Low-frequency Raman scattering in a polycrystalline C60 film: The role of orientational disorder

Low-frequency Raman scattering in the orientationally disordered phase of a polycrystalline C₆₀ film is investigated. By analogy with disordered media (glasses), the low-frequency Raman spectra are interpreted in terms of light scattering by localized vibrational states.     

Dispersion Compensation in Externally Modulated Transmission System Using Chirped Fiber Grating

We present an externally modulated NTSC AM-VSB erbium-doped fiber amplifier (EDFA)-repeated system in the 1550 nm region which uses a chirped fiber grating (CFG) as a dispersion compensation device. In contrast to the conventional externally modulated fiber optical CATV systems, either with or without dispersion compensation fiber (DCF), good performances of carrier-to-noise ratio (CNR) ≥50 dB, composite second order (CSO) ≥74 dB, and composite triple beat (CTB) ≥65 dB were achieved for the full channel band after a 100-km single-mode fiber (SMF) transmission.     

Simulation of a turbulent premixed open V-shaped flame using contour advection with surgery

Despite its capability of high spatial resolution, simulation of turbulent flows with traditional Lagrangian (front tracking) scheme is often discouraged by numerical instability caused by clustering of marker nodes and topological changes of fronts. Contour advection surgery (CAS), being a robust front tracking scheme, can limit the growth of front complexity during simulation without jeopardizing accuracy or efficiency. This allows it to open up an advantage over traditional front-tracking schemes. It has already been demonstrated that CAS, with incorporation of the reaction sheet model, can accurately simulate the propagation and advection of a turbulent premixed V-shaped flame. In this study, it is further tested with 10 values of vortex circulation. A range of upstream turbulence levels of 1.8–19.8% was obtained. Results indicate that upstream turbulence increase the average flame length, flame zone area and the overall burning rate. Flame surface density Σ was also estimated. Maximum values of Σ obtained lie in the range 0.1–1.4 mm⁻¹. Skewness towards the burnt region was observed in all profiles of Σ. Similar to results from laboratory experiments, it was found that Σ values decreases with upstream turbulence. From this study, the ability of CAS to cope with intense turbulence is demonstrated and a better quantitative understanding on the scheme has also been acquired.     

Au deposits on graphite: On the nature of high temperature desorption peaks in CO thermal desorption spectra

Due to the discovery of Au as a catalyst for low temperature CO oxidation, the adsorption of CO on Au surfaces has attracted a lot of attention recently. On stepped and rough single crystal surfaces as well as on deposited particles two characteristic desorption states above 100 K have been observed via TPD. We have studied Au deposits on graphite in order to elucidate the nature of these desorption peaks in more detail. For this purpose, Au was deposited at 100 K and 300 K on HOPG as a weakly interacting support. In analogy to other supports, we obtain two desorption states (∼140 K and ∼170 K) whose relative intensities depend strongly on the deposition temperature with the high temperature peak being much more pronounced for the 100 K deposits. After annealing to 600 K, both states drastically lose intensity. XP spectra, on the other hand, show virtually no decrease of the Au 4f intensity as would be expected for desorption or significant changes of the particle morphologies. We conclude that both desorption peaks are defect-related and connected with under-coordinated Au atoms that are lost for the most part upon annealing. These sites could be located at the perimeter of dendritic islands or on small, defect-rich particles in addition to larger particles not adsorbing CO at 100 K. Preliminary STM results are in favour of the second interpretation.     

Bulk Sn1−xMnxO2 magnetic semiconductors without room-temperature ferromagnetism

Polycrystalline Sn_1−xMn_xO₂ (0≤x≤0.05) diluted magnetic semiconductors were prepared by solid-state reaction method and their structural and magnetic properties had been investigated systematically. The three Mn-doped samples (x=0.01, 0.03, 0.05) undergo paramagnetic to ferromagnetic phase transitions upon cooling, but their Curie temperatures are far lower than room temperature. The magnetization cannot be attributed to any identified impurity phase. It is also found that the magnetization increases with increasing Mn doping, while the ratio of the Mn ions contributing to ferromagnetic ordering to the total Mn ions decreases.     

