Structure and properties of the mesophase of syndiotactic polystyrene—III. Selective sorption of the mesophase of syndiotactic polystyrene

Syndiotactic polystyrene (sPS) has various crystalline forms such as α, β, γ, and δ forms, and a mesophase depending on the preparation method. In this study, we focused on the mesophase with the molecular cavity of sPS, which is obtained by step‐wise extraction of the guest molecules from the sPS δ form. To prepare the mesophase containing different shapes and sizes of the cavity, two kinds of the sPS δ form membrane cast from either toluene or chloroform solution were first prepared and then the guest molecules were removed by a step‐wise extraction method using acetone and methanol. We could succeed in the preparation of two kinds of mesophase with different shapes and sizes of the molecular cavity. Either toluene or chloroform vapor sorption to the sPS mesophase membranes was examined at 25 °C. Sorption analysis indicates that the mesophase with large molecular cavities can mainly sorb large molecules; on the other hand, the mesophase with small cavities can sorb only the small molecules, and is unable to sorb a large amount of large molecule because the cavity was too small to sorb the large molecules. Therefore, the sPS mesophase membrane has sorption selectivity based on the size of the molecular cavity. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 238–245, 2004     

Differential scanning calorimetry and thermogravimetric analysis investigation of the thermal properties and degradation of some radiation‐grafted films and membranes

The influence of irradiation and grafting on the crystallinity of three base polymers has been investigated with differential scanning calorimetry. Grafting has the largest effect on the base polymer crystallinity and results in a reduction of the crystallinity. The thermal degradation of the base polymers and grafted films has been investigated with thermogravimetric analysis. The extent of the fluorination of the base polymer, the irradiation method, and the graft level all influence the thermal degradation and its activation energy. It is proposed that the variation of the chain lengths of the grafted polystyrene chains is actually a primary underlying factor responsible for the influence of these various parameters on the degradation process. The first results of a comparative thermal analysis of some fuel‐cell membranes are also presented, and the promise and shortcomings of this method are discussed. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 2612–2624, 2004     

Extractive spectrophotometric determination of Cobalt(II) in synthetic and pharmaceutical samples using Cyanex 923.

Cyanex 923 has been proposed as a sensitive analytical reagent for the direct extractive spectrophotometric determination of cobalt(II). Cobalt(II) forms a blue-colored complex with Cyanex 923 in the organic phase. The maximum absorbance of the complex is measured at 635 nm. Beer's law was obeyed in the range 58.9 - 589.0 microg of cobalt. The molar absorptivitiy and Sandell's sensitivity of the complex was calculated to be 6.79 x 10920 l mol(-1) cm(-1) and 0.088 microg cm(-2), respectively. The nature of the extracted species was found to be Co(SCN)2 x 2S. An excellent linearity with a correlation coefficient value of 0.999 was obtained for the Co(II)-Cyanex 923 complex. Stability and regeneration of the reagent (Cyanex 923) for reuse is the main advantage of the present method. The method was successfully applied to the determination of cobalt in synthetic mixtures and pharmaceutical samples was found to give values close to the actual ones. Standard alloy samples, such as high-speed tool BCS 484 and 485, have been tested for the determination of cobalt for the purpose of validating the present method. The results of the proposed method are comparable with atomic absorption spectrometry and were found to be in good agreement.     

Preparation and characterization of finely dispersed drugs. 5. Ethyl 3,5-di(acetylamino)-2,4,6-triiodobenzoate

Controlled precipitation of the diagnostic imaging agent ethyl 3,5-di(acetylamino)-2,4,6-triiodobenzoate has been used to produce fine particles of various sizes, morphologies, and degrees of crystallinity, which depended on experimental conditions. In addition, two distinct polymorphic forms of the drug have been fully characterized by single crystal X-ray diffraction studies, and evidence for a third polymorph was also observed. Some of the so prepared dry particles were coated with a thin layer of silica.     

EQCM Study of the Couple Thallium(I)/Thallium Amalgam at a Thin Film Mercury Electrode

EQCM and voltammetric data show that thallium(I) ions, which are adsorbed in the region of the positive surface charge, most probably, in the form of the ionic pairs, are not reduced. In this potential region, thallium(I) ions are reduced directly from the solution. At more negative potentials, the previously adsorbed stable ionic pairs slowly undergo transition into the less stable form. From this form, thallium(I) ions can be reduced or desorbed into the solution. The process is best described by a model of one electron, i.e., full charge transfer.     

Study of the Surface Tension of the Aqueous Solutions of Dodecylamidoethyldimethylbenzylammonium Chloride

The dynamic and equilibrium surface tensions of aqueous dodecylamidoethyldimethylbenzylammonium chloride solutions of various concentrations at 16, 20, 25, 30, and 35°C are studied for the first time. The effects of the concentration and temperature on the surface tension relaxation are discussed. The possibility of two-dimensional phase transition and its effect on the dynamic behavior of surface tension are considered.     

Formation Enthalpies of Water–n-octane–1-propanol–sodium Dodecyl Sulfate Microemulsions at 298.15 K

The solution enthalpies of water–n-octane–1-pentanol (PeⁿOH)–sodium dodecyl sulfate (SDS) microemulsions and their components in 2-propanol at 298.15 K were determined by the thermochemical method at fixed mass fractions of PeⁿOH (0.1450) and SDS (0.0775). The formation enthalpies of microemulsions were calculated using the thermochemical cycle, and it was shown that their values are positive. The results obtained indicate that the intercomponent interactions in the investigated systems are rather weak. The formation of thermodynamically stable microemulsions is determined by entropy changes associated with the disintegration of water and 1-pentanol homoassociates.     

Peculiarities of Adsorption of Some Polar Substances from Vapor Phase on a Microporous Clay Adsorbent

The adsorption of polar organic substances (methanol, pyridine, and acetonitrile) and water was studied from the vapor phase on microporous adsorbent prepared by the substitution of polyhydroxyaluminum ions for the sodium ions of natural montmorillonite clay. The differential isosteric heats of adsorption of these substances were calculated and analyzed in a wide range of fillings.     

Generic Well-Posedness of Constrained Variational Problems Without Convexity Assumptions

In our previous work, a generic well-posedness result (with respect to variations of the integrand of the integral functional) without the convexity condition was established for a class of optimal control problems satisfying the Cesari growth condition. In this paper, we extend this generic well-posedness result to classes of constrained variational problems in which the values at the endpoints and constraint maps are also subject to variations.