Enantioselective metal-free reduction of ketones by a user-friendly silane with a reusable chiral additive

1-Hydrosilatrane, a safe and easy-to-handle reducing reagent that can be inexpensively accessed, has been shown to reduce prochiral ketones asymmetrically in the presence of chiral 1,2-aminoalcohols with ees ranging from 8% to 86%. The best result was achieved using ephedrine as the source of chirality, which is readily commercially available. The additive can be recovered through extraction and reused without any erosion of enantioselectivity.     

A new strategy for the synthesis of pyrazolo[4,3-e][1,2,4]triazolo[4,3-c]pyrimidines and pyrazolo[4,3-e][1,2,4]triazolo[1,5-c]pyrimidines

A series of pyrazolo[4,3-e][1,2,4]triazolo[4,3-c]pyrimidines were prepared via oxidative cyclization of aldehyde N-(1,3-diphenylpyrazolo[3,4-d]pyrimidin-4-yl)hydrazones. Dimroth rearrangement of such a series yielded pyrazolo[4,3-e][1,2,4]triazolo[1,5-c]pyrimidines.     

Physical immobilization of Rhizopus oryzae lipase onto cellulose substrate: activity and stability studies

Rhizopus oryzae lipase (ROL) was immobilized by adsorption onto oxidized cellulose fibers and regenerated films. The maximum adsorption level increases with the raise in the amount of carboxylic groups on cellulose surface confirming that adsorption is being governed mainly by electrostatic interaction between the enzyme and the substrate. This hypothesis was further confirmed by zeta-potential measurements showing a decrease in the zeta-potential of the fibers after enzyme adsorption. XPS analysis showed an intensification of the N 1s peak attesting the presence of the enzyme on the surface. The effect of temperature, pH and solvent polarity on the immobilized enzyme activity and stability was investigated. The catalytic esterification of oleic acid with n-butanol has been carried on using hexane as an organic solvent. A high conversion yield was obtained (about 80%) at 37 degrees C with a molar ratio of oleic acid to butanol 1:1 and 150IU immobilized lipase. The adsorption achieved two successive cycles with the same efficiency, and started to lose its activity during the third cycle.     

Ca2+‐complex stability of GAPAGPLIVPY peptide in gas and aqueous phase,investigated by affinity capillary electrophoresis and molecular dynamics simulations and compared to mass spectrometric results

Strong, sequence‐specific gas‐phase bindings between proline‐rich peptides and alkaline earth metal ions in nanoESI‐MS experiments were reported by Lehmann et al. (Rapid Commun. Mass Spectrom. 2006, 20, 2404–2410), however its relevance for physiological‐like aqueous phase is uncertain. Therefore, the complexes should also be studied in aqueous solution and the relevance of the MS method for binding studies be evaluated. A mobility shift ACE method was used for determining the binding between the small peptide GAPAGPLIVPY and various metal ions in aqueous solution. The findings were compared to the MS results and further explained using computational methods. While the MS data showed a strong alkaline earth ion binding, the ACE results showed nonsignificant binding. The proposed vacuum state complex also decomposed during a molecular dynamic simulation in aqueous solution. This study shows that the formed stable peptide–metal ion adducts in the gas phase by ESI‐MS does not imply the existence of analogous adducts in the aqueous phase. Comparing peptide–metal ion interaction under the gaseous MS and aqueous ACE conditions showed huge difference in binding behavior.     

Recent advances in capillary electrophoretic migration techniques for pharmaceutical analysis (2013–2015)

This review updates and follows‐up a previous review by highlighting recent advancements regarding capillary electromigration methodologies and applications in pharmaceutical analysis. General approaches such as quality by design as well as sample injection methods and detection sensitivity are discussed. The separation and analysis of drug‐related substances, chiral CE, and chiral CE‐MS in addition to the determination of physicochemical constants are addressed. The advantages of applying affinity capillary electrophoresis in studying receptor–ligand interactions are highlighted. Finally, current aspects related to the analysis of biopharmaceuticals are reviewed. The present review covers the literature between January 2013 and December 2015.     

A sensitive nitrite sensor using an electrode consisting of reduced graphene oxide functionalized with ferrocene

A composite consisting of chitosan containing azidomethylferrocene covalently immobilized on sheets of reduced graphene oxide was drop-casted on a polyester support to form a screen-printed working electrode that is shown to enable the determination of nitrite by cyclic voltammetry and chronoamperometry. Both reduction and oxidation of nitrite can be accomplished due to the high electron-transfer rate of this electrode. Under optimal experimental conditions (i.e. an applied potential of 0.7 V vs. Ag/AgCl in pH 7.0 solution), the calibration plot is linear in the 2.5 to 1450 μM concentration range, with an ~0.35 μM limit of detection (at a signal-to-noise ratio of 3). The sensor was successfully applied to the determination of nitrite in spiked mineral water samples, with recoveries ranging between 95 and 101 %.

