A Comparative Study of Various Pretreatment Approaches for Bio-Ethanol Production from Willow Sawdust,Using Co-Cultures and Mono-Cultures of Different Yeast Strains

The effect of different pretreatment approaches based on alkali (NaOH)/hydrogen peroxide (H₂O₂) on willow sawdust (WS) biomass, in terms of delignification efficiency, structural changes of lignocellulose and subsequent fermentation toward ethanol, was investigated. Bioethanol production was carried out using the conventional yeast Saccharomyces cerevisiae, as well as three non-conventional yeasts strains, i.e., Pichia stipitis, Pachysolen tannophilus, Wickerhamomyces anomalus X19, separately and in co-cultures. The experimental results showed that a two-stage pretreatment approach (NaOH (0.5% w/v) for 24 h and H₂O₂ (0.5% v/v) for 24 h) led to higher delignification (38.3 ± 0.1%) and saccharification efficiency (31.7 ± 0.3%) and higher ethanol concentration and yield. Monocultures of S. cerevisiae or W. anomalus X19 and co-cultures with P. stipitis exhibited ethanol yields in the range of 11.67 ± 0.21 to 13.81 ± 0.20 g/100 g total solids (TS). When WS was subjected to H₂O₂ (0.5% v/v) alone for 24 h, the lowest ethanol yields were observed for all yeast strains, due to the minor impact of this treatment on the main chemical and structural WS characteristics. In order to decide which is the best pretreatment approach, a detailed techno-economical assessment is needed, which will take into account the ethanol yields and the minimum processing cost.     

Supramolecular systems based on poly(ethyleneimines) and calix[4]resorcinarenes with alkylphosphonate fragments. Aggregation and catalytic activity

Aggregation in poly(ethylenimine)-calix[4]resorcinarene-water-DMF systems was studied by the methods of conductometry and dynamic light scattering. The sizes (radii) of the aggregates formed and the critical micelle concentrations were determined. The catalytic activity for these systems in the hydrolisys of phosphorus acid esters was shown. Published in Russian in Izvestiya Akademii Nauk. Seriya Khimicheskaya, No. 5, pp. 924–931, May, 2007.     

Cr3+的水解聚合作用的研究 Ⅺ.在顺丁烯二酸存在下的水解和聚合

在60℃和恒定离子强度下,用平衡法研究了0.004mol dm^-3Cr(NO₃)₃在三种不同浓度顺丁烯二酸H₂A(0.008,0.010,0.014mol dm^-3的水溶液中的状态,用计算机拟合和p.q.r分析方法得到了[Cr(OH)A₂]^2-,[Cr₂(OH)A₂]⁺[Cr₃(OH)₂A₂]⁺和CrA₃^3-四种水解产物,并计算了其平衡常数,在我们系列工作中研究了在宽广的Cr³⁺和顺丁烯二酸浓度下Cr³⁺的状态,共生成11种配合物,本文对其形成规律进行了讨论.     

纸张保存的化学

讨论了纸张保存过程中的某些化学问题,对纸张的酸性、酸性来源和纤维系酸催化水解以及影响纸张变质的其它因素进行了分析,评述了近年来在纸张脱酸、脱色和利用新的浆内施胶剂等方面研究取得的一些成果。     

水洗和回烧工艺对高镍三元材料LiNi0.88Co0.07Al0.05O2微观结构及电化学性能的影响

以镍钴氢氧化物、异丙醇铝为原料,采用水解法合成三元前驱体Ni_(0.88)Co_(0.07)Al_(0.05)O_2,再与锂盐混合烧结得到正极材料(TEM)、X射线光电子能谱(XPS)、能量色散X射线谱(EDS)和恒电流充放电测试等对样品的晶体结构、微观形貌、元素价态以及电化学性能进行表征。研究表明,料液比1∶25、水洗3次、600℃回烧2 h合成的LiNi_(0.88)Co_(0.07)Al_(0.05)O_2具有较优的综合电化学性能,其在0.2C的放电比容量达207.6 mAh·g~(-1),首次充放电效率为84.8%,1C放电比容量为192.0 mAh·g~(-1),循环100周后,材料的放电比容量仍有148.0 mAh·g~(-1),容量保持率达到77.1%。     

氨基的脱保护——乙酰苯胺水解实验教学设计*

通过开放性设计实验完成氨基脱保护实验的教学。指导学生以回收的乙酰苯胺为原料,自主设计乙酰苯胺在酸、碱条件下水解正交实验方案并分组独立操作,制备并提纯苯胺,比较不同条件下的苯胺收率,筛选出乙酰苯胺最佳的水解条件。对所选实验班级近3年的实验结果进行统计和分析,并通过验证实验考察了结果的可重复性。     

Aniline-terephthalaldehyde resin p-toluenesulfonate (ATRT) as a highly efficient and reusable catalyst for alcoholysis,hydrolysis, and acetolysis of epoxides

Alcoholysis, hydrolysis, and acetolysis of epoxides were carried out in the presence of a catalytic amount of aniline-terephthalaldehyde resin p-toluenesulfonate (ATRT) to give the corresponding β-substituted alcohols in good yields. Alcoholysis and hydrolysis of epoxides catalyzed by ATRT proceeded faster than those by pyridinium p-toluenesulfonate (PPTS).     

酸水解-离子色谱法测定精四氯化钛中三氯乙酰氯

建立了酸水解-离子色谱法测定精四氯化钛中痕量三氯乙酰氯(CCl3COCl)的方法.四氯化钛样品与2 mol/L HCl按体积比1∶4水解平衡后,采用氢氧化物共沉淀法去除溶液中Ti4+,V5+和Fe3+等金属离子,用Ag2O沉淀法降低水解溶液中Cl-浓度,水解溶液通过H型阳离子交换柱和水系滤膜,离子色谱法测定溶液中三氯乙酸(TCAA),据TCAA与CCl3COCl摩尔量守恒计算样品中CCl3COCl含量.结果表明,共沉淀溶液pH值在9.0～10.0范围内,可将目标金属离子基本去除完全;加入Ag2O降低溶液Cl-浓度后,溶液中Cl-,NO3-和SO42-的浓度对水解溶液中TCAA的色谱法峰无影响.本方法对精四氯化钛样品中CCl3COCl的定量限为1.20 μg/g,低于俄罗斯精四氯化钛中CCl3COCl允许限值(5μg/g);方法加标回收率在84.1％ ～87.3％之间,共沉淀时溶液pH值的轻微变化对回收率无明显影响,分析结果稳定可靠;方法用于5个平行样品中CCl3COCl含量测定(45.6,37.9,40.8,38.9和43.5 μg/g),相对标准偏差7.7％,方法精密度较好.方法满足精四氯化钛中CCl3COCl质量控制要求.     

人工神经网络用于锕系离子An3+水解常数pK1预测研究

０引言水解常数是金属离子水溶液化学的基础数据，对于研究水溶液中离子的状态以及进一步研究其在水溶液中的其它化学行为是必不可少的。一般金属离子（包括镧系金属离子）的水解常数数据相对较为完善，对它们水解的规律性也有不少研究，但锕系金属离子的水解常数数据迄今较缺乏，特别是重锕系的水解常数数据基本空缺犤１～５犦。这主要是因为锕系多为放射性元素，重锕系则基本是人工元素，被发现或合成较晚，即使通过核反应合成，量也往往极少（常以多少个原子个数计算），且半衰期大多很短，因而从获取样品到进行有关化学研究都相当困难。…