Dodecyl benzenesulfonic acid (DBSA) surfactant was used in the present study to find the effect of concentration on its electrical conductance in solution from 293-323K above and below the critical micelle concentration (CMC). The micellization parameters i.e. degree of counter ion binding (β), aggregation number (n) and number of counter ion micelle(m) were measured. The interaction of DBSA with polyvinylpyrrolidone (PVP) was also studied at 293K throughconductance and surface tension measure ments. A number of important parameters i.e. critical aggregation concentration (CAC), Gibb‘s free energy (△G) and binding ratio (R) were determined and the effect of NaCl on the CAC and polymer saturation point (PSP) was also investigated. 相似文献
ZnBr2-catalysed phenylthioalkylation of ketene bis(trimethylsilyl)acetals, obtained from carboxylic acids, with appropriate α-chlorosulphides can be used to prepare γ- and δ- lactones. 相似文献
A simple and selective method for rapid and efficient concentration and determination of μg l−1 levels of Au(III) ions in aqueous solution using octadecyl silica membrane disks modified by pentathia-15-crown-5 and flame atomic absorption spectrometry is presented. The influence of flow rates of eluent and sample solution, amount of ligand, types and least amount of eluent for elution of Au from disks were investigated. Break through volume and limit of detection of the membrane disks modified by 5 mg of the thiacrown ether was found to be 2.0 l and 1.0 μg l−1, respectively. The effects of various cationic interferences on percent recovery of gold were studied. The method was successfully applied for the determinations of gold in some pharmaceutical samples and for the recovery of trace Au3+ ions from synthetic and water samples. 相似文献
A specific method was developed for the quantitative determination of the renin inhibitor CP-BO,794. Serum extracts containing the drug and an internal standard were injected into a standard reverse-phase high-performance liquid chromatography (HPLC) column. The mobile phase, methanol/water (8/2), flowed at 1 ml/min through the column and then via a heated nebulizer interface into a corona discharge atmospheric pressure chemical ionization source. The assay minimum limit of quantification was 50 pg/mL. It exhibits satisfactory accuracy and precision over the range 50 pg/ml, to 10 ng/mL. A minor modification of the HPLC mobile phase was necessary to attain extremely low detection limits. The addition of a structural analogue contributed to enhancing the precision of the assay. 相似文献
Transfer of technology is a complex process with many facets, options and constraints. While the concept is an important step in bringing industrialization process to agricultural based countries, it is clear, however, that a country will only benefit from a new technology if it addresses a real need, and if it can be absorbed and adapted to suit the existing cultural and technological base.
International Atomic Energy Agency, as UN body, has a mandate to promote nuclear applicationsand assist Member States in transfer of technology for peaceful applications. This mandate has been pursued by many different mechanisms developed in the past years: technical assistance, coordinated research programmes, scientific and technical meetings, publications, etc. In all these activities the Agency is the organizer and initiator, but main contributions come from expert services from developed countries and, increasingly, from developing countries themselves. The technical cooperation among developing coutries more and more becomes part of different programmes.
In particular, regional cooperation has been demonstrated as an effective instrument for transfer of technology from developed and among developing countries.
