甲烷氧化偶联Na2WO4-Mn/SiO2催化剂热效应的研究

采用固定床微型反应装置,研究了甲烷氧化偶联反应过程中Na2WO4-Mn/S iO2催化剂床层的热效应和催化性能的关系,考察了反应炉温、CH4/O2比和反应气体空速对催化剂床层热点分布的影响.研究结果表明,甲烷氧化偶联催化剂床层的热效应强烈依赖于反应条件.反应炉温越高,CH4/O2比越低,反应气体空速越大,催化剂床层的热点温度越高.结合催化性能和热效应关系的研究,为优化甲烷氧化偶联的反应操作提供了实验依据.     

Synthesis and electrochemical properties of spinel LiMn2O4 prepared by the rheological phase method

Pure-phase and well-crystallized spinel LiMn₂O₄ powders were successfully synthesized by a simple rheological phase method. The thermal behavior and structure properties of the powders prepared by the rheological phase method compared with the solid-state reaction were investigated by thermogravimetry, powder X-ray diffraction , scanning electron microscopy and transmission electron microscopy. According to the results of the electrochemical tests, it is obvious that the sample resulting from the rheological phase method shows higher discharge capacity and better cycling stability than one formed in the solid-state reaction. The cyclic voltammogram and columbic efficiency curves also confirm that the product by the rheological phase method has a good cycling performance due to its fine cubic spinel structure and morphology.     

Crystal structure of cobalt molybdate hydrate CoMoO4·nH2O

We have determined the crystal structure of the title compound, which has a triclinic cell with cell parameters of , , , α=76.617°, β=84.188°, γ=74.510° and space group . The crystal structure suggests the chemical formula CoMoO₄·3/4H₂O. The structure consists of MoO₄ tetrahedra and CoO₆ octahedra, confirming the earlier X-ray absorption near-edge spectroscopic (XANES) investigation on the hydrate. The comparison of the crystal structures of the hydrate and the α-,β-, and hp-phases shows that the hydrate exhibits metal cation coordinations similar to those of the β-phase, but had arrangements of CoO₆ and MoO_n polyhedra similar to those of the hp-phase.     

Electroreductive polymerization of trans-[RuCl 2(vpy) 4] on Nd-Fe-B magnets: electrochemical impedance spectroscopy interpretation, Raman spectroscopy, X-ray photoelectron spectroscopy and scanning electron microscopy analysis

The electropolymerization of trans-[RuCl₂(vpy)₄] (vpy=4-vinylpyridine) monomer on Nd-Fe-B magnets was studied by electrochemical impedance spectroscopy (EIS). Impedance diagrams obtained during the polymerization process were used to monitor film formation. The EIS results gave insight into the electrochemical phenomena occurring at the magnet surface as the polymerization process progressed. The film structure and morphology were also studied by X-ray photoelectron spectroscopy, scanning electron microscopy and Raman spectroscopy. The Raman spectroscopy results showed that the polymerization takes place at the vinyl groups of the monomer and also that the redox polymer structure is very similar to that of the monomer. The ratio of the intensity of the XPS peaks for fluorine (from the electrolyte PF₆ ^–) and ruthenium present in the film showed that the polymer on Nd-Fe-B contained an equal proportion of Ru²⁺ and Ru³⁺, indicating that part of the film is positively charged, i.e. {[RuCl₂(vpy)₄]⁺} _n .     

