Catalytic transformation of methane over in-loaded ZSM-5 zeolite in the presence of ethene

Methane is shown to react with ethene over In-loaded ZSM-5 to higher hydrocarbons such as propene and toluene at around 673 K. Such methane conversion is not catalyzed by proton-exchanged ZSM-5 (H-ZSM-5) under the same conditions, only C2H4 being converted to higher hydrocarbons. By using 13C-labeled methane (13CH4) as a reactant, the reaction paths for the formation of propene, benzene and toluene were examined. 13C-labeled propene (13CC2H6) is formed by the reaction of 13CH4 with C2H4. The lack of 13C-labeled benzene revealed that propene is not transformed to benzene, which instead originates entirely from C2H4. The 13C atom is inserted both into the methyl group and benzene ring in the toluene formed. This indicates that toluene is formed by two reaction paths; the reaction of 13CC2H6 with butenes formed by the dimerization of C2H4 and the reaction of benzene with 13CH4. The existence of the latter path was proved by the direct reaction of 13CH4 with benzene. The reaction of methane with benzene was also carried out in a continuous flow system over In-loaded ZSM-5. The reaction afforded 7.6% and 0.9% yields of toluene and xylenes, respectively, at 623 K.     

Comparison of PAMAM-Au and PPI-Au nanocomposites and their catalytic activity for reduction of 4-nitrophenol

Dendrimer-Au nanocomposites are prepared in aqueous solutions using poly(amidoammine)dendrimers (PAMAM) (generation 2, 3, and 5) and poly(propyleneimine)dendrimers (PPI)(generation 2, 3, and 4) by wet chemical NaBH(4) method. The Au nanoparticles thus obtained are 2-4 nm in diameter for both dendrimers and no generation dependence on the particle size is observed, whereas the generations of the dendrimers are increased as stabilization of Au-nanoparticles is achieved with lower dendrimer concentrations. Studies of the reduction reaction of 4-nitrophenol using these nanocomposites show that the rate constants for the PAMAM dendrimers (generations 2 and 3) are higher than those for the PPI dendrimers (generations 2 and 3), while a distinct difference in the rate constants is not seen for the PAMAM dendrimer (generation 5) or the PPI dendrimer (generation 4). In addition, the rate constants for the reduction of 4-nitrophenol involving all the dendrimers decrease with increases in dendrimer concentrations.     

Ring transformation of 6H-cyclopropa[e]pyrazolo[1,5-a]pyrimidine. IV (1). Reduction and reaction of 5a-acetyl-6a-ethoxycarbonyl-5a,6a-dihydro-6H-cyclopropa[e]pyrazolo[1,5-a]pyrimidine-3-carbonitriles with primary amines

The reaction of 5a-acetyl-6-ethoxycarbonyl-5a,6a-dihydro-6H-cyclopropa[e]pyrazolo[1,5-a]pyrimidine-3-carbonitrile ( 1a ) with benzylamine gave ethyl l-benzyl-5-cyano-8a,9-dihydro-2-methyl-1H-pyrrolo[3,4-e]-pyrazolo[1,5-a]pyrimidine-8a-carboxylate ( 2a ), in addition to 5-acetyl-3-benzylamino-1-(4-cyanopyrazol-3-yl)- 2-pyridone ( 3 ). Reaction of 1a with aniline gave ethyl 6-acetyl-8-anilino-3-cyano-7,8-dihydro-4H-pyrazolo-[1,5-a][1,3]diazepine-8-carboxylate ( 4 ), in addition to ethyl 3-cyano-7-methyl-6-pyrazolo[1,5-a]pyrimidine-acrylate ( 5 ). On the other hand, the same reactions of 1b with benzylamine or aniline gave 2b or 8b , respectively. Though catalytic hydrogenation of 1a over 5% palladium-carbon proceeded by ring fission of cyclopropane ring to give 9 , 1a (or 1b ) afforded 4,5-dihydro derivatives ( 13 or 15 ) by catalytic hydrogenation over platinum oxide. The reactivity of 5-methoxy-4,5,5a,6a-tetrahydro-6H-cyclopropa[e]pyrazolo[1,5-a]pyrimidine ( 16 ), which are related analogs of 1a,b , is also described.     

Evaluation of the adsorption affinity of proteins to calcium hydroxyapatites by desorption and pre-adsorption methods

The adsorption affinity of bovine serum albumin (BSA) and lysozyme (LSZ) to calcium hydroxyapatite (CaHAP) was evaluated by desorption and two step adsorption methods. These experiments were carried out at 15°C in a 1×10⁻⁴ mol dm⁻³ KCl solution of pH 6.0. BSA molecules were scarcely desorbed, exhibiting an irreversible adsorption of BSA, though LSZ slightly desorbed. This result supports our previous findings that LSZ adsorbs weakly onto phosphate ions exposed on ac or bc faces of CaHAP while BSA adsorbs strongly onto positively charged sites on ac or bc faces of CaHAP. The amount of adsorbed LSZ was markedly increased by the pre-adsorption of BSA, where LSZ was adsorbed onto BSA-covered CaHAP. On the other hand, the amount of adsorbed BSA was not changed by the pre-adsorption of LSZ. In both pre-adsorption systems it was confirmed by an HPLC method that no protein molecule pre-adsorbed was desorbed after the post-adsorption procedure. Therefore, it was interpreted that the enhancement of adsorption of positively charged LSZ is induced by an electrostatic attractive force through pre-adsorption of negatively charged BSA molecules with a high coverage. However, since the coverage of LSZ onto CaHAP is considerably low, no stimulation of BSA adsorption occurred on the LSZ-covered surface. The formation of double protein adsorbed layers consisting of pre- and post-adsorbed proteins was proposed.     