Optical characterization of thin thermal oxide films on copper by ellipsometry

A complete optical characterization in the visible region of thin copper oxide films has been performed by ellipsometry. Copper oxide films of various thicknesses were grown on thick copper films by low temperature thermal oxidation at 125 °C in air for different time intervals. The thickness and optical constants of the copper oxide films were determined in the visible region by ellipsometric measurements. It was found that a linear time law is valid for the oxide growth in air at 125 °C. The spectral behaviour of the optical constants and the value of the band gap in the oxide films determined by ellipsometry in this study are in agreement with the behaviour of those of Cu₂O, which have been obtained elsewhere through reflectance and transmittance methods. The band gap of copper oxide, determined from the spectral behaviour of the absorption coefficient was about 2 eV, which is the generally accepted value for Cu₂O. It was therefore concluded that the oxide composition of the surface film grown on copper is in the form of Cu₂O (cuprous oxide). It was also shown that the reflectance spectra of the copper oxide–copper structures exhibit behaviour expected from a single layer antireflection coating of Cu₂O on Cu. Received: 19 July 2001 / Accepted: 27 July 2001 / Published online: 17 October 2001     

GENERALIZED DIFFERENTIAL QUADRATURE METHOD FOR THE FREE VIBRATION OF TRUNCATED CONICAL PANELS

This paper presents an improved generalized differential quadrature (GDQ) method for the investigation of the effects of boundary conditions on the free vibration characteristics of truncated conical panels. The truncated conical panel is an important geometrical shape in the fields of aerospace, marine and structural engineering. However, despite this importance, few works in free vibration analysis have dealt with this particular geometry. In this work, the vibration characteristics of clamped and simply supported truncated conical shells are obtained for various circumferential wave numbers. Further, the effects of the vertex and subtended angles on the frequency parameters are also examined in detail. Due to limited published results in the open literature, results for a range of cases are compared with those generated from the commercial finite element solver McNeal-Schwendler Corporation Nastran, and excellent agreement is observed.     

Combining PSMs with hard OR methods: the philosophical and practical challenges

Combinations of problem structuring methods with hard OR methodologies are seldom described in the literature. This paper will reflect on the barriers to such combinations that can be seen at the philosophical level—paradigm incommensurability—and cognitive level—type of personality and difficulty of switching paradigm. This paper examines the combination of Soft Systems Methodology and Discrete Event Simulation within an Intermediate Care case study. The paper will argue, by way of the practical application, that these problems are not insurmountable and that the result can be seen as interplay of the soft and hard paradigms. The idea of yin and yang is proposed as a metaphor for this process.     

Studies on cardiac ingredients of plants. VII: Chemical transformation of proscillaridin by means of the Diels-Alder reaction and biological activities of its derivatives.

The Diels-Alder reactions of a cardiac glycoside, proscillaridin (1), with some dienophiles were investigated. The reaction of 1 with alkenes such as methyl vinyl ketone and methyl acrylate afforded 3-oxo-2-oxabicyclo[2.2.2]oct-7-enes (2-5) and para-substituted benzene derivatives (6 and 7), while 1 reacted with alkynes (3-butyn-2-one, methyl propiolate) to yield para- or meta-substituted benzene derivatives (6-9). The biological activities of the resulting derivatives were evaluated by the use of isolated guinea-pig papillary muscle preparations and Na+,K(+)-adenosine triphosphatase (ATPase) preparation from dog kidney. Among the proscillaridin derivatives, compounds 4 and 7 moderately inhibited Na+,K(+)-ATPase activity. Furthermore, the concentration range of 7 over which its positive inotropic effect on guinea-pig papillary muscle preparations, increased from 5% to 95% of maximum was broader than that of 1, i.e., concentration dependency was maintained over a greater range of concentration.