High photosensitivity in cis-polyphenylacetylene films irradiated with 60Co γ-ray

This paper reports that ⁶⁰Co γ-ray irradiation can convert cis-polyphenylacetylene (cis-PPA) films prepared with rare-earth coordination catalysts to highly photosensitive materials. The dependence of the photosensitivity on irradiation dose, preparation methods, and microstructure of the PPA films has been investigated by means of a potential discharge technique. The photosensitivity was enhanced with increasing irradiation dose. The critical dose to produce a light response was 5 × 10³ Gy. The maximum surface potential discharge rate was 618 V/s, and the dark decay was approximately 2 V/s for cis-PPA films irradiated with ⁶⁰Co γ-ray (dose: 2 × 10⁵ Gy). The cis-transoidal-PPA and an electrophotographic photoreceptor device incorporating cis-PPA showed a higher irradiation effect. The structure and properties of ⁶⁰Co γ-ray irradiated rare-earth PPA films are similar to the unirradiated films.     

Laser-induced damage of Ta2O5/SiO2 narrow-band interference filters under different 1064 nm Nd:YAG laser modes

The laser-induced damage (LID) behavior of narrow-band interference filters was investigated with a Nd:YAG laser at 1064 nm under single-pulse mode and free-running mode. The absorption measurement of such coatings was performed with surface thermal lensing (STL) technique. The damage morphologies under the two different laser modes were also studied in detail. It was found that all the filters exhibited a pass-band-center-dependent absorption and laser-induced damage threshold (LIDT) behavior, but the damage morphologies were diverse. The explanation was given with the analysis of the electric field distribution and the operational behavior of the irradiation laser.     

Ultraviolet Luminescence in Mg0.12Zn0.88O Alloy Films

We investigate the origin of ultraviolet （UV） emission from Mg0.12 Zn0.88 O alloy thin films with a wurtzite structure fabricated on c-plane Al2O3 substrates by plasma assisted molecular beam epitaxy. At room temperature, the absorption edge and UV emission band of the Mg0.12Zn0.88O film shift to high-energy side compared with ZnO films. Temperature dependence of the photoluminescence spectra shows that the UV emission is composed of free exciton and neutral donor bound exciton emissions. Two-step dissociation processes of the UV emission are observed with the increasing temperature. The thermal quenching mechanism is attributed to the dissociation of the free exciton from the neutral donor bound exciton in the low temperature region and the dissociation of free electron and hole from the free exciton in the high temperature region.     

A lithium ethyl­ene­diphos­phon­ate containing lithium chains and symmetric hydrogen bonds

In the title compound, catena‐poly[lithium‐μ₃‐ethyl­ene­diphos­phon­ato], [Li(C₂H₇O₆P₂)]_n, the supra­molecular monoclinic (C2/c) structure consists of one‐dimensional lithium chains [Li⋯Li = 2.7036 (8) Å] that are embedded within ethyl­ene­diphosphon­ate anions linked by strong symmetric hydrogen bonds [O⋯O = 2.473 (3) Å]. The Li atoms and the H atom in the symmetric hydrogen bond reside on twofold rotation axes and there is an inversion center at the mid‐point of the C—C bond of the ethylenediphosphonate ligand.     

Resistivity－temperature characteristics of sol gel YBa2Cu3Oy samples synthesized in flowing oxygen atmosphere

The relationship of resistivity versus synthesizing temperature of sol gel YBa_2Cu_3O_y samples was studied when prepared under flowing oxygen conditions. A set of high-temperature ρ－T curves was obtained for the whole process. After the sample finished the test measuring, its resistivity was ρ_{300}=9.83×10^{-3 }Ω·cm at room temperature. The ρ－T curve also showed that the orthorhombic－tetragonal phase transformation of sol-gel YBa_2Cu_3O_y sample occurred at 581℃ for the sample in the rising temperature process, but at 613℃ in the cooling process, lower than that of the samples made by using the conventional powder metallurgy methods.     

Highly enantioselective fluorescent recognition of α-amino acid derivatives

Bisbinaphthyl-based macrocycles are found to carry out enantioselective fluorescent recognition of α-amino acid derivatives. It is observed that one enantiomer of a N-protected phenyl glycine can increase the fluorescence intensity of the binaphthyl fluorophores by over 4-fold but the other enantiomer does not cause much fluorescence enhancement. This highly enantioselective fluorescent response makes the binaphthyl macrocycles practically useful for the enantioselective fluorescent recognition of the amino acid substrate.     

Mid-infrared generation based on a periodically poled LiNbO3 optical parametric oscillator

We report a nanosecond Nd:YVO_4-pumped optical parametric oscillator (OPO) based on periodically poled LiNbO_3 (PPLN). Tuning is achieved in this experiment by varying the temperature and period of the PPLN. The design of double-pass singly resonant oscillator (DSRO) and confocal cavity enables the OPO threshold to be lowered considerably, resulting in a simple, compact, all-solid-state configuration with the mid-infrared idler powers of up to 466mW at 3.41μm.     

ASYMPTOTIC NORMALITY OF KERNEL ESTIMATES OF A DENSITY FUNCTION UNDER ASSOCIATION DEPENDENCE

Let {X_n, n≥1} be a strictly stationary sequence of random variables, whichare either associated or negatively associated, f(·) be their common density. In this paper,the author shows a central limit theorem for a kernel estimate of f(·) under certain regularconditions.     

作业成本法数学模型的创新

随着企业产品价格竞争愈演愈烈，成本的合理分配、计算日显重要，但在间接费用的分摊上，传统成本会计对成本信息反映失真的局限性日益显露，会计理论界和实务界开始寻求一种新的准确的成本计算方法，作业成本法应运而生。本将由作业成本法基本原理推导出其数学模型，并将对其数学模型进一步改进，建立比较数学模型。使作业成本法向实际应用更进一步。