植入用Co—Cr—Mo合金与Ti—6Al—4V合金的电偶腐蚀研究

组件式设计常被用地人工髋关节，钴络钼合金（Ｃｏ－Ｃｒ－Ｍｏ）与钛合金（Ｔｉ－６Ａｌ－４Ｖ）的压配最常用，本文应用电化学方法研究了静态条件下两种合金的电偶腐蚀行为，浸泡实验表明，钴络钼合金为阳极，但电偶电流与其维钝电流相近，并无明显加速度腐蚀效应，钛合金为阴极，受到保护，失重及金相观察结果显示，在４５天的浸泡实验周期内，未发现腐蚀痕迹，混合电位理论和电位处于两种合金的钝化电位区，电偶电流为合金的维钝     

DFT investigation of sites of protonation of antitumor of 2‐(4‐aminophenyl)benzazoles in the gas phase and in solution

The proton affinity on each of the possible sites in the antitumor 2‐(4‐aminophenyl)benzazoles has been calculated at the B3LYP/6‐311G** level of theory in the gas phase and in solution. The N₃‐site of protonation is found to be strongly favored over the NH₂‐site for the studied compounds both in gas phase and in solution. The stability of N₃‐protonated species is explained by the resonance interaction of the NH₂‐group with the heterocyclic ring. The potential energy surface (PES) for the protonation process was studied at the density functional theory (DFT)/B3LYP/6‐311++G** level of theory. Solvent effects on the PES were also examined using two models: Onsager self‐consistent field and polarizable continuum model (PCM). © 2005 Wiley Periodicals, Inc. Int J Quantum Chem, 2005     

EFFECT OF La_2O_3 AND CeO_2 ON CH_4-CO_2 REFORMING NICKEL CATALYST

IntroductionConsiderableattelltionisno\vbeillgpaidtotheCO7refonningof.etha..llto]forseveralreasonst(l)withthedevelopmentofindustrics.moreandnlorcCOZIsabettedintotheatmosphere,leadingto"greenhouseeffect",whichhasbroughtaboutgreatilltcreslallovertheworld.Th…     

Phenol methylation over CrPO4 and CrPO4?AlPO4 catalysts

The vapor-phase catalytic alkylation of phenol with methanol and dimethyl carbonate on a series of differently prepared CrPO₄ (Cr/P=1) and CrPO₄-AlPO₄ (CrAIP) catalysts, has been studied at different temperatures (473–673 K). The reaction is first order in phenol, giving a mixture of O- and C-alkylated products (C-alkylation taking place preferentially at theortho-position). Moreover, dimethyl carbonate is a better methylating agent than methanol.     

过渡金属大环配合物的研究Ⅲ 4-硝基-苯并15冠-5与钴(Ⅱ)、铜(Ⅱ)和银(Ⅰ)配合物的合成及性质

有关冠醚配体与碱金属,碱土金属和稀土离子形成配合物的特性研究,国内外均有报导,但冠醚与d-过渡金属离子配合物的研究工作,则开展较晚,文献报导亦甚少。本文为探讨4-硝基-苯并15冠-5(No_2·B15C15)与过渡金属离子的配位能力,合成了Co(Ⅱ),Cu(Ⅱ),和Ag(Ⅰ)与4-硝基-苯并15冠-5配合物。并进行了元素分析,X-射线衍射,红外光谱,摩尔电导,激光拉曼光谱及差热-热失重分析的研究。     

Monolayers of hydrogen-bonded polymer blends at the air–water interface: poly(vinylacetate)+poly (4-hydroxystyrene)

 The surface pressure (Π) vs surface concentration (Γ_s) curves of the hydrogen-bonded polymer blend poly(vinylacetate)+ poly(4-hydro-xystyrene) (PVAc+P4HS) have been measured at 25 °C onto a water subphase at pH=2.0. While PVAc forms extended monolayers, and the free surface of water is found to be a good solvent for it, P4HS forms compressed monolayers, and the surface is a near Θ-type solvent for it. PVAc and P4HS form miscible non-ideal monolayers until near the collapse pressure through the whole concentration range. The composition dependence of the Π–Γ_s curves is rather complex. Contrary to what might be expected, the addition of PVAc to the blend does not reduce the rigidity of the monolayer until its weight fraction is larger than 0.5. The compressibility data of the P4HS-rich monolayers suggest the existence of a second maximum at high surface coverages, a result already observed in some polysiloxanes. Received: 11 March 1998 Accepted: 7 May 1998