Dielectric relaxation in the paracrystalline phase in polyacrylonitrile

Thermal expansion and dielectric relaxation of polyacrylonitrile were measured in the temperature range from ?75 to 152°C. at frequencies from 30 cps to 3 Mc./sec. The thermal expansion curve and the temperature dependence of logarithmic relaxation time both show an inflection at 85°C. An x-ray study by Bohn reveals that this inflection comes from the thermal expansion of the paracrystalline phase of this polymer, and consequently the transition at 85°C. and the associated relaxation are ascribed to molecular motion in the paracrystalline phase. The relaxation strength increases with increasing temperature above this point. The transition is caused by freezing of the bending vibration of chains whereas the relaxation results from rotational vibration. The length of segments in this phase is roughly estimated to be ca. 100 A. by comparing the observed relaxation strength with the theory developed on the basis of the above considerations.     

Structural studies of the carbon monoxide complex of [NiFe]hydrogenase from Desulfovibrio vulgaris Miyazaki F: suggestion for the initial activation site for dihydrogen

The carbon monoxide complex of [NiFe]hydrogenase from Desulfovibrio vulgaris Miyazaki F has been characterized by X-ray crystallography and absorption and resonance Raman spectroscopy. Nine crystal structures of the [NiFe]hydrogenase in the CO-bound and CO-liberated forms were determined at 1.2-1.4 A resolution. The exogenously added CO was assigned to be bound to the Ni atom at the Ni-Fe active site. The CO was not replaced with H(2) in the dark at 100 K, but was liberated by illumination with a strong white light. The Ni-C distances and Ni-C-O angles were about 1.77 A and 160 degrees, respectively, except for one case (1.72 A and 135 degrees ), in which an additional electron density peak between the CO and Sgamma(Cys546) was recognized. Distinct changes were observed in the electron density distribution of the Ni and Sgamma(Cys546) atoms between the CO-bound and CO-liberated structures for all the crystals tested. The novel structural features found near the Ni and Sgamma(Cys546) atoms suggest that these two atoms at the Ni-Fe active site play a role during the initial H(2)-binding process. Anaerobic addition of CO to dithionite-reduced [NiFe]hydrogenase led to a new absorption band at about 470 nm ( approximately 3000 M(-1)cm(-1)). Resonance Raman spectra (excitation at 476.5 nm) of the CO complex revealed CO-isotope-sensitive bands at 375/393 and 430 cm(-1) (368 and 413 cm(-1) for (13)C(18)O). The frequencies and relative intensities of the CO-related Raman bands indicated that the exogenous CO is bound to the Ni atom with a bent Ni-C-O structure in solution, in agreement with the refined structure determined by X-ray crystallography.     

Ferrocene-containing polymers. I. Radiation-induced polymerization of ferrocenylmethyl methacrylate

γ-Ray-induced polymerizations of ferrocenylmethyl methacrylate (FMMA) in crystalline and amorphous states were investigated with kinetical and ESR methods. In the crystalline state the polymerization of FMMA proceeded slowly and gave low-molecular-weight polymers, whereas in the amorphous state it proceeded rapidly and gave polymers of much higher molecular weight. Molecular weight distributions of these polymers were binodal. The temperature dependence and the dose-rate dependence of the polymerization rates were different between the two states. Wide-line nuclear magnetic resonance (NMR) spectra of the amorphous monomer suggested that the polymerization proceeded in a supercooled state. Electron spin resonance (ESR) spectra of γ-irradiated FMMA and 1,1′-ferrocenyl-di(methyl methacrylate) showed that ferrocene radicals and methacrylic radicals were formed simultaneously at low temperature; with increasing temperature the former radicals disappeared, whereas the latter changed into growing chain radicals. The yields of radicals were relatively low; this means that ferrocene groups in the monomers behave as a radiation energy absorber.     

Purification and characterization of recombinant murine endostatin in E. coli

Endostatin, a carboxyl-terminal fragment of collagen XVIII is known as an anti-angiogenic agent, that specifically inhibits the proliferation of endothelial cell and the growth of several primary tumor. We report here the purification and characterization of the recombinant murine endostatin (rmEndostatin) which was expressed in a prokaryotic expression system. This rmEndostatin has similar physiochemical properties of yeast-produced recombinant endostatin, and it also specifically inhibits the proliferation and migration of bovine capillary endothelial cells stimulated by basic fibroblast growth factor. The biological activity of rmEndostatin was also shown by its anti-angiogenic ability on the chorioallantoic membrane of chick embryo in vivo. In this article, we demonstrate the refolding and purification of rmEndostatin, expressed using E. coli system, to a biologically active and soluble form. In addition, these results confirm the activity of endostatin as a potent anti-angiogenic agent.     

RECENT PROGRESS OF NANO-MECHANICAL MAPPING

 Nano-mechanical mapping by atomic force microscopy has been developed as an useful application to measure mechanical properties of soft materials at nanometer scale. To date, the Hertzian theory was used for analyzing force-distance curves as the simplest model among several contact mechanics between elastic bodies. However, the preexisting methods based on this theory do not consider the adhesive interaction in principle, which cannot be neglected in the ambient condition. A new analytical method was introduced to estimate the elasticity and the adhesive energy simultaneously by means of the JKR theory, describing adhesive contact between elastic materials. Poly(dimethylsiloxane) (PDMS) and isobutylene-co-isoprene rubber (IIR) were analyzed to verify the applicable limit of the JKR analysis. For elastic samples such as PDMS, the force-deformation plots obtained experimentally were consistent with JKR theoretical curves. Meanwhile, for viscoelastic samples, especially for IIR, the experimental plots revealed large deviations from JKR curves depending on scanning velocity and maximum loading force. Some nano-rheological arguments were employed based on the difference between these specimens.     

