Solution NMR techniques for large molecular and supramolecular structures

Transverse relaxation-optimized spectroscopy (TROSY) or generation of heteronuclear multiple quantum coherences during the frequency labeling period and TROSY during the acquisition period have been combined either with cross-correlated relaxation-induced polarization transfer (CRIPT) or cross-correlated relaxation-enhanced polarization transfer (CRINEPT) to obtain two-dimensional (2D) solution NMR correlation spectra of (15)N,(2)H-labeled homo-oligomeric macromolecules with molecular weights from 110 to 800 kDa. With the experimental conditions used, the line widths of the TROSY-components of the (1)H- and (15)N-signals were of the order of 60 Hz at 400 kDa, whereas, for structures of size 800 kDa, the line widths were about 75 Hz for (15)N and 110 Hz for (1)H. This paper describes the experimental schemes used and details of their setup for individual measurements. The performance of NMR experiments with large structures depends critically on the choice of the polarization transfer times, the relaxation delays between subsequent recordings, and the water-handling routines. Optimal transfer times for 2D [(15)N,(1)H]-CRIPT-TROSY experiments in H(2)O solutions were found to be 6 ms for a molecular weight of approximately 200 kDa, 2.8 ms for 400 kDa, and 1.4 ms for 800 kDa. These data validate theoretical predictions of inverse proportionality between optimal transfer time and size of the structure. The proton longitudinal relaxation times in H(2)O solution were found to be of the order of 0.8 s for structure sizes around 200 kDa, 0.4 s at 400 kDa, and 0.3 s at 800 kDa, which enabled the use of recycle times below 1 s. Since improper water handling results in severe signal loss, the water resonance was kept along the z-axis during the entire duration of the experiments by adjusting each water flip-back pulse individually.     

A facile retro-ene reaction of 5-(methoxyamino)-3-aryl-1,3,4-oxadiazol-2(3H)-ones

5-(N-Methoxy-N-methyl)amino-3-aryl-1,3,4-oxadiazol-2(3H)-ones 3 undergo a heteroretro-ene reaction in refluxing methanol in which the leaving enophile is formaldehyde. The resulting 5-(methylimino)-3-aryl-1,3,4-oxadiazolidin-2-one 4 may be viewed as a kinetic product which tautomerizes to the more stable 5-(methylamino)-3-aryl-1,3,4-oxadiazol-2(3H)-one 5 as the thermodynamic product. Comparison of calculated reaction energies reveals that the presence of the heterocyclic ring facilitates the retro-ene reaction, but the expulsion of formaldehyde is predicted to be highly exothermic even in its absence.     

Bromination of 2,1,3-benzothiadiazoles

The bromination of 2,1,3-benzothiadiazoles in 47% hydrobromic acid at elevated temperature has led to a general preparative method for the synthesis in high yield of otherwise difficulty accessible brominated 2,1,3-benzothiadiazoles. The typical addition reaction is apparently eliminated under these reaction conditions and substitution takes place exclusively. Bromination of 2,1,3-benzothiadiazole occurs successively at positions 4 and 7. 4-Substituted 2,1,3-benzothia-diazoles are selectively brominated at position 7. 5-Bromo- and 5-methyl-2,1,3-benzothiadiazole are brominated consecutively at positions 4 and 7.     

Synthesis,spectroscopic and redox properties of nickel(II) salicylaldimine complexes containing sterically hindered phenols

The preparation and spectroscopic characterization of a series of new bis[N-(2,6-di-t-butyl-1-hydroxyphenyl)salicylaldiminato]nickel(II) complexes, [Ni(L^X)₂], bearing one or two OH and MeO substituents on the salicylaldehyde moiety, as well as radical species generated from these compounds by the oxidation with PbO₂, are reported. The [Ni(L^X)₂] chelates, which appear to be tetrahedral in the solid state and in dioxane solution, are converted into a square-planar configuration in non-donor solvents. The OH-substituted complexes, unlike their MeO analogues, form six-coordinate adducts in pyridine, DMF and DMSO. These new compounds, unlike their analogues with electron-withdrawing substituents (Cl, Br, NO₂), are easily oxidized by PbO₂ to produce Ni^II-stabilized phenoxy radicals in which the unpaired electrons are delocalized over the ligand and do not couple with the second radical center. No e.s.r. signals were observed that could be attributed to a M = ±2 transition of the triplet state biradicals.     

Ab-initio-Berechnungen des π-Bindungsbeitrages in BF3 und BCl3

Ab initio gradient calculations were performed on BF₃ and BCl₃ to evaluate the -contribution in these compounds. The influence of the basis set on the results is studied for borontrifluoride. For the chlorine compound the -contribution is smaller than for the fluorine compound.