Open image in new window

Graphical abstract We describe the design of ferrocene-functionalized reduced graphene oxide electrode and its electrocatalytic properties towards the determination of nitrite. Compared to a reduced graphene oxide electrode, the sensor exhibits enhanced electrocatalytic activity towards both oxidation and reduction of nitrite.

     

Thio effects on the departure of the 3'-linked ribonucleoside from diribonucleoside 3',3'-phosphorodithioate diesters and triribonucleoside 3',3',5'-phosphoromonothioate triesters: implications for ribozyme catalysis

To provide a solid chemical basis for the mechanistic interpretations of the thio effects observed for large ribozymes, the cleavage of triribonucleoside 3',3',5'-phosphoromonothioate triesters and diribonucleoside 3',3'-phosphorodithioate diesters has been studied. To elucidate the role of the neighboring hydroxy group of the departing 3'-linked nucleoside, hydrolysis of 2',3'-O-methyleneadenosin-5'-yl bis[5'-O-methyluridin-3'-yl] phosphoromonothioate (1 a) has been compared to the hydrolysis of 2',3'-O-methyleneadenosin-5'-yl 5'-O-methyluridin-3'-yl 2',5'-di-O-methyluridin-3'-yl phosphoromonothioate (1 b) and the hydrolysis of bis[uridin-3'-yl] phosphorodithioate (2 a) to the hydrolysis of uridin-3'-yl 2',5'-di-O-methyluridin-3'-yl phosphorodithioate (2 b). The reactions have been followed by RP HPLC over a wide pH range. The phosphoromonothioate triesters 1 a,b undergo two competing reactions: the starting material is cleaved to a mixture of 3',3'- and 3',5'-diesters, and isomerized to 2',3',5'- and 2',2',5'-triesters. With phosphorodithioate diesters 2 a,b, hydroxide-ion-catalyzed cleavage of the P--O3' bond is the only reaction detected at pH >6, but under more acidic conditions desulfurization starts to compete with the cleavage. The 3',3'-diesters do not undergo isomerization. The hydroxide-ion-catalyzed cleavage reaction with both 1 a and 2 a is 27 times as fast as that compared with their 2'-O-methylated counterparts 1 b and 2 b. The hydroxide-ion-catalyzed isomerization of the 3',3',5'-triester to 2',3',5'- and 2',2',5'-triesters with 1 a is 11 times as fast as that compared with 1 b. These accelerations have been accounted for by stabilization of the anionic phosphorane intermediate by hydrogen bonding with the 2'-hydroxy function. Thio substitution of the nonbridging oxygens has an almost negligible influence on the cleavage of 3',3'-diesters 2 a,b, but the hydrolysis of phosphoromonothioate triesters 1 a,b exhibits a sizable thio effect, k(PO)/k(PS)=19. The effects of metal ions on the rate of the cleavage of diesters and triesters have been studied and discussed in terms of the suggested hydrogen-bond stabilization of the thiophosphorane intermediates derived from 1 a and 2 a.     

Highly enantioselective conjugate addition of thiols using mild scandium triflate catalysis

A Sc complex of (4S,5S)-diphenyl PYBOX 1 was found to serve as a catalyst for the asymmetric conjugate addition reactions between various thiols and 3-crotonoyl-2-oxazolidinone, affording the corresponding adducts in good yields and high enantioselectivies (up to 92% ee). A new improved method for making (4S,5S)-diphenyl PYBOX is presented.     

Studies of interactions between silane coupling agents and cellulose fibers with liquid and solid-state NMR

The hydrolysis of three alkoxy-silane coupling agents, gamma-methacryloxypropyl trimethoxy silane (MPS), gamma-aminopropyl triethoxy silane (APS), and gamma-diethylenetriaminopropyl trimethoxy silane (TAS), was carried out in ethanol/water solutions (80/20 w/w) at different pH values and followed by 1H, 13C and 29Si NMR spectroscopy. Acidic media were found to stabilize the hydrolyzed forms. As expected, the formation of silanol groups was followed by their self-condensation to generate oligomeric structures, yielding, ultimately, solid homopolycondensated structures, as analyzed by 29Si and 13C high-resolution solid-state NMR. Hydrolyzed MPS in acidic media was then successfully adsorbed onto a cellulose surface and the ensuing substrates submitted to thermal treatment at 110-120 degrees C under reduced pressure, in order to create covalent bonds between cellulose and the coupling agent.