A novel method for preparation of 2-(methyl- or phehnylthio)alkanoic esters

Ethyl 2-acetylalkanoate gave ethyl 2-(methyl- or phenylthio)alkanoate in high yield on treatment wiht CH₃SSO₂CH₃, PhSSO₂Ph, or PhSSPh in the presence of small excess of EtONa in EtOH. Application of the present method to synthesis of pellitorine and the queen substance is also described.     

Computer simulation for the cooligomerization system

In order to clarify the kinetic features of the styrene (A)–methyl methacrylate (B)–CCl₄(S) cooligomerization system, a computer simulation was carried out. The experimental data on the degree of polymerization and the deviation of the cooligomer composition from the statistical steady-state composition were comparatively well explained by calculations based on the kinetic equations derived from the assumed reaction scheme and the values of the velocity coefficients, although the values of the four velocity coefficients in the initiation step and the velocity coefficient of the termination by the coupling of two solvent radicals were estimated. The results of the calculation of the rate of each component reaction show that the following two reactions are the most important in the initiation and in the transfer and termination steps when the [S]/([A] + [B]) ratio is large: where, A, A*, and P are styrene, polystyryl radical, and the cooligomer, respectively. Moreover, it was concluded that the deviation of the cooligomer composition from the statistical steady-state composition was caused by these two reactions.     

Protective effects of small amounts of bis(2-ethylhexyl)sulfosuccinate on the helical structures of human and bovine serum albumins in their thermal denaturations

The protective effect of an anionic double-tailed surfactant, sodium bis(2-ethylhexyl)sulfosuccinate (AOT), on the structures of human serum albumin (HSA) and bovine serum albumin (BSA) in their thermal denaturations was examined by means of circular dichroism measurements. The structural changes of these albumins were reversible in the thermal denaturation below 50 degrees C, but became partially irreversible above this temperature. The effect was observed in the thermal denaturation above 50 degrees C. Although the helicity of HSA decreased from 66% to 44% at 65 degrees C in the absence of the surfactant, the decrement of it was restrained in the coexistence of AOT of extremely low concentrations. When the HSA concentration was 10 muM, the maximal protective effect appeared at 0.15 mM AOT. In the coexistence of the surfactant of this concentration, the helicity was maintained at 58% at 65 degrees C, increasing to the original value upon cooling to 25 degrees C. Beyond 0.15 mM AOT, the helicity sharply decreased until 3 mM AOT. A particular AOT concentration required to induce the maximal protective effect ([AOT]REQ) was examined at different HSA concentrations. [AOT]REQ shifted to higher values with an increase of the protein concentration. From the protein concentration dependences of [AOT]REQ, the maximal protection was estimated to require 8.0 and 5.0 AOT ions per a molecule of HSA and BSA, respectively. The AOT concentration, where the protective effect was observed, was too low to form its micelle-like aggregate. Then the protein structures might be stabilized by a cross-linking of surfactant monomers bound to specific sites. These specific sites might exist between a group of nonpolar residues and a positively charged residue located on several sets of amphiphilic helical rods in the proteins. Such a unique function of the double-tailed ionic surfactant is first presented by its characteristic nature as an amphiphilic material.     

Polymerization of allyl esters of unsaturated acids. VII. Copolymerization of methyl allyl maleate and fumarate with styrene

Radical copolymerizations of methyl allyl maleate (MAM) and methyl allyl fumarate (MAF) with styrene (St) are carried out in bulk using AIBN as an initiator at 60°C, and their copolymerization behaviors are compared in detail. The different rate features are observed with each other; thus in the MAF-St copolymerization the rate was quite enhanced and, also, the maximum rate was found at the molar ratio of 1:1 in the monomer feed, whereas no maximum phenomenon of the rate was apparent for the MAM—St copolymerization. The copolymerizability of MAF with St was quite high, whereas that of MAM was very poor. The cyclization of MAM or MAF was hindered by the highly reactive St monomer. These results are discussed in terms of the formation of the charge—transfer complex between MAF and St and, furthermore, the cyclocopolymerization kinetics involving the 17 elementary reactions as the propagation reactions.     

Synthesis of thermally crosslinkable fluorine‐containing poly(arylene ether ketone)s—II. Propargyl ether terminated poly(arylene ether ketone)s

Novel thermally crosslinkable fluorine‐containing poly(arylene ether ketone)s comprised of 2,3,5, 6‐tetrafluoro‐1,4‐phenylene moiety were synthesized by the termination of polymer chain ends with propargyl ether groups in order to improve solvent resistance. Crosslinking reaction occurred over 250°C through the formation of both chromen ring and polyene structure. This structure change brought about not only the outstanding solvent resistance but also the increase in glass transition temperature (T_g). The cured films also exhibited excellent thermal stability, transparency and hydrophobicity derived from fluorine atoms. Copyright © 2004 John Wiley & Sons, Ltd.