     

Development of an ethanol-selective optode membrane based on a reversible chemical recognition process

Lipophilic trifluoroacetophenone derivatives incorporated in plasticized PVC membranes are able to selectively extract water and alcohols from the sample solution into the organic membrane phase, reversibly forming hydrates and hemi-acetals, respectively. Since this is accompanied by a change in the absorption spectrum of the acetophenone isologue, the chemical recognition process can directly be translated into an optical signal. With N-acetyl-N-dodecyl-4-trifluoroacetylaniline (ETH 6022) as the electrically neutral, lipophilized carrier ethanol can be determined from 0.5 to 35% (v/v) in aqueous solutions. The calibration curve for different ethanol-water mixtures shows a good correlation with the mathematically derived formalism and thus confirms the theoretically expected behavior. Besides high reproducibility of the optical signals, very short response times of less than 30 s were realized. The optode membrane presented exhibits a preference for ethanol compared to water by a factor greater than 11. The selectivities for several primary alcohols, such as methanol, ethanol, 1-propanol and 1-n-butanol, are comparable, but isopropanol and tert.-butanol are rejected by a factor of about 10. The alcohol concentration in different beverages was determined to evaluate the reliability of the system. The values obtained for wine, beer and different spirits show an excellent correlation with those obtained by a conventional approach involving distillation and density measurements. A residual standard deviation of ± 0.27% (v/v) over the 0.7–40% (v/v) range was found.     

The Total Synthesis of (±)-Isocomene by an Intramolecular Ene Reaction. Preliminary communication

The racemic sesquiterpene isocomene ( 1 ) has been synthesized starting from 1,7-octadien-3-one ( 2 ) in a stereoselective manner (Scheme 2). In the key step 4 → 5 the C(7), C(8)-bond was formed by an intramolecular thermal ene reaction. Further elaboration of 5 involved the ring contraction 6 → 7 , the elimination 8 → 9 and the final olefin isomerization 9 → 1 .     

Die Reaktionen von Eisen(III)-chlorid mit Trithiazylchlorid. Die Kristallstruktur von [S4N4Cl]+[FeCl4]⊖

Reactions of Iron Trichloride with Trithyazyl Chloride. Crystal Structure of [S₄N₄Cl]⁺[FeCl₄]^? Iron trichloride reacts with (NSCl)₃ yielding S₄N₄[FeCl₄]₂, S₃N₃Cl₂[FeCl₄] or S₄N₄Cl[FeCl₄], depending on the reaction conditions. The i.r. spectra prove the presence of [FeCl₄]^? ions for all three compounds. The ⁵⁷Fe-Mössbauer spectra show a slight quadrupole splitting at 80 K for S₃N₃Cl₂[FeCl₄] (ΔE^Q = 0.42 mm · s^?1) and S₄N₄Cl[FeCl₄] (ΔE^Q = 0.23 mm · s^?1), which indicates a slight deformation of the FeCl₄^? tetrahedra. The crystal structure of S₄N₄Cl[FeCl₄] was determined and refined with X-ray diffraction data (2549 independent reflexions, R = 0.026). S₄N₄Cl[FeCl₄] crystallizes in the triclinic space group P1 with two formula units per unit cell. The lattice constants are a = 712, b = 911, c = 1006 pm, α = 76.5°, β = 83.8° and γ = 80.5°. The structure consists of the so far unknown [S₄N₄Cl]^⊕ cations and slightly deformed FeCl₄^? ions. The [S₄N₄Cl]^⊕ ion consists of a S₄N₄ ring built up of two nearly planar S₃N₂ fragments having a dihedral angle of 136°. The average SN bond length is 157 pm, the SCI bond length 214 pm.     

Über die Konfiguration des Prolins im Ergotamin

It is well known that in the ergot alkaloids of the peptide type the proline appears in thel-configuration. Different methods of acid hydrolysis may lead to various cleavage products; hydrolysis by HCl yieldsd-proline, on the other hand hydrolytic cleavage by means of strongly acid cation exchange resin preserved the orginall-configuration.

---

---

Teilveröffentlichung der Dissertation vonH. Kolassa, Univ. Wien, 1973.     

Thermische Polymerisation von Acenaphthylen

Zusammenfassung Acenaphthylen wurde durch Anpolymerisation und zweifache Hochvakuumsublimation gereinigt. Die Reinigungsmethode wird ausführlich beschrieben.Bei verschiedenen Temperaturen wurde mit einer dilatometrischen Methode die thermische Bruttogeschwindigkeit gemessen. Zwischen 95 und 105 °C giltk _br=7,0₈·10¹⁰ exp (– 30,9 kcal/RT).Die beträchtliche Aktivierungsenergie der Bruttoreaktion ist sowohl auf eine große Aktivierungsenergie der thermischen Startreaktion als auch auf eine relativ hohe Wachstumsaktivierungsenergie zurückzuführen.Das Polymerisationsverhalten von Acenaphthylen kann vermutlich aufgrund seiner sterischen Eigenschaften erklärt werden.

---

Summary Acenaphthylene was purified by partial polymerisation, followed by double stage high vacuum sublimation. The method of purification is described in detail.The thermal overall rate was measured at different temperatures by a dilatometric method. Between 95 and 105 °C the following relation holds:k _th=7,0₈ · 10¹⁰ exp (– 30,9 kcal/RT).The considerable energy of activation of the overall reaction depends on a relatively high energy of activation of both the thermal initiation and the propagation reaction.It is supposed, that the polymerisation behaviour of acenaphthylene depends mainly on its steric properties.