Yb3+:KY(WO4)2晶体生长与光谱性能

采用泡生法生长YbKYW晶体, 通过XRD分析确认所生长的晶体为β-YbKYW. TG-DTA测量结果表明, 晶体的熔点为1045 ℃, 相变温度为1010 ℃. 测得晶体红外光谱和拉曼光谱, 对其峰值所属振动的归属进行了指认, 并测量了晶体的吸收光谱和荧光光谱. 结果表明, YbKYW晶体在940, 980 nm附近有很强的吸收峰, 主峰980 nm处的吸收截面积为1.34×10-19 cm2;该晶体在990, 1010, 1030 nm附近都有较强的荧光发射峰, 其中最强发射峰1030 nm的发射线宽高达16 nm, 有望作为可调谐激光器的增益介质. 计算得其1030 nm受激发射截面积为3.1×10-20 cm2.     

Comparison of quantitative methods for analysis of polyphasic pharmaceuticals

Adequate very sensitive quantification methods are needed for the development and are also now required for the monitoring of undesirable solid form(s) as routine tests. The pre-requisite for quantitation are selectivity, sensitivity and most important the purity of standards and their proper storage, what is a challenge for metastable forms. Several analytical techniques are available such as X-ray diffraction, spectroscopy, thermal analysis and microcalorimetry. The different steps of the validation of the analytical methods and problems to be solved are discussed. Examples illustrate the different techniques and compare their possible advantages and limits. The relative standard deviation of measurements should allow for checking the homogenization procedure of mixtures for calibration. The validation should be carried out following ICH guidelines for validation of analytical methods. Comparison of different techniques in adequate concentration range add confidence in the analytical results.     

Temperature influence on hydrogen sorption in palladium limited-volume electrodes (Pd-LVE)

The effect of temperature on hydrogen and deuterium electrosorption into a palladium LVE (limited-volume electrode) has been investigated. A decrease in hydrogen capacity (H/Pd ratio) with increasing temperature has been observed. Temperature strongly influences the plots of measured H(D)/Pd values vs. potential scan rate. In addition, hydrogen absorption was found to be dependent on the composition of the surrounding electrolyte solution. These results have confirmed the hypothesis that two different mechanisms of hydrogen desorption from the palladium electrode take place, namely electrochemical oxidation and non-electrochemical recombination. Further, the ratio between the rate constants for these two processes has been found to change with temperature. Electronic Publication     

Kinetics of thermal decomposition of alkaline phosphates

Summary The thermal behavior of KH₂PO₄, NaH₂PO₄ and Na₂HPO₄ under non-isothermal conditions using TG method with different heating rates was studied. The values of the reaction rate were processed by means of Friedmans differential-isoconversional method. A dependence of the activation energy vs. conversion was observed. Therefore a procedure based on the compensation effect (suggested by Budrugeac and Segal) was applied. A less speculative data processing protocol was offered by the non-parametric kinetics method suggested by Serra, Nomen and Sempere. Three steps were observed by non-isothermal heating: a dehydration, a dimerization and a polycondensation. The differences in the intimate reaction mechanism are determined by the initial number of water molecules.     

Interaction of gas phase atomic hydrogen with Pt(111):Direct evidence for the formation of bulk hydrogen species

Employing hot tungsten filament to thermal dissociate molecular hydrogen,we generated gas phase atomic hydrogen under ultra-high vacuum(UHV)conditions and investigated its interaction with Pt(111) surface.Thermal desorption spectroscopy(TDS)results demonstrate that adsorption of molecular hy- drogen on Pt(111)forms surface Had species whereas adsorption of atomic hydrogen forms not only surface Had species but also bulk Had species.Bulk Had species is more thermal-unstable than surface Had species on Pt(111),suggesting that bulk Had species is more energetic.This kind of weakly- adsorbed bulk Had species might be the active hydrogen species in the Pt-catalyzed hydrogenation reactions.     

The Reaction and Applied Study of the Amide and P_2S_5

It is usually reported that reaction between carbonyl and P2S5 produce thiono group compound. The Products from carbonyl after ammonolysis and hydrazinolysis have the very import applied value in the synthesize of heterocyclic compound. Sulfuration reation if a nucleophilic attack, SPS2 anionsid obtained from P2S5 in the organic sovent, rather easier than thereationsof scheeren’s reagent. The reation mechanism is as follows: The reation speed has something todo with the electronegative of…     

Simple and controllable synthesis of highly dispersed Pt-Ru/C catalysts by a two-step spray pyrolysis process

A carbon supported Pt-Ru catalyst with uniform distribution and small average size of the Pt-Ru particles was synthesized using a two-step spray pyrolysis (SP) method; the electrocatalytic activity of the prepared catalyst for methanol oxidation is better than that of the standard commercial catalyst.     

二吡啶四硝基酞菁钴的合成及光谱—电化学性质研究

本文报道了以钼酸铵为催化剂,将4—硝基邻苯二甲酸酐、脲和氯化铵混合,于220℃加热合成四硝基酞菁钴,将此配合物溶于吡啶,于115℃加热反应6天合成了二吡啶四硝基酞菁钻配合物。并对二吡啶四硝基酞菁钴的氧化还原半波电势、电解氧化还原产物的电子吸收光谱进行了研究。     

An Easy One-Pot Procedure for the Synthesis of <Emphasis Type="Italic">N</Emphasis>-Sulfonyl Phosphorous Ylides and Sulfonyl Iminophosphoranes

Summary. Reaction of triphenylphosphine and an electron deficient acetylenic ester in the presence of strong N–H acid such as alkyl and aryl sulfamides or acetamide produces phosphorous ylides at room temperature in CH₂Cl₂. The aryl sulfamide phosphoranes undergo a smooth transformation reaction in boiling toluene and produce iminophosphoranes.