Development and characterization of hydroquinone-loaded nanofiber for topical delivery: effect of chitosan

Hydroquinone (HQ) loaded polymer solution was electrospun for its topical application. Nanofibers were then investigated in terms of stability, drug release, and antifungal activity. The effect of chitosan (CS) was investigated on the viscosity, stability, drug release, and antifungal activity of the developed formulation. Results indicate a significantly stable HQ-loaded nanofiber formulation. The addition of CS caused hydration of the drug delivery system and enhanced drug release but reduced its stability. HQ-loaded nanofiber mat showed significant antifungal activity, however, there was no inhibition zone in samples containing CS.     

Imidazolium Based Surface Active Ionic Liquids as Novel Micellar Media for Simultaneous and Sensitive Electrochemical Detection of Dopamine and Ascorbic Acid

Surface active ionic liquid (SAIL) micelle assisted, simultaneous and highly sensitive electrochemical sensing of dopamine (DA) and ascorbic acid (AA) is presented. Results presented herein establish that SAILs viz.1‐dodecyl‐3‐methyl imidazolium chloride ([DDMIM][Cl]), 1‐octyl‐3‐methyl imidazolium chloride ([OMIM][Cl]) and 1‐butyl‐3‐methyl imidazolium chloride ([BMIM][Cl]) exhibit a probe and SAIL nature/concentration specific impact on the redox behaviour of hydroquinone (H₂Q), dopamine (DA) and ascorbic acid (AA). To our observations, the electrochemical behaviour of DA and AA is affected oppositely by SAILs with the apparent effects being more appreciable in presence of [DDMIM][Cl]. In the presence of [DDMIM][Cl] micelles, the electro‐oxidation of AA was observed to occur at potentials about 350 mV less positive than required for electrooxidation of DA, an important advantage that minimises the interference of former in sensing of the later. The peak to peak potential separation of 350 mV observed in presence of [DDMIM][Cl] micelles is the largest to be reported so far. The DPV signal for DA and AA displayed a linear response in the concentration range of 6.6 to 99.9 μM and 6.6 to 131.5 μM respectively. Very low detection limits of 0.0161 μM for DA in presence of 39.8 μM AA and 0.0227 μM for AA in presence of 39.8 μM DA were estimated in micellar phase of [DDMIM][Cl].     

A Ready‐to‐Use Electrochemical Kit Design for the Diagnosis of Single Nucleotide Polymorphisms

In this study, for the first time a model electrochemical kit was constructed for the detection of a functional polymorphism in catechol‐O‐methyl transferase (COMT) gene which is important for diagnosis of neuropsychiatric disorders as Alzheimer disease. The disposable pencil graphite electrode (PGE) is designed as a “kit” and the probe DNA covered PGE can detect single nucleotide polymorphisms (SNPs) from real samples based on the guanine oxidation signal even after 5 months of kit preparation (150 days durability).The detection limit (S/N=3) of the biosensor was calculated as 1.18 pmol of synthetic target sequence and 6.09×10⁵ molecules of real samples in 30 min detection time.     

Discrimination and simultaneous determination of hydroquinone and catechol by tunable polymerization of imidazolium-based ionic liquid on multi-walled carbon nanotube surfaces

Tunable polymerization of ionic liquid on the surfaces of multi-walled carbon nanotubes (MWCNTs) was achieved by a mild thermal-initiation-free radical reaction of 3-ethy-1-vinylimidazolium tetrafluoroborate in the presence of MWCNTs. Successful modification of polymeric ionic liquid (PIL) on MWCNTs surfaces (PIL-MWCNTs) was demonstrated by scanning electron microscopy, transmission electron microscopy, Fourier transform infrared spectroscopy, thermogravimetric analysis and X-ray photoelectron spectroscopy. The resulting PIL-MWCNTs possessed unique features of high dispersity in aqueous solution and tunable thickness of PIL layer, due to positive imidazole groups along PIL chains and controllable ionic liquid polymerization by tuning the ratio of precursor. Based on cation-π interaction between the positive imidazole groups on PIL-MWCNTs surface and hydroquinone (HQ) or catechol (CC), excellent discrimination ability toward HQ and CC and improved simultaneous detection performance were achieved. The linear range for HQ and CC were 1.0 × 10⁻⁶ to 5.0 × 10⁻⁴ M and 1.0 × 10⁻⁶ to 4.0 × 10⁻⁴ M, respectively. The detection limit for HQ was 4.0 × 10⁻⁷ M and for CC 1.7 × 10⁻⁷ M (S/N = 3), correspondingly.     

Analytical application of the poly(1H-1,2,4-triazole-3-thiol) modified gold electrode for high-sensitive voltammetric determination of catechol in tap and lake water samples

ABSTRACT

In this work, a simple, sensitive and rapid method for the determination of trace amounts of catechol (CT) in aqueous media has been suggested. For this purpose, poly(1H-1,2,4-triazole-3-thiol) film was electrochemically deposited successfully at the gold electrode (Au/T3T). The electrochemical behaviour of CT was studied on the Au/T3T electrode by the cyclic voltammetry and differential pulse voltammetry techniques. The anodic peak current value and the concentration of CT showed a good linear relationship in the range of 0.015–2.8 µM. The limit of detection was found as 1.88 nM (S/N = 3). Besides, the reproducibility, repeatability, stability and interference measurements were also assayed. This sensor was applied successfully for the detection of CT in synthetic and real samples.     

