Three-dimensional atom probe study of the segregation behaviour of Ni91Pt9 alloy after sputtering

To investigate local ordering and segregation phenomenon in a Ni91Pt9-alloy after sputtering and annealing a 3D optical atom probe (OAP) has been used. The specimen tips have been prepared from polycrystalline samples. To sputter the samples a separate preparation chamber with a scannable Ar-sputter-gun is connected to the OAP vessel. When necessary, the sample can be electrically heated to induce segregation and cure the altered layer. After a heat treatment of a Ni91 at. %Pt 9 at.% specimen at 1100 K the surface of a (111)-oriented specimen is enriched in platinum by a factor of two in relation to the bulk. The phenomenon of short-range ordering has been investigated on the surface and in the subsurface volume. A 3D reconstruction of this annealed NiPt specimen shows regions with high concentration of platinum that gives an indication at short-range ordering. Uniform sputtering of the tip without a heat treatment induces a decisive depletion of Pt on the surface and the following subatomic layers. The atom-probe results of specimens in thermal equilibrium are in close agreement to further surface sensitive results obtained from Ion Scattering Spectroscopy (ISS) and Auger Electron Spectroscopy (AES).     

TZT/AC/PMMA体系光谱烧孔及激光诱导的填孔效应的研究

报道四苯并卟啉锌/芳晴/有机玻璃TZT/AC/PMMA体系光化学烧孔的光谱稳定性、多重烧孔及激光诱导的填孔效应。 关键词：     

压力淬火过程中锗的相结构研究

 应用高压原位差热方法，直接测量了压力下锗的固化参数─—固化温度与过冷度。高压差热信号表明，当压力大于3 GPa时，锗在凝固过程中可能发生结构相变。X射线结构分析表明，在最终的样品中除GeⅠ相外，还形成GeⅢ相和GeⅣ相。     

Sequencing of antisense DNA analogues by capillary gel electrophoresis with laser-induced fluorescence detection

A method using capillary gel electrophoresis with laser-induced fluorescence detection is described which permits complete sequence determination of antisense DNA analogues of unknown sequence. This method, originally created as a tool to confirm the sequence of antisense oligonucleotides being developed as therapeutic drugs, utilizes data collected under a range of experimental conditions described by the Ogston model as applied to gel electrophoresis. A linear relationship independent of experimental conditions between the relative electrophoretic migration time and the oligonucleotide base number was observed and is shown to be consistent with a simplified version of this model and can be used to facilitate the sequence determination.     

A simple method improving the analyzing accuracy of circular groove guide

A simple method is introduced to improve the analysing accuracy of circular groove guide. With this method, the characteristic equation of circular groove guide is derived and its solution is given and discussed.The Project Supported by National Natural Science Foundation of P.R.China     

离心力场作用下多孔介质中强制对流换热的研究

对离心流化床中空气通过多孔物料层的强制对流换热进行了理论和实验研究。获得了气流和物料间强制对流换热的准则关联式。研究结果表明,在气流速度和温度梯度方向一致的条件下,强制对流换热比通常的边界层强制对流换热有所强化,其换热的准则关联式具有 Nu=CRePr的线性形式。从而验证了改变气流方向和热流密度矢量之间夹角可以强化换热的这一强化传热新原理。     

固体间界面的物理模型和界面对声波的反射

简要描述了模拟两固体间界面特性的弹簧模型，该模型最早是根据静力学方法提出的，后来用固体间界面薄层的声波反射方法加以改进，从界面弹簧模型可以方便地得到界面外近似边界条件，其中包含界面“弹簧”振子的劲度常数和质量，文章还给出了两相间固体中界面声反射系数的表达式，介绍了测量界面劲度常数的超声反射谱方法。最后讨论了仍关声波与界面相互作用研究领域中最近的一些研究进展。     

计量累积和控制图方案设计的选择

常规控制图已广泛应用于生产,国家标准<计数型累积和图>GB4887-85的实施,使得判断生产“过程”异常具有更高的灵敏度,能更经济地保证产品质量,它是常规控制图的改进与发展.在常规控制图中,为了使控制图能对小偏差有较快的反映,一般用缩小控制界线,如将3σ限改为2σ限,但会导致第一类误判率大大升高.而累积和方法可以通过对方案参数的适当选择使控制图在第一类误判率并不明显升高的情况下对小偏差反映敏感.此外,累积和方法还允许针对各种需要设计出特别适于发现某个偏差,例如1.5σ_e 的