Correlation between oxygen consumption and photobleaching during in vitro photodynamic treatment with ATX-S10.Na(II) using pulsed light excitation: dependence of pulse repetition rate and irradiation time

We revealed that in ATX-S10.Na(II)(13,17-bis (1-carboxypropionyl) carbamoylethyl-8-etheny-2-hydroxy-3-hydroxyiminoethylidene-2,7,12,18-tetraethyl porphyrin sodium)-mediated photodynamic therapy using 667 nm nanosecond-pulsed light excitation at a peak intensity of 2.0 MW/cm(2), phototoxicity increased with decreasing pulse repetition rate in the range of 5-30 Hz for A549 cell cultures. To examine the relation between the reaction mechanism and measured phototoxicity, we carefully measured the kinetics of photochemical oxygen consumption and photobleaching during irradiation of ATX-S10.Na(II)-sensitized A549 monolayer cultures. Measurements of oxygen consumption with a microelectrode, which was performed just above the cells, showed that there was no significant difference between the magnitudes of decrease in oxygen at the three repetition rates at the same cumulative fluence. Loss of ATX-S10.Na(II) fluorescence intensity also exhibited little repetition rate dependence when compared at the same cumulative fluence. We investigated the correlation between oxygen consumption and photobleaching during irradiation and obtained "fluorescence-oxygen diagrams." The diagrams showed dynamic changes between oxygen-dependent and oxygen-independent photobleaching at the higher repetition rates of 10 and 30 Hz, whereas such change was not clearly seen over the whole irradiation time at 5 Hz. These results suggest that the reduced phototoxicity at high repetition rates might be due to an oxygen-independent reaction. We presumed that the change in the reaction mechanism was associated with the local concentrations of the photosensitizer and oxygen in cells during irradiation.     

Thallium-201 chloride dynamic analysis using thallium-201 chloride and sodium iodide-131 thyroid subtraction scintigraphy

The mechanism of 201Tl chloride accumulation is unclear in thyroid gland and thyroid tumor. This report examines 108 patients that received thyroid scintigraphy examinations with both 201Tl chloride and sodium 131I. The patients were diagnosed clinically and histologically whenever possible. The ROI were obtained by subtraction imaging with both isotopes and by subtraction positive and negative areas of imaging. Dynamic curves were obtained for 201Tl chloride per square unit of each ROI. The dynamic curve in the radioiodide-accumulated area was examined. The data indicate that the clearance rate of 201Tl chloride (T15) was correlated with the sodium 131I uptake rate at 24 h (r = 0.70).     

Light-driven molecular hinge: a new molecular machine showing a light-intensity-dependent photoresponse that utilizes the trans-cis isomerization of azobenzene

[reaction: see text] A new class of molecular machine exhibits a hingelike motion upon photoirradiation. The motion (close and open) can be operated by alternate irradiation with UV and visible light. The trans/trans and cis/cis isomers are thermally stable at 40 degrees C, and the photochemical closure reaction (from trans/trans to cis/cis isomer) is dependent on the intensity of the light used because of the short-lived intermediate (trans/cis isomer).     

Selectivity of stationary phases in reversed-phase liquid chromatography based on the dispersion interactions

