冲击伤复合高速破片致伤的损伤特点和冲击伤防护研究

探讨了冲击伤复合高速破片致伤的损伤特点及复合材料对冲击伤的防护效果。结果表明，肢体高速破片致伤对肺冲击伤具有加重作用，加重效应主要发生在原发冲击伤部位，加重效应的机理可能与压力波引起的血流扰动有关。利用复合材料防护可减轻肺冲击伤程度，降低动物的死亡率。     

Fluid-Damping Controlled Instability in Tube Bundles Subjected to Air Cross-Flow

There are different excitation mechanisms that cause fatal damages due to undesirable vibrations in heat exchanger tube bundles subjected to cross-flow. One of them is the fluid-damping-controlled instability (galloping) that is characterised by a sudden appearance of large amplitudes of the tubes exclusively in cross-flow direction. This paper reports on investigations using an experimental set-up in a wind tunnel where the galloping mechanism in a tube bundle can be observed as an isolated phenomenon. The apparatus allows to realise several tube bundle configurations and geometry's of real heat exchangers. The position of a flexible test tube with a linear iso-viscoelastic mounting inside the tube array is variable. The test tube is equipped with dynamical pressure sensors which are placed directly under pressure holes inside the tube. For the investigation of the acting fluid forces the non-stationary pressure distribution is measured simultaneously at 30 points on the circumference in mid plane and at 15 points in line along the tube together with the tube motion. The acting fluid forces are determined by integration of the whole pressure field process. The study gives insights into the effect of the fluid-damping-controlled instability that is still not fully understood. Moreover, a flow visualization gives an impression of the mechanism at relevant Reynolds-numbers. The results show that in case of instability due to galloping the correlation length of the forces acting along the tube axis increases suddenly to large values. The fluid forces are correlated well for the whole tube when galloping is dominant. The exciting fluid forces show harmonic character and lead to a classical resonance behaviour. Instead of a simple free vibration test in vacuum or still air, which is done mostly for fluid excited structures, the damping coefficient of the oscillating system is determined under operating conditions on the basis of the measured fluid forces. A comparison of the results with those of a free vibration test in still air is shown. This revised version was published online in July 2006 with corrections to the Cover Date.     

Second order effects in an elastic half-space acted upon by a non-uniform normal load

A closed form solution to the second order elasticity problem, when an isotropic compressible elastic half-space undergoes a deformation owing to a non-uniformly distributed normal load, is presented. The method of integral transform is employed and the case when loading is distributed, in accordance with Hertz's law, is discussed. The limiting solution for incompressible isotropic elastic material is also derived. Numerical calculations for the second order elastic material for the displacement and the normal stress in thez-direction are carried out. It is found that, in comparision to the linear elastic case, the displacement increases and the normal stress decreases in the second order elastic material

---

Sommario Si presenta una soluzione del secondo ordine in forma chiusa del problema di un semi-spazio elastico isotropo compressibile soggetto a un carico normale distribuito non uniformemente, ottenuta mediante il metodo delle trasformate integrali. Si discute il caso del carico distribuito secondo la legge di Hertz; si deriva anche la soluzione limite per materiale elastico isotropo incompressibile. Si ottengono numericamente alcuni risultati relativi a spostamenti e tensioni normali nella direzione z: si trova che, a paragone del caso elastico lineare, gli spostamenti aumentano e le tensioni diminuiscono nel materiale elastico del secondo ordine.

     

A phenomenological and extended continuum approach for modelling non-equilibrium flows

This paper presents a new technique that combines Grad’s 13-moment equations (G13) with a phenomenological approach to rarefied gas flows. This combination and the proposed solution technique capture some important non-equilibrium phenomena that appear in the early continuum-transition flow regime. In contrast to the fully coupled 13-moment equation set, a significant advantage of the present solution technique is that it does not require extra boundary conditions explicitly; Grad’s equations for viscous stress and heat flux are used as constitutive relations for the conservation equations instead of being solved as equations of transport. The relative computational cost of this novel technique is low in comparison to other methods, such as fully coupled solutions involving many moments or discrete methods. In this study, the proposed numerical procedure is tested on a planar Couette flow case, and the results are compared to predictions obtained from the direct simulation Monte Carlo method. This test case highlights the presence of normal viscous stresses and tangential heat fluxes that arise from non-equilibrium phenomena, which cannot be captured by the Navier–Stokes–Fourier constitutive equations or phenomenological modifications.      

