Coupled structural and magnetic properties of ferric fluoride nanostructures: Part II,a Monte Carlo–Heisenberg study

We present a numerical study of the magnetic structure of nanostructured iron fluoride, using the Monte Carlo Metropolis simulated annealing technique and a classical Heisenberg Hamiltonian with superexchange angle dependent interactions. The parameters are adjusted on experimental results, and the atomic structure and topology taken from a previous atomistic model of grain boundaries in the same system. We find perfect antiferromagnetic crystalline grains and a disordered magnetic configuration (speromagnetic) at the grain boundary, in agreement with experimental features. Both the lowest magnetic energy and the rate of magnetic frustration are found to be dependent on the relative disorientation of crystalline grains, i.e. on the cationic topology. We conclude on possible extensions of the model.     

Pressure‐assisted CEC versus CEC using methacrylate‐based monolithic columns: Influence of the polymerization‐mixture composition

Pressure‐assisted CEC (pCEC) can either be performed on a CE instrument by adding pressure at the column inlet, or by applying voltage on a capillary liquid chromatography system. This study investigates the pressure's added value in pCEC using an LC instrument as well as the influence of the polymerization‐mixture composition on monolithic columns in such experimental circumstances. Two factors of the polymerization mixture, which is used to prepare the monolithic capillary columns, were varied according to an experimental design approach: the pore‐forming solvent/total monomer ratio and the pore‐forming solvents composition. Initially, the effect of the resulting stationary phase on the elution behavior of mainly pharmaceutical compounds was studied. Four responses were used to evaluate the effects on the chromatography: retention time, retention factor, peak asymmetry and number of theoretical plates. After processing the results, the stationary phase composition with the best chromatographic behavior was determined and tested. The advantageous properties of this stationary phase compared with the design center‐point column were demonstrated. Secondly, the results of these pCEC experiments were compared with those generated in an identical experimental setup previously performed using CEC. Chromatographic conditions were chosen so that the center‐point column showed similar retention in CEC and pCEC. The expected advantage (faster analysis) and drawback (decreased efficiency) of pCEC in the analysis of pharmaceuticals was evaluated. Analysis time and efficiency were both found to depend greatly on the porosity of the column. The conclusion of this comparison is that pCEC did not have a significant added value to CEC. However, this was mainly due to the instrument's limitation of the pressure‐driven flow over the column. A clear benefit of the pCEC setup was apparatus‐related, i.e. the presence of a loop injection system on the pCEC instrument, which avoids the injection problems that were occasionally observed in CEC.     

Microfluidics in macro-biomolecules analysis: macro inside in a nano world

Use of microfluidic devices in the life sciences and medicine has created the possibility of performing investigations at the molecular level. Moreover, microfluidic devices are also part of the technological framework that has enabled a new type of scientific information to be revealed, i.e. that based on intensive screening of complete sets of gene and protein sequences. A deeper bioanalytical perspective may provide quantitative and qualitative tools, enabling study of various diseases and, eventually, may offer support for the development of accurate and reliable methods for clinical assessment. This would open the way to molecule-based diagnostics, i.e. establish accurate diagnosis and disease prognosis based on identification and/or quantification of biomacromolecules, for example proteins or nucleic acids. Finally, the development of disposable and portable devices for molecule-based diagnosis would provide the perfect translation of the science behind life-science research into practical applications dedicated to patients and health practitioners. This review provides an analytical perspective of the impact of microfluidics on the detection and characterization of bio-macromolecules involved in pathological processes. The main features of molecule-based diagnostics and the specific requirements for the diagnostic devices are discussed. Further, the techniques currently used for testing bio-macromolecules for potential diagnostic purposes are identified, emphasizing the newest developments. Subsequently, the challenges of this type of application and the status of commercially available devices are highlighted, and future trends are noted.     

MRS study of the effects of minocycline on markers of neuronal and microglial integrity in ALS

Objective

Magnetic resonance spectroscopy (MRS) allows to monitor brain metabolites noninvasively in amyotrophic lateral sclerosis (ALS). The objective of this study was to use MRS to monitor the effect of minocycline treatment (200 mg/day) over a short period (6 weeks) on the brain metabolites in the precentral gyrus and brainstem in newly diagnosed ALS patients.