Selectivity of 15 stationary phases was examined, either commercially available or synthesized in-house. The highest selectivity factors were observed for solute molecules having different polarizability on the 3-(pentabromobenzyloxy)propyl phase (PBB), followed by the 2-(1-pyrenyl)ethyl phase (PYE). Selectivity of fluoroalkane 4,4-di(trifluoromethyl)-5,5,6,6,7,7,7-heptafluoroheptyl (F13C9) phase is lowest among all phases for all compounds except for fluorinated ones. Aliphatic octyl (C8) and octadecyl (C18) phases demonstrated considerable selectivity, especially for alkyl compounds. While PBB showed much greater preference for compounds with high polarizability containing heavy atoms than C18 phase, F13C9 phase showed the exactly opposite tendency. These three stationary phases can offer widely different selectivity that can be utilized when one stationary phase fails to provide separation for certain mixtures. The retention and selectivity of solutes in reversed-phase liquid chromatography is related to the mobile phase and the stationary phase effects. The mobile phase effect, related to the hydrophobic cavity formation around non-polar solutes, is assumed to have a dominant effect on retention upon aliphatic stationary phases such as C8, C18. In a common mobile phase significant stationary phase effect can be attributed to dispersion interaction. Highly dispersive stationary phases such as PBB and PYE retain solutes to a significant extent by (attractive) dispersion interaction with the stationary phase ligands, especially for highly dispersive solutes containing aromatic functionality and/or heavy atoms. The contribution of dispersion interaction is shown to be much less on C18 or C8 phases and was even disadvantageous on F13C9 phase. Structural properties of stationary phases are analyzed and confirmed by means of quantitative structure-chromatographic retention (QSRR) study.     

Effect of amount of monomer on radiation-induced polymerization of styrene adsorbed on silica gel

The effect of amount of monomer on radiation-induced polymerization of styrene adsorbed on silica gel was investigated with the monomer amounting from less than monolayer adsorption to more than the equilibrium adsorption. The rate of graft polymerization and the molecular weight of the polymer changed with the amount of monomer adsorbed on silica gel. Maximum grafting efficiency was obtained at monolayer adsorption. The molecular weight of graft polymer was higher than that of homopolymer in both radical and cationic polymerizations, and the ratio in molecular weight of graft polymer to that of homopolymer tends to be unity with increasing amount of adsorbed monomer. These results can mainly be explained in terms of the number of initiating species (radical and cation) that change in relation to the amount of adsorbed monomer. Propagation and termination change with amount of adsorbed monomer in relation to the molecular mobility of adsorbed monomer. A very high-molecular-weight graft polymer is formed only with a small amount of adsorbed monomer in the initial stage. The grafting percent with a large amount of adsorbed monomer increased after most of the monomer has been polymerized. Secondary effect of radiation on the graft and homopolymers due to energy transfer from silica gel is suggested from the complicated phenomena in the later stage of the reaction.     

Energy Dissipation Processes of singlet‐excited 1‐Hydroxyfluorenone and its Hydrogen‐bonded Complex with N‐methylimidazole¶

Effects of solvent, pH and hydrogen bonding with N‐methylimidazole (MIm) on the photophysical properties of 1‐hydroxyfluorenone (1HOF) have been studied. Fluorescence lifetime, fluorescence quantum yield and triplet yield measurements demonstrated that intersystem crossing was the dominant process in apolar media and its rate constant significantly diminished with increasing solvent polarity. The acceleration of internal conversion in alcohols paralleled the strength of intermolecular hydrogen bonding. The faster energy dissipation from the singlet‐excited state in cyclohexane was attributed to intramolecular hydrogen bonding. The pK_a of 1HOF decreased from 10.06 to 5.0 on light absorption, and H₃O⁺ quenched the singletexcited molecules in a practically diffusion‐controlled reaction. On addition of MIm in toluene, dual fluorescence was observed, which was attributed to reversible formation of excited hydrogen‐bonded ion pair. Rate constants for the various deactivation pathways were derived from the combined analysis of the steady‐state and the time‐resolved fluorescence results.     

On the absolute Riesz summability of orthogonal series

- , [4]. , .     

