锂锰尖晶石红外光谱的研究

本文对锂锰尖晶石的红外光谱进行了研究。由于锂锰尖晶石的晶体结构属于Fd3m空间群,锂离子占据四面体空隙(8a位置),锰离子占据八面体空隙(16d位置)。根据群论的知识,对锂锰尖晶石晶体中离子的振动方式与红外活性之间的内在关系进行了讨论。并列出了锂锰尖晶石的红外光谱实验数据。通过理论分析,我们推断:位于618.6和501.5cm~(-1)的红外吸收带分别来源于Mn(Ⅳ)-O和Mn(Ⅲ)-O键在晶体中的不对称伸缩振动(单元为Mn(Ⅳ)O_6和Mn(Ⅲ)O_6八面体),位于1124cm~(-1)的弱红外吸收带来源于Li-O键的不对称伸缩(单元为LiO_4四面体)。还有一些低于400cm~(-1)的可能吸收带在400～4000cm~(-1)范围内未能检测到。这一结论的可靠性通过锂锰尖晶石和掺杂的锂锰尖晶石的红外光谱实验数据得到证实。     

Foams and surface rheological properties of β-casein, gliadin and glycinin

Interfacial rheological properties and their suitability for foam production and stability of two vegetable proteins were studied and compared to β-casein. Proteins used ranged from flexible to rigid/globular in the order of β-casein, gliadin and soy glycinin. Experiments were performed at pH 6.7. Network forming properties were characterised by the surface dilational modulus (determined with the ring trough) and the critical falling film length (L_still) at which a stagnant protein film will break. Gliadin had the highest dilational modulus, followed by glycinin and β-casein, whereas glycinin formed the strongest film against fracture in the overflowing cylinder. The rate of decrease in the surface tension was studied at the air–water (Wilhelmy plate method) and the oil–water interface (bursting membrane) and the dynamic surface tension during compression and expansion in the caterpillar. Gliadin had the lowest equilibrium interfacial tensions and β-casein the lowest dynamic surface tension during expansion. Hardly any foam could be formed at a concentration of 0.1 g/l by shaking. At a concentration of 1.4 g/l most foam was formed by β-casein, followed by gliadin and glycinin. It seems that in the first place the rate of adsorption is important for foam formation. For the vegetable proteins, adsorption was slow. This resulted in lower foamability, especially for glycinin.     

Ag-Bi高温超导线材转变温度的测量

介绍了 Bi系银包套高温超导线材的电阻温度特性 ,用测电阻和电磁感应两种方法分别测量了材料的超导转变温度 ,电磁感应法测量曲线上台阶的出现表明材料中 Bi(2 2 2 3)和 Bi(2 2 12 )两相的存在。     

Adaptive regulation for deterministic systems

For the linear deterministic system with unknown orders and coefficients adaptive controls are given so that the closed-loop system is stabilized and the unknown parameters are consistently estimated. Moreover, if the parameter estimation is ignored, then the system input and output can be reduced to zero with an exponential rate.This project is supported by the National Natural Science Foundation of China.In Commemoration of the 15th Anniversary of the Acta Mathematicae Applicatae Sinica.     

Fully-angular polyhex chains with minimal total π-electron energy

By Hückel molecular orbital (HMO) theory, the calculation of the total energy of all π-electrons in conjugated hydrocarbons can be reduced to that of E(G)=|λ₁|+|λ₂|+?+|λn|, where λi are the eigenvalues of the corresponding graph G. Denote by Ψn the set of all fully-angular polyhex chains with n hexagons. In this paper, we show that Hn has the minimum total π-electron energy among chains in Ψn, where Hn is the helicene chain.     

Sharp condition of global existence for second-order derivative nonlinear Schrödinger equations in two space dimensions

This paper discusses a class of second-order derivative nonlinear Schrödinger equations which are used to describe the upper-hybrid oscillation propagation. By establishing a variational problem, applying the potential well argument and the concavity method, we prove that there exists a sharp condition for global existence and blow-up of the solutions to the nonlinear Schrödinger equation. In addition, we also answer the question: how small are the initial data, the global solutions exist?     

A Liouville type theorem for polyharmonic elliptic systems

In this paper, we consider the polyharmonic system m(−Δ)U=Vq,m(−Δ)V=Up in RN, for m>1, N>2m, with p?1, q?1, but not both equal to 1, where m(−Δ) is the polyharmonic operator. Set α=2m(q+1)/(pq−1), β=2m(p+1)/(pq−1), for α,β∈[(N−2)/2,N−2m), we prove the nonexistence of positive solutions.     

First-principle studies on the electronic structure of Fe3O4(110) surface

The first-principle was employed to study the six possible models for the Fe₃O₄(110) surface, namely the AB-terminated surface (AB model), the AB-terminated with Fe_A vacancy (AB-Fe_A vac model), the AB-terminated with Fe_B vacancy (AB-Fe_B vac model), the B-terminated surface (B model), the B-terminated surface with Fe_B vacancy (B-Fe_B vac model) and the B-terminated surface with O vacancy (B-O vac model). The stability, the electronic structure and the magnetic properties of the six surface models were also calculated. The results predict that the B-O vac model is more stable than other types of surface models. The half-metallic property remain in the AB and B models, while the other four surface models exhibit metallic properties. At the same time, the AB, AB-Fe_A vac, AB-Fe_B vac, B and the B-Fe_B vac models have ferrimagnetic properties, while the B-O vac model has antiferromagnetic property.      

Fabrication of bamboo-shaped GaN nanorods

Bamboo-shaped GaN nanorods were formed through a simple sublimation method. They were characterized by means of X-ray powder diffraction (XRD), transmission electron microscopy (TEM), high-resolution transmission electron microscopy (HRTEM) and selected-area electron diffraction (SAED). The TEM image showed that the nanorods were bamboo-like. XRD, HRTEM and SAED patterns indicated that the nanorods were single-crystal wurtzite GaN. Received: 8 January 2001 / Accepted: 28 April 2001 / Published online: 20 December 2001