Synthesis and central nervous system stimulant activity of 5,8-methanoquinazolines fused with imidazole,thiadiazole, pyrimidine and 1,3,5-triazine

5,8-Methanoquinazolines fused with imidazoles 4a-4b , thiadiazoles 5–6 , pyrimidines 7, 9, 11 and 12 , and 1,3,5-triazine 13 were prepared starting from (5R,8S)-2-amino-8,9,9-trimethyl-5,6,7,8-tetrahydro-5,8-methanoquinazoline 3 . Most compounds possessed central nervous system stimulant activities.     

Preparation of Titania from Tetrakis(diethylamino)titanium via Hydrolysis

The conversion of tetrakis(diethylamino)titanium (Ti(NEt₂)₄) into titania via either a combination of hydrolysis (Ti(NEt₂)₄ : THF : H₂O = 1 : 10 : x, x = 2, 4, 10) at ambient conditions and calcination (method A) or hydrolysis in a water-tetrahydrofuran (THF) mixture (Ti(NEt₂)₄ : THF : H₂O = 1 : 10 : 100) at reflux (method B) was investigated. Titanium tertiary butoxide (Ti(O ^t Bu)₄) was also used as a substitute for Ti(NEt₂)₄. The hydrolysis via method A resulted in the formation of amorphous solids containing organics. Thermal analyses showed that the hydrolysis products showed mass losses up to 500°C probably due to the presence of diethylamine (Et₂NH) formed via the hydrolysis of Ti(NEt₂)₄ in the hydrolysis products, while a mass loss of the hydrolysis product from Ti(O ^t Bu)₄ was completed up to about 200°C. After calcination at 600°C, anatase or a mixture of anatase and rutile was obtained. The crystallization behavior of the hydrolysis products from Ti(NEt₂)₄ was different from that of the hydrolysis product from Ti(O ^t Bu)₄. The hydrolysis via method B gave only an amorphous material from Ti(NEt₂)₄, while a crystalline titania (anatase and brookite) formed from Ti(O ^t Bu)₄.     

Nitrogen adsorption on fluorinated activated carbon fiber

Nitrogen adsorption isotherms for fluorinated activated carbon fiber (F-ACF) and fluorinated carbon black (F-CB) were measured at 77 K. Surface structures of F-ACF and F-CB were examined by _s -plot analysis using the adsorption data on the nonporous carbon black (CB) and F-CB. The surface energy of F-ACF was lower than that of ACF. The micropore structure of ACF was preserved even after fluorination, although the limiting adsorption amount and the micropore width decreased with fluorination.     

Kinetic study of the electron-transfer oxidation of the phenolate anion of a vitamin E model by molecular oxygen generating superoxide anion in an aprotic medium

Electron-transfer reduction of molecular oxygen (O2) by the phenolate anion (1-) of a vitamin E model, 2,2,5,7,8-pentamethylchroman-6-ol (1H), occurred to produce superoxide anion, which could be directly detected by a low-temperature EPR measurement. The rate of electron transfer from 1- to O2 was relatively slow, since this process is energetically unfavourable. The one-electron oxidation potential of 1- determined by cyclic voltammetric measurements is sufficiently negative to reduce 2,2-bis(4-tert-octylphenyl)-1-picrylhydrazyl radical (DOPPH*) to the corresponding one-electron reduced anion, DOPPH-, suggesting that 1- can also act as an efficient radical scavenger.     

Surface treatment of silicon carbide using TiO2(IV) photocatalyst

Silicon carbide (SiC) and diamond were decomposed to CO(2)(g) by the photocatalysis with TiO(2) at room temperature, although the decomposition rate of diamond was very slow. According to the XPS spectra of Si2p on the SiC surface, SiO(2) was simultaneously formed on the surface by the TiO(2) photocatalysis. The thickness of the SiO(2) formed on the SiC surface during the photocatalytic oxidation for 1 h was estimated to be about 40 A from the depth profile of the XPS spectra using Ar etching. The SiC surface was oxidized by the TiO(2) photocatalysis even under the condition without a direct contact with the TiO(2). This indicates that the photocatalytic oxidation of the SiC occurs due to active oxygen species photogenerated on the TiO(2) surface, but not by hole produced in the valence band of the TiO(2). Moreover, a remote surface treatment system using the quartz beads coated with TiO(2) was developed for the SiC surface oxidation. Consequently, the TiO(2) photocatalysis will be very useful for the surface treatment of SiC such as photopatterning without defects and damage to the substrate because the photocatalytic reaction is carried out under mild conditions.