Mechanics of rubber shear springs

FEA calculations have been carried out for a model rubber shear spring, consisting of a block of a highly elastic material, bonded between two rigid parallel plates and sheared by displacing one of the plates parallel to the other in its own plane. The block was prevented from deforming in the perpendicular direction, and thus was deformed in plane strain. Stress distributions along the bond-line and the center-line are reported and compared with those expected from the theory of large elastic deformations. Unexpected tensile stresses were found to develop in the interior of the sheared block. They are attributed to the absence on the end surfaces of the stresses needed to maintain a simple shear, causing a pronounced change in the reference pressure—a consequence that is usually overlooked. Because the internal stresses are governed by the boundary conditions, they were strongly affected by the shape of the end surfaces. In addition, they were reduced markedly by assigning values to Poisson's ratio slightly lower than 0.5, thus allowing some volume expansion of the rubber. Strain energy release rates were also evaluated for growth of a crack along the bond-line, starting at the edges, and compared with those reported previously by Lindley and Teo [Energy for crack growth at the bonds of rubber springs, Plast. Rubber Mat. Appl. 4 (1979) 29-37], Muhr et al. [A fracture mechanics study of natural rubber-to-metal bond failure, J. Adhes. Sci. Technol. 10 (1996) 593-616], Gregory and Muhr [Stiffness and fracture analysis of bonded rubber blocks in simple shear, in: D. Boast, V.A. Coveny (Eds.), Finite Element Analysis of Elastomers, Professional Engineering Publications, Bury St. Edmunds, UK, 1999, pp. 265-274] and Gough and Muhr [Initiation of failure of rubber close to bondlines, in: Proceedings of the International Rubber Conference, Maastricht, Netherlands, June 2005, IOM Communications Ltd., London, 2005, pp. 165-174]. They confirm that a long crack at the compression edge will grow faster than one at the tension edge, but the results for short cracks were inconclusive.     

聚氨酯在磨粒侵蚀条件下的表面化学效应

在工程实际中，由于高分材料的抗磨粒侵蚀性能都比较而得到了广泛的应用，然而载至目前，所见这类材料在磨粒侵蚀磨损机理方面的研究报道相当之少，而且仅局限于物理过程的考察。因此，对聚氨酯在磨粒侵蚀条件下的表面化学效应进行了试验研究。利用扫描电子显微镜、Ｘ射线光电子能谱仪和傅立叶表面红外分析仪，对这种高分子材料在磨粒侵蚀磨损前后表面的微观形貌、元素组成、结合能和官能闭进行了分析。     

Flow through isotropic granular porous media

A generalization of the Navier-Stokes equation is developed to include laminar flow through a rigid isotropic granular porous medium of spatially varying permeability. The model is based on a theory of interspersed continua and the mean geometrical properties of an idealized granular porous microstructure. The derived momentum transport equations are applicable to granular porous media over the entire porosity range from zero through unity. No restriction with respect to flow velocity is imposed, except for the assumption of laminar flow within the pores. The results provide useful and versatile equations and substantiate many of the empirical equations currently in use. One of the major advantages of the generalized momentum equation is its adaptability to numerical simulation.     

High Ethene/Ethane Selectivity in 2,2′‐Bipyridine‐Based Silver(I) Complexes by Removal of Coordinated Solvent

Following removal of coordinated CH₃CN, the resulting complexes [Ag^I(2,2′‐bipyridine)][BF₄] ( 1 ) and [Ag^I(6,6′‐dimethyl‐2,2′‐bipyridine)][OTf] ( 2 ) show ethene/ethane sorption selectivities of 390 and 340, respectively, and corresponding ethene sorption capacities of 2.38 and 2.18 mmol g^?1 when tested at an applied gas pressure of 90 kPa and a temperature of (20±1) °C. These ethene/ethane selectivities are 13 times higher than those reported for known solid sorbents for ethene/ethane separation. For 2 , ethene sorption reached 90 % of equilibrium capacity within 15 minutes, and this equilibrium capacity was maintained over the three sorption/desorption cycles tested. The rates of ethene sorption were also measured. To our knowledge, these are the first complexes, designed for olefin/paraffin separations, which have open silver(I) sites. The high selectivities arise from these open silver(I) sites and the relatively low molecular surface areas of the complexes.     

Far‐Red and Near‐IR AIE‐Active Fluorescent Organic Nanoprobes with Enhanced Tumor‐Targeting Efficacy: Shape‐Specific Effects

The rational design of high‐performance fluorescent materials for cancer targeting in vivo is still challenging. A unique molecular design strategy is presented that involves tailoring aggregation‐induced emission (AIE)‐active organic molecules to realize preferable far‐red and NIR fluorescence, well‐controlled morphology (from rod‐like to spherical), and also tumor‐targeted bioimaging. The shape‐tailored organic quinoline–malononitrile (QM) nanoprobes are biocompatible and highly desirable for cell‐tracking applications. Impressively, the spherical shape of QM‐5 nanoaggregates exhibits excellent tumor‐targeted bioimaging performance after intravenously injection into mice, but not the rod‐like aggregates of QM‐2.