Preconcentration of silver(I), gold(III) and palladium(II) in sea water with p-dimethylaminobenzylidenerhodanine supported on silica gel

A water-insoluble chelating material, p-dimethylaminobenzylidenerhodanine on silica gel (DMABR—SG) is described for preconcentration of trace amounts of silver(I), gold(III) and palladium(II) from water samples. Radioactive tracers (^110mAg and ¹⁹⁵Au) were used to study the behavior of silver and gold; palladium was monitored spectrophotometrically as its 1-(2-pyridylazo)naphthol complex in chloroform. In batch experiments, silver was quantitatively retained on the DMABR—SG at acidities ranging from 1.7 M to pH 5, and gold from 3 M to pH 5; equilibrium was achieved within 1 min for both elements. From sea water, silver ion was completely retained at pH 1.0–6.5 and gold ion at pH 1.0–3.5. In the case of palladium, shaking for about 20 min was required for quantitative retention at pH 1.0–5.0 for aqueous solution and at pH 1.0–7.0 for sea water. The chelating capacity of the DMABR—SG was 23 μmol Ag, 11 μmol Au and 11 μmol Pd per g. Quantitative recovery of silver and gold on DMABR—SG columns from sea water was achieved at higher flow rates (1–2 l h^-1 and 2–3 l h^-1, respectively) than with other chelating resins, e.g., Chelex 100, palladium required slower flow rate (150 ml h^-1). Silver retained on the DMABR—SG column was completely eluted with 20 ml of 2.5% sodium thiosulfate solution but palladium remained on the column. Silver, gold and palladium were quantitatively eluted with 20 ml of 0.1% thiourea in 0.1 M hydrochloric acid.     

Crystal engineering of photochromic diarylethene single crystals

Photochromic performance of diarylethene single crystals was controlled by crystal engineering using non-covalent aromatic-aromatic interactions as the directional intermolecular force. A diarylethene derivative with two pentafluorophenyl groups, 1,2-bis(2-methyl-5-pentafluorophenyl-3-thienyl)perfluorocyclopentene (1a), formed stoichiometric co-crystals with benzene (Bz) and naphthalene (Np) by aryl-perfluoroaryl interactions. Face-to-face pi-stacking interactions between the pentafluorophenyl groups of 1a and the aromatic molecules are responsible for 2:1 and 1:1 stoichiometric compositions in 1a/Bz and 1a/Np co-crystals, respectively. The diarylethene underwent thermally stable and photoreversible photochromic reactions in a homo-crystal of 1a and co-crystals 1a/Bz and 1a/Np. The absorption spectra of the photogenerated closed-ring isomers varied depending on the conformation of the diarylethene molecules packed in the crystals. The diarylethene 1a also formed 1:1 stoichiometric co-crystals with different kinds of diarylethenes, 1,2-bis(2-ethyl-5-phenyl-3-thienyl)perfluorocyclopentene (2a) and 1,2-bis[2-methyl-5-(1-naphthyl)-3-thienyl]perfluorocyclopentene (3a). Both co-crystals 1a/2a and 1a/3a showed photochromism. Although 1a, 2a, and 3a underwent efficient photocyclization reactions in their homo-crystals, highly selective photocyclization reactions of 2a or 3a were observed in the co-crystals. The selective reactions were confirmed by HPLC and X-ray crystallography. Excited energy transfers from 1a to 2a and from 1a to 3a are considered to occur and cause the selective reactions.     

Dibenzylmagnesium-Initiated Anionic Oligomerizations of trans-Stilbene, 1,1-Diphenylethylene,and α-Methylstyrene in Hexamethylphosphortriamide

trans-Stilbene, 1, 1-diphenylethylene, and α-methylstyrene were allowed to react with dibenzylmagnesium to form their oligomers in hexamethylphosphortriamide (HMPA). One and two molecules of stilbene and 1, 1-diphenylethylene were incorporated into the magnesium carbon bond, and the carbanions obtained in HMPA were stable in analogy with the anionic living polymer having alkali cation as the gegenion in eithers. Intense coloration was observed during the reaction between α-methylstyrene and dibenzylmagnesium as well as in the case of stilbene and 1, 1-diphenylethylene. The low molecular weight products which were formed after a long time in the reaction between α-methylstyrene and dibenzylmagnesium were found to have no magnesium-carbon bond. It was considered that the cleavage of the propagating chain occurred gradually after the rapid propagation had proceeded to consume the monomer.