Alloying by high dose ion implantation of iron into magnesium and aluminium

Alloys of the systems Fe–Al (mixable over the whole concentration range) and Fe–Mg (insoluble with each other) were produced by implantation of Fe ions into Al and Mg, respectively. The implantation energy was 200 keV and the ion doses ranged from 1 × 10₁₄ to 9 × 10₁₇cm^-2The obtained implantation profiles were determined by Auger electron spectroscopy depth profiling. Maximum iron concentrations reached were up to 60 at.% for implantation into Al and 94 at.% for implantation into Mg. Phase analysis of the implanted layers was performed by conversion electron Mössbauer spectroscopy and X‐ray diffraction. For implantation into Mg, two different kinds of Mössbauer spectra were obtained: at low doses paramagnetic doublets indicating at least two different iron sites and at high doses a dominant ferromagnetic six‐line‐pattern with a small paramagnetic fraction. The X‐ray diffraction pattern concluded that in the latter case a dilated αiron lattice is formed. For implantation into Al, the Mössbauer spectra were doublet structures very similar to those obtained at amorphous Fe–Al alloys produced by rapid quenching methods. They also indicated at least two different main iron environments. For the highest implanted sample a ferromagnetic six‐line‐pattern with magnetic field values close to those of Fe₃Al appeared.     

State of and prospects for XeF(C−A) optically pumped lasers

Experimental and theoretical results are presented on an XeF(C?A) blue-green laser driven by 5-kJ energy. The laser was pumped by a ferrite-induced discharge of 90 cm in length. The output energy of 0.22 J was obtained with a plane-parallel resonator. A program to simulate laser operation has been developed. Numerical results for a wide range of conditions are compared with experiments performed by us and by other authors. It is found that intracavity refractive losses limit laser operation for XeF pressures above 3 torr. The laser efficiency strongly depends on the discharge-to-cavity length ratio. Possible ways to increase the laser power and efficiency are discussed.     

有势场逆问题的边界元法

本文给出了位势方程逆问题的一种最小二乘边界元解法。控制方程为Ｌａｐｌａｃｅ方程，但一部分边界上未给出任何边值，而只在某些内点上给出了势函值。这一问题在数学上属不适定问题，但在一定条件下存在唯一解。本文同时给出了一种估计解的可靠性的方法。数值试验表明，这类逆问题采用边界元法是非常有效的。     

Why define atoms in real space?

The physics of a system is determined by a variation of the action integral, i.e., by a variation of the space–time volume integral of the Lagrange function. If one demands that the properties of an atom in a molecule be derived from physics, the atom must generate its own space–time volume, requiring that its boundaries be defined in real space. The variations in the action are related to the actions of generators of infinitesimal unitary transformations. In the general case, the action integral is altered by generators acting in both the spacelike and timelike surface bounding the space–time volume, whereas for a total isolated system, the physics is totally determined by their action in just the spacelike surfaces at the two time endpoints. It is shown and illustrated for a one-dimensional system that the definition of an atom corresponds to the possibility of choosing a subsystem in such a way that the contributions to the change in action resulting from the evolution in time of its spatial boundaries vanishes identically. The properties of these subsystems and of the total system of which they are a part are, therefore, determined by one and the same action principle. This choice of subsystem corresponds to the possibility of augmenting the Lagrange function by the divergence of the gradient of the electron density a step that, while leaving the equations of motion unchanged, modifies the generating operators in the required manner. © 1994 John Wiley & Sons, Inc.     

Three-dimensional atom probe study of the segregation behaviour of Ni91Pt9 alloy after sputtering

To investigate local ordering and segregation phenomenon in a Ni91Pt9-alloy after sputtering and annealing a 3D optical atom probe (OAP) has been used. The specimen tips have been prepared from polycrystalline samples. To sputter the samples a separate preparation chamber with a scannable Ar-sputter-gun is connected to the OAP vessel. When necessary, the sample can be electrically heated to induce segregation and cure the altered layer. After a heat treatment of a Ni91 at. %Pt 9 at.% specimen at 1100 K the surface of a (111)-oriented specimen is enriched in platinum by a factor of two in relation to the bulk. The phenomenon of short-range ordering has been investigated on the surface and in the subsurface volume. A 3D reconstruction of this annealed NiPt specimen shows regions with high concentration of platinum that gives an indication at short-range ordering. Uniform sputtering of the tip without a heat treatment induces a decisive depletion of Pt on the surface and the following subatomic layers. The atom-probe results of specimens in thermal equilibrium are in close agreement to further surface sensitive results obtained from Ion Scattering Spectroscopy (ISS) and Auger Electron Spectroscopy (AES).     

TZT/AC/PMMA体系光谱烧孔及激光诱导的填孔效应的研究

报道四苯并卟啉锌/芳晴/有机玻璃TZT/AC/PMMA体系光化学烧孔的光谱稳定性、多重烧孔及激光诱导的填孔效应。 关键词：     

Spin effects in instanton models

Nonperturbative nolocal structure of QCD vacuum is well described by instanton model. Specific helicity and flavor structure of zero modes of quarks, in instanton field allows simultaneously to explain some important features of low-and high-energy hadron phenomemology. The basic characteristics of hadron spectrum, partonic sum rules, heavyquark potential etc within the instanton liquid model are briefly discussed.     

Study of the charge-exchange reactions\pi ^ - p \to (\pi ^0 ,\eta ,\eta \prime )n at 63 GeV

Muon electron pairs were detected in an Al multiplate spark chamber, exposed to a neutrino beam from the CERN PS. The leptons were not accompanied by other particles, except occasionally by protons. The background came mainly from muon associated π⁰ production, with one decay gamma lost. It was determined empirically, together with the small contribution from υ _e reactions. For electron energies above 2 GeV the background is 5.7±1.5 events, whereas 18 (μe)-candidates have been observed. Hence the effect is established, with a rate of about 10^?4 as compared to the muonic reactions above 3 GeV. Charm creation as the origin of this (μe)-production process is excluded; heavy neutral lepton production does not fit the kinematics observed. Instead the events are compatible with the two-body decay of an object with variable invariant mass of order 1 GeV, possibly resulting from axion interactions.