CNLS System

The relation between the total variation of classical field theory and the multisymplectic structure is shown. Then the multisymplectic structure and the corresponding multisymplectic conservation of the coupled nonlinear Schrodinger system are obtained directly from the variational principle.     

一类非线性Schr(o)dinger方程的守恒差分法与Fourier谱方法

考察了一类带导数项的非线性Schrodinger方程的周期边值问题，提出了一种守恒的差分格式，在空间方向上采用Fourier谱方法，证明了格式的稳定性和收敛性．数值试验得到了与理论分析一致的结果．     

CsNiCl3晶体的光谱精细结构、零场分裂参量及Jahn-Teller效应

应用不可约张量理论构造了三角对称晶场中3d²/3d⁸态离子的45阶可完全对角化的微扰哈密顿矩阵，研究了CsNiCl₃晶体的光谱精细结构、晶体结构、零场分裂参量、Jahn-Telller效应以及自旋单重态对Ni²⁺离子基态能级的影响，理论与实验相符合.在此基础上，进一步研究了以前工作中被忽略的自旋-自旋耦合作用和Trees修正对CsNiCl₃晶体的光谱精细结构和零场分裂参量的影响，发现有四种机理会影响零场分裂参量：1)自旋-轨道耦合机理，2)自旋-自旋耦合机理；3)自旋-轨道与自旋-自旋联合耦合机理；4)自旋-轨道与Trees修正联合耦合机理，其中自旋-轨道耦合机理是最主要的，其他三种机理也是不可忽略的. 关键词： 基态能级 精细结构 零场分裂 自旋-自旋耦合     

B_2分子X~3Σ_g~-和A~3Σ_u~-态的势能函数

使用SAC/SAC-CI方法,利用D95(d),6-311g**以及cc-PVTZ等基组,对B2分子的基态(X3Σg-)和第一激发态(A3Σu-)的平衡结构和谐振频率进行了优化计算.通过对3个基组的计算结果的比较,得出了D95(d)基组为3个基组中的最优基组的结论;使用D95(d)基组,利用SAC的GSUM(Group Sum of Operators)方法对基态(X3Σg-),SAC-CI的GSUM方法对激发态(A3Σu-)进行单点能扫描计算,用正规方程组拟合Murrell-Sorbie函数,得到了相应电子态的完整势能函数;从得到的势能函数计算了与基态(X3Σg-)和第一激发态(A3Σu-)相对应的光谱常数(Be,αe,ωe和ωeχe),结果与实验数据吻合.     

The Lamb-dip spectrum of methylcyanide: Precise rotational transition frequencies and improved ground-state rotational parameters

Methylcyanide, CH₃CN, is an important interstellar species, and therefore the accurate knowledge of precise rest frequencies for rotational transitions as well as ground-state rotational and hyperfine constants is needed. In this work the hyperfine structure of the millimeter- and submillimeter-wave spectra of CH₃CN has been further investigated. In addition, accurate THz measurements have been carried out for the first time. Consequently, the present investigation allowed us to provide the most accurate ground state rotational and hyperfine parameters known at the moment for CH₃C¹⁴N. To resolve the hyperfine structure of the rotational transitions observed, the Lamb-dip technique has been exploited. Both frequency-modulated and video-type detections have been employed.     

Surface structures formed by individual adsorption and coadsorption of Mn and Bi on Cu(0 0 1), studied by LEED

We have studied the individual adsorption of Mn and Bi, and their coadsorption on Cu(0 0 1) by low-energy electron diffraction (LEED). For Mn, we have determined the c(2 × 2) structure formed at 300 K, whose structure had been determined by several methods. We reconfirmed by a tensor LEED analysis that it is a substitutional structure and that a previously reported large corrugation (0.30 Å) between substitutional Mn and remaining surface Cu atoms coincides perfectly with the present value. In the individual adsorption of Bi, we have found a c(4 × 2) structure, which is formed by cooling below ∼250 K a surface prepared by Bi deposition of ∼0.25 ML coverage at 300 K where streaky half-order LEED spots appear. The c(4 × 2) structure has been determined by the tensor LEED analysis at 130 K and it is a substitutional structure. In the coadsorption, we found a c(6 × 4) structure, which has been determined by the tensor LEED analysis. It is very similar to the previously determined structure of the c(6 × 4) formed by coadsorption of Mg and Bi, and embedded MnBi₄ clusters are arranged in the top Cu layer instead of MgBi₄. Large lateral displacements of Bi atoms in the c(6 × 4)-(Mn + Bi) suggest that the Mn atoms undergo the size-enhancement caused by their large magnetic moment.     

一类机器人系统的最优控制

本文通过把结构阻尼系数当作控制变量来讨论一类弹性机器人系统的最优控制问题 ,并利用Banach空间几何性质证明了最优控制元的存在唯一性     

A comparative study of the structure and crystallization of bulk metallic amorphous rod Pr60Ni30Al10 and melt-spun metallic amorphous ribbon Al87Ni10Pr3

Pr-based bulk metallic amorphous （BMA） rods （Pr60Ni30Al10） and Al-based amorphous ribbons （Al87Ni10Pr3） have been prepared by using copper mould casting and single roller melt-spun techniques, respectively. Thermal parameters deduced from differential scanning calorimeter （DSC） indicate that the glass-forming ability （GFA） of Pr60Ni30Al10 BMA rod is far higher than that of Al87Ni10Pr3 ribbon. A comparative study about the differences in structure between the two kinds of glass-forming alloys, superheated viscosity and crystallization are also made. Compared with the amorphous alloy Al87Ni10Pr3, the BMA alloy Pr60Ni30Al10 shows high thermal stability and large viscosity, small diffusivity at the same superheated temperatures. The results of x-Ray diffraction （XRD） and transmission electron microscope （TEM） show the pronounced difference in structure between the two amorphous alloys. Together with crystallization results, the main structure compositions of the amorphous samples are confirmed. It seems that the higher the GFA, the more topological type clusters in the Pr-Ni-Al amorphous alloys, the GFAs of the present glass-forming alloys are closely related to their structures.     

A study of structural, compositional and optical properties of spray-deposited non-stoichiometric (Zn,Fe)S thin films

Non-stoichiometric ternary chalcogenides (Zn,Fe)S were prepared in the film form by pyrolytic spray deposition technique, using air/nitrogen as the carrier gas. The precursor solution comprised of ZnCl₂, FeCl₂ and thiourea. The depositions were carried out under optimum conditions of experimental parameters viz. carrier gas (air/nitrogen) flow rate, concentration of precursor constituents, nozzle substrate distance and temperature of quartz substrate. The deposited thin films were later sintered in argon at 1073 K for 120 min.The structural, compositional and optical properties of the sintered thin films were studied. X-ray diffraction studies of the thin films indicated the presence of (Zn,Fe)S solid solution with prominent cubic sphalerite phase while surface morphology as determined by scanning electron microscopy (SEM) revealed a granular structure.The chemical composition of the resulting thin films as analyzed by energy dispersive X-ray analysis (EDAX) reflected the composition of the precursor solutions from which the depositions were carried out with Fe at% values ranging from 0.4 up to 33.SEM micrographs of thin films reveal that the grain sizes of the thin films prepared using air as carrier gas and N₂ as carrier gas are in the vicinity of 300 and 150 nm, respectively.The diffuse transmittance measurements for thin films, as a function of wavelength reveal the dependence of direct optical band gap on Fe content and type of phase.