Methods

Ten ALS patients (not on riluzole treatment) were recruited and submitted to single-voxel proton MRS longitudinal examinations (1) before minocycline treatment, (2) 3 weeks and (3) 6 weeks after initiation of treatment.

Results

Results did not show the expected decrease of N-acetylaspartate/creatine (NAA/Cr) in the precentral gyrus, and an increased NAA/Cr ratio in the brainstem suggested neuronal recovery. The myo-inositol (mI)/Cr ratio was unchanged in the precentral gyrus, but increased in the brainstem, indicating a glial reaction.

Conclusions

MRS results suggest that minocycline treatment could be beneficial in the early stages of ALS.     

Influence of the spatial position of a trifluoromethyl group on the 13C chemical shifts in the cyclohexane series

The influence of the introduction of a trifluoromethyl group on the 13C chemical shifts in cyclohexane was examined. The two main effects observed are located at the alpha and gamma positions relative to the carbon bearing the fluorine atoms. By comparison of the collected data it was possible to calculate the increments corresponding to the substitution of a hydrogen atom by a CF3 group at axial or equatorial positions on the cyclohexane ring.     

Future of high pressure liquid chromatography: do we need porosity or do we need pressure?

Making a theoretical study supported by experiments of the kinetic advantages of increased inlet pressures versus increased external porosity using impedance plots of analysis time versus required plate number, it is found that both approaches more or less have the same effect on the kinetic performance. The need to change a given system to one with an increased inlet pressure or with an increased external porosity can best be assessed from the optimal plate number (N(opt)) of the system. When the pursued application requires a plate number that is larger than N(opt), any increase in inlet pressure and external porosity is beneficial. When the required plate number is smaller than N(opt), any increase in inlet pressure and external porosity should preferentially be accompanied by an overall reduction of the feature sizes of the support. The degree to which this feature size reduction can be realized in practice will to a large extent determine which of the two approaches will be the dominant system of the future.     

Size and charge effects on the binding of CO to late transition metal clusters

We report on the size and charge dependence of the C-O stretching frequency, nu(CO), in complexes of CO with gas phase anionic, neutral, and cationic cobalt clusters (Co(n)CO(-0+)), anionic, neutral, and cationic rhodium clusters (Rh(n)CO(-0+)), and cationic nickel clusters (Ni(n)CO(+)) for n up to 37. We develop models, based on the established vibrational spectroscopy of organometallic carbonyl compounds, to understand how cluster size and charge relate to nu(CO) in these complexes. The dominating factor is the available electron density for backdonation from the metal to the CO pi* orbital. Electrostatic effects play a significant but minor role. For the charged clusters, the size trends are related to the dilution of the charge density at the binding site on the cluster as n increases. At large n, nu(CO) approaches asymptotes that are not the same as found for nu(CO) on the single crystal metal surfaces, reflecting differences between binding sites on medium sized clusters and the more highly coordinated metal surface sites.     

Molecular rotors: design, synthesis, structural analysis, and silver complex of new [7.7]cyclophanes

New molecular rotors, [7.7](2,6)pyridinocyclophanes (monomers and dimers) embedding 1,3-dioxanes in the bridges, were investigated by variable-temperature NMR, molecular modeling, and single-crystal X-ray diffractometry. The nitrogen-inside rotation of the pyridine ring is more hindered in the derivatives with longer distance between the bridges (i.e., para > meta and 2,6-pyridylene > ortho) and can be chemically stopped by complexation with CF(3)SO(3)Ag. [structure: see text]     

Quantized vortices in the ideal bose gas: a physical realization of random polynomials

We propose a physical system allowing one to experimentally observe the distribution of the complex zeros of a random polynomial. We consider a degenerate, rotating, quasi-ideal atomic Bose gas prepared in the lowest Landau level. Thermal fluctuations provide the randomness of the bosonic field and of the locations of the vortex cores. These vortices can be mapped to zeros of random polynomials, and observed in the density profile of the gas.