Some examples of actual programmes are given. 相似文献
The conformational stability and structure of 2,3-dimethylpropenal, 2,3-difluoropropenal and their 3,3-dimethyl and 3,3-difluoro derivatives were investigated utilizing ab initio calculations with 3-21G and 6-31G basis sets. For 2,3-dimethylpropenal and 3,3-difluoropropenal the s-trans was predicted to be the low-energy form. In the case of 3,3-dimethylpropenal and 2,3-difluoropropenal the s-cis was predicted by both levels of calculation to be the more stable conformer. Full optimization was performed at the transition states and the barriers to internal rotation were calculated. Methyl and fluorine substitution were found to significantly increase the barrier to interconversion in propenal. The relative change in the barrier depends on the position and the type of the substituent. The trans to cis barrier in 2,3-dimethylpropenal was calculated to be about 3 kcal mol−1 greater than that in 3,3-dimethylpropenal, while the cis to trans barrier in 2,3-difluoropropenal was predicted to be about 7 kcal mol−1 higher than the corresponding one in 3-3-difluoropropenal. 相似文献
A first-derivative spectrophotometric (1D) method and a derivative-ratio zero-crossing spectrophotometric (1DD) method were used to determine pyritinol dihydrochloride (I) in the presence of its precursor (II) and its degradation product (III) with 0.1N hydrochloric acid as a solvent. Linear relationships were obtained in the ranges of 6-22 microg/mL for the (1D) method and 6-20 microg/mL for the (1DD) method. By applying the proposed methods, it was possible to determine pyritinol dihydrochloride in its pure powdered form with an accuracy of 100.36 +/- 1.497% (n = 9) for the (1D) method and an accuracy of 99.92 +/- 1.172% (n = 8) for the (1DD) method. Laboratory-prepared mixtures containing different ratios of (I), (II), and (III) were analyzed, and the proposed methods were valid for concentrations of < or = 10% (II) and < or = 50% (III). The proposed methods were validated and found to be suitable as stability-indicating assay methods for pyritinol in pharmaceutical formulations. 相似文献
Multielement neutron activation analysis has been applied to the determination of macro, micro and trace amounts of Al, Br, Ca, Cl, Co, Cr, Cs, Fe, K, La, Mg, Mn, Na, Rb, Sc and V in molasses of Kom Ombo, Edfu, Armant, Naga Hammady and Abu Korkass cane sugar factories. The threshold element concentrations are acceptable and below the safety. Differences in element concentrations may be related to different botanic textures and structures, different compositions of sugar cane plants, corrosion of containers or changes in soil as a result of geochemical differentiation. The method is sensitive down to 0.038 ppm of V. The relative errors due to counting statistics are in the range of 0.2–11%. 相似文献
Summary A new simple, rapid and accurate amplification micro method for fluoride determination is described. It is based on the reaction between the sparingly soluble calcium iodate and the fluoride ion. After adding isopropyl alcohol to the solution, so that its final concentration is 65%, and filtering, an equivalent amount of the iodate is obtained. The latter is titrated iodometrically resulting in a six-fold amplification of the titre. The method is reproducible over a range from 0.4–8 mg fluoride ion. The mean recovery is 99.69%, after applying a correction factor due to potassium iodate solubility.
Zusammenfassung Ein Multiplikationsverfahren zur Mikrobestimmung von Fluorid wurde beschrieben. Es beruht auf der Umsetzung zwischen dem schlecht löslichen Calciumjodat und Fluorid. Nach Zusatz von i-Propylalkohol, bis die Lösung 65% davon enthält, wird filtriert. Die äquivalente Jodatmenge wird jodometrisch titriert. Zwischen 0,4 und 8 mg Fluorid sind die Ergebnisse reproduzierbar. Bei Anwendung eines Korrekturfaktors wegen der Löslichkeit von Kaliumjodat wurden 99,69% Fluorid wieder gefunden.
A simple synthesis has been devised for the tripodal 3,3,4-tetraamine ligand N{(CH2)3NH2}2{(CH2)4NH2} (L). This ligand forms
a copper(II) complex, [Cu (LH)Cl2]ClO4 (7), the structure of which has been determined by X-ray diffraction. The cation contains
a five-coordinate copper atom, bonded to two chloride ions, the two propylamine groups and the tertiary nitrogen atom of the
ligand; the arrangement is a distorted trigonal bipyramid, in which the two primary amine groups occupy the axial positions.
The butylamine group of the ligand does not coordinate to copper but is protonated. It is involved in hydrogen bonding to
the perchlorate ion. The e.p.r. spectrum of [Cu(dpt)Cl2] is very similar to that of (7), suggesting that it also has a trigonal
bipyramidal structure.
This revised version was published online in June 2006 with corrections to the Cover Date. 相似文献