Investigation of metal activation of a partially purified polyphenol oxidase enzyme electrode

Biosensors can be developed using different biological materials and immobilization technologies. Enzymes are generally used in biosensor construction, and some enzymes need metal ions or small organic molecules as a cofactor for their activation. Polyphenol oxidases can be activated by several metal ions such as Cu²⁺, Mg²⁺, Zn²⁺, Mn²⁺, and Ni²⁺. In this study, a new measurement method has been developed that is based on the metal ion activation of the polyphenol oxidase enzyme used in the biosensor preparation, especially to determine the concentration of Mg²⁺ ions. Polyphenol oxidase (PPO) (EC 1.10.3.1) was partially purified from potato (Solanum tuberosum) by using (NH₄)₂SO₄ precipitation, dialysis, and lyophylization processes. As a result of this processes, approximately 30-fold purification was achieved for PPO. For construction of the biosensor, the enzyme was immobilized on the dissolved oxygen probe membrane using gelatin and glutaraldehyde (2.5%). Using the biosensor, we obtained responses for catechol in the absence and presence of Mg²⁺ ions. Differences between the biosensor responses were related to the concentration of Mg²⁺ ions. The biosensor response depends linearly on concentration of Mg²⁺ ions between 0.05 and 7.5?mM. In the optimization studies, phosphate buffer (pH 7.0, 50?mM) and 35°C were determined to be the optimum conditions. This project will be a novel biosensor study and it might bring a new term, ‘activation based biosensor’ into the biosensor area.     

Effects of Coverage,Water, and Defects on Catechol/TiO2 Interface

Catechol adsorbed on TiO₂ is one of the simplest models to explore the relevant properties of dye-sensitized solar cells. However, the effects of water and defects on the electronic levels and the excitonic properties of the catechol/TiO₂ interface have been rarely explored. Here, we investigate four catechol/TiO₂ interfaces aiming to study the influence of coverage, water, and defects on the electronic levels and the excitonic properties of the catechol/TiO₂ interface through the first-principles many-body Green's function theory. We find that the adsorption of catechol on the rutile (110) surface increases the energies of both the TiO₂ valence band maximum and conduction band minimum by approximately 0.7 eV. The increasing coverage and the presence of water can reduce the optical absorption of charge-transfer excitons with maximum oscillator strength. Regarding the reduced hydroxylated TiO₂ substrate, the conduction band minimum decreases greatly, resulting in a sub-bandgap of 2.51 eV. The exciton distributions in the four investigated interfaces can spread across several unit cells, especially for the hydroxylated TiO₂ substrate. Although the hydroxylated TiO₂ substrate leads to a lower open-circuit voltage, it may increase the separation between photogenerated electrons and holes and may therefore be beneficial for improving the photovoltaic efficiency by controlling its concentration. Our results may provide guidance for the design of highly efficient solar cells in future.     

Development of Biosensor for Catechol Using Electrosynthesized Poly(3‐methylthiophene) and Incorporation of LAC Simultaneously

Simultaneous electropolymerization of 3‐methylthiophene and incorporation of Laccase (LAC) was carried out in the presence of propylene carbonate as a medium by amperometric method. This enzyme modified electrode was used for the sensing of polyphenol. Catechol is taken as a model compound for the study. UV‐Vis spectral studies suggest no denaturation of LAC in presence of propylene carbonate. The SEM studies reveal the surface morphology and incorporation of LAC in P3MT with agglomerated flaky masses are observed in with and without enzyme micrographs. The cyclic voltammograms were recorded for 0.01 mM catechol on plain glassy carbon, polymer and enzyme incorporated electrodes at pH 6.0 and scan rate 50 mV s^?1. The fabricated electrochemical biosensor was used for the determination of catechol in aqueous solution by Differential Pulse Voltammetry (DPV) technique. The concentration linear range of 8×10^?8 to 1.4×10^?5 M a value of Michealis? Menten constant K_m=7.67 µmol dm^?3 and activation energy is 32.75 kJ mol^?1. It retains 83 % of the original activity after 60 days which is much higher than that of other biosensors. The developed biosensor was used to quantify catechol in the determination in real samples.     

Synthesis of size tunable monodispersed silver nanoparticles and the effect of size on SERS enhancement

Spherical and monodispersed silver nanoparticles (AgNPs) are ideal for fundamental research as the contribution from size and shape can be accounted for in the experimental design. In this paper a seeded growth method is presented, whereby varying the concentration of sodium borohydride-reduced silver nanoparticle seeds, different sizes of stable spherical nanoparticles with a low polydispersity nanoparticles are produced using hydroquinone as a selective reducing agent. The surface-enhanced Raman scattering (SERS) enhancement factor for each nanoparticle size produced (17, 26, 50, and 65 nm) was then assessed using three different analytes, rhodamine 6G (R6G), malachite green oxalate (MGO) and thiophenol (TP). The enhancement factor gives an indication of the Raman enhancement effect by the nanoparticle. Using non-aggregated conditions and two different laser excitation wavelength (633 nm and 785 nm) it is shown that an increase in particle size results in an increased enhancement for each analyte used.     

Green and mild laccase-catalyzed aerobic oxidative coupling of benzenediol derivatives with various sodium benzenesulfinates

The oxidative coupling reaction between hydroquinone or catechols and various sodium benzenesulfinates was investigated using the laccase from Trametes versicolor, in the presence of O₂ in a phosphate buffer solution at room temperature to afford sulfonyl benzenediols in 75–95% yield.