Temperature effects on surface activity and application in oxidation of toluene derivatives of CTAB-SDS with KMnO4

The γ_cmc values of CTAB-SDS decrease from 63.67 mN/m at 10‡C to 36.38 mN/m at 90‡C, slightly lower than those of either CTAB or SDS. Correspondingly, the CMC of CTAB-SDS decreases almost by half. The increase of surface activity of CTAB-SDS can be attributed to the relatively weak electrostatic interaction at high temperature, which is supported by the increase of solubility of CTAB-SDS with rise in temperature. Catalytic effect on oxidation of toluene derivatives with potassium permanganate follows the order CTAB-SDS > SDS > CTAB. This is not caused by the dissociative effect of CTAB-SDS with low surface activity at low temperature, as seen from the fact that almost all oxidative products can be retrieved for different toluene derivatives and surfactants by mimicking the conditions of reaction. In the emulsifications of toluene derivatives at 90‡C, the time that turbid water layers of surfactant solutions take to become clear is the same as that of the catalytic effect on oxidation of toluene derivatives. Thus, it can be inferred that surfactants can improve the oxidation yields of toluene derivatives by increasing the contact between two reacting phases.     

烟气中Hg的氧化机理的研究

本文对Ｈｇ与Ｃｌ２在烟气中的氧化反应进行了热力平衡计算和动力学计算。平衡计算的结果表明有ＣＩ元索存在时Ｈｇ的氧化率为１００％，而在相同的条件下动力学计算纺果为Ｈｇ的氧化率在２０％～８０％之间变化，与实验结果吻合。实际的氧化反应是一种超平衡状态，不能达到理想的平衡状态。因此应采用动力学与热力平衡分析相结合的方法研究Ｈｇ在烟气中的反应机理。同时，计算结果显示Ｃｌ含量对Ｈｇ的氧化率的影响很大．     

Al-pillared clays supported rare earths and palladium catalysts for deep oxidation of low concentration of benzene

Al-pillared clays supported rare earths (RE/Al-PILC) are prepared and used as supports of palladium catalysts for deep oxidation of low concentrations of benzene (130-160 ppm). The supports and catalysts are characterized by X-ray powder diffraction (XRD), FT-IR, BET, transmission electron microscopy (TEM) and temperature-programmed reduction (H₂-TPR). The results show that Al-pillaring results in a strong increase in the basal spacing (d_0 0 1) from about 1.2 to 1.8 nm, and an increase in the BET surface area from 63.6 (±3.2) to 238.8 (±11.9) m²/g. Activity tests of deep oxidation of low concentration benzene show catalysts supported on Al-PILC and RE/Al-PILC are obviously more active than that on raw clay. Pd/6% Ce/Al-PILC, in particular, can catalyze the complete oxidation of low concentration benzene at a temperature as low as about 290 °C.     

General strategy for a short and efficient synthesis of 3-hydroxy-4-methylprolines (HMP)

The non-proteinogenic amino acid 3-hydroxy-4-methylproline (HMP) is an active constituent of some potent antimicrobials including echinocandins, nostopeptins, pneumocandins, sporiofungin and mulundocandins. A synthesis has been achieved in 10 steps with 29% overall yield; the Evans’ aldol reaction using Crimmins’ modified method was pivotal to the success of the strategy.     

Asymmetric synthesis of homo-apioneplanocin A from d-ribose

Homo-apioneplanocin A was efficiently synthesized via stereoselective hydroxymethylation, regio- and chemoselective hydroboration, and chemoselective oxidation as key steps from d-ribose.     

Comparison of growth stress measurements with modelling in thin iron oxide films

High temperature oxidation of metals leads to residual stresses both in the metal and in the growing oxide. In this work, the evolution of this residual stresses is theoretically predicted in the growing oxide layers. The origin of these stresses is based on a microstructural model. Using experimental results providing from the oxidation kinetics, and an analysis proposed to describe the growth strain occurring in the thin layers, a set of equations is established allowing determining the stresses evolution with oxidation time. Then, the model is compared with experimental results obtained on both α-Fe and phosphated α-Fe, oxidised at different temperatures. Numerical data are extracted from experiments either with an asymptotic formulation or with an inverse method. These two methods give good agreement with experiments and allow extracting the model parameters.     

纳米TiO_2用于甲基橙溶液的光催化氧化研究

本实验采用纳米级的二氧化钛,对甲基橙溶液进行了紫外光催化氧化处理,探讨了pH的影响和添加Fe3+的效果及反应动力学方程,结果表明,采用UV/O3/TiO2工艺对其进行处理,pH4-5时,10W紫外灯光照60min,CODcr去除率达84%,脱色率达96%以上。添加Fe3+,对溶液的催化降解速度提高不明显。动力学研究表明,CODcr降解速度对CODcr的浓度为一级反应。     

Indirect Oxidation of Organic Substances by Intermediates of the Oxygen Reduction

Results of two urgent and practically important directions of research on the indirect oxidation of organic compounds by highly reactive intermediates generated electrochemically from oxygen (HO₂ ^–, HO₂ ^·, HO^·) are considered and orderly arranged. The studies in question are the indirect synthesis and mineralization of organic toxicants in waste water.     

Mathematical modelling of the oxidation of nickel titanium alloys

A one-dimensional bulk reaction model for the oxidation of nickeltitanium is formulated, with preferential oxidation of titaniumbeing included. The modelling is directed at the better understandingof the dominant mechanisms involved in the oxidation processand their significance for the biocompatibility of the alloy.Two different regimes for the relative diffusivities of oxygenand the metals are investigated. By assuming fast bulk reactions,different asymptotic structures emerge in different parameterregimes and the resulting models take the form of moving boundaryproblems. Different profiles of nickel concentration are obtained:in particular a nickel-rich layer (observed in practice) ispresent below the oxide/metal interface for the case when oxygenand the metals diffuse at comparable rates.