Pressure-induced effects in the heterogeneous adsorption of insulin on chromatographic surfaces

The effect of increasing the average column pressure (ACP) on the heterogeneous adsorption of insulin variants on a C18-bonded silica was studied in isocratic reversed-phase HPLC. Adsorption isotherm data of lispro and porcine insulin obtained for values of the ACP ranging from 57 to 237 bar were fitted to the Langmuir-Freundlich and the Tóth equation. The resulting isotherm parameters, including the equilibrium adsorption constant and the heterogeneity index, were next used for the calculation of distribution functions characterizing the energy of interactions between the adsorbed insulin molecules and the stationary phase. It was observed that increasing the pressure by 180 bar causes a broadening of the distribution functions and a shift of the position of their maximum toward lower interaction energies. These findings suggest that, under high pressures, the insulin molecules interact with the stationary phase in a more diversified way than under low pressures. Additionally, the most probable value of the energy of the insulin-surface interactions becomes lower when the ACP increases. The pressure-induced changes in the interaction of insulin variants with the hydrophobic surface are attributed to a possible conformational flexibility of the molecular structure of this protein.     

Influence of camphorsulfonic acid in nitroxide‐mediated styrene miniemulsion polymerization

The rate‐accelerating effects of camphorsulfonic acid (CSA) on nitroxide‐mediated styrene miniemulsion polymerization were studied. Polymerizations were initiated with benzoyl peroxide (BPO) as an initiator and mediated with either 2,2,6,6‐tetramethylpiperidinyloxy (TEMPO) or 4‐hydroxy‐2,2,6,6‐tetramethylpiperidinyloxy (OH‐TEMPO). Although CSA has been used to accelerate the rate in bulk nitroxide‐mediated polymerizations, it has not been well studied in emulsion/miniemulsion. With dispersed systems, the effectiveness of CSA is likely to be affected by partitioning between the aqueous and organic phases. In styrene miniemulsion experiments performed over a range of conditions, the effect of adding CSA varied from negligible to significantly increasing the final conversion and molecular weight, depending on the nitroxide:BPO ratio. At a ratio of nitroxide:BPO = 1.7, the effect of CSA addition is small, whereas the final conversion and molecular weight are dramatically enhanced by CSA addition when the nitroxide:BPO ratio is 3.6. CSA is most effective in enhancing the rate and molecular weight when the initial free‐nitroxide concentration is higher. The magnitude of the rate and molecular weight enhancement was similar for TEMPO and OH‐TEMPO despite their differences in water solubility. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 40: 2828–2841, 2002     

A new route to vinyltributyltin compounds by flash pyrolysis of alkyltributyltin acetates

Flash pyrolysis of alkyltributyltin acetates, at high temperatures (600–850° C) under a moderate vacuum provides a convenient route to vinyltin derivatives.     

Contactless conductivity detection of synthetic polymers in non-aqueous size-exclusion electrokinetic chromatography

A capacitively coupled contactless conductivity detection (CCD) system has been applied for the detection of neutral synthetic polymers in capillary size-exclusion electrokinetic chromatography (SEEC). Polystyrene standards, that were used as a model compounds, were separated on a capillary column packed with porous 10 microm silica particles with an electrokinetically driven mobile phase, and detected by CCD and UV detection simultaneously. Mass-calibration curves for polystyrene were constructed. Satisfactory results were obtained for the linearity, the run-to-run repeatability (<0.2% for the relative retention and <4% for the peak area) and the robustness of the detector. One of the major issues in this preliminary study was to investigate the origin of the peaks observed for the polystyrene standards. The effect of the molar mass of the polystyrenes on the sensitivity was small. Therefore, the signals obtained could not be explained as the result of an increased viscosity and a decreased solution conductivity of the solute zone. An alternative hypothesis is suggested, and recommendations for further research are given.     

Improved model of multicomponent adsorption in reversed-phase liquid chromatography

This work presents a modification to the real adsorbed solution model using a Flory-Huggins type of expression that was reported previously. This modification consists in replacing the Flory-Huggins activity coefficient by the spreading pressure dependent approach. This new model takes into account explicitly the adsorbate-adsorbate interactions taking place in the adsorbed phase. It provides an excellent prediction of the competitive, ternary adsorption equilibrium of benzyl alcohol, 2-phenylethanol and 2-methyl benzyl alcohol observed in a reversed-phase liquid chromatographic system using information merely derived from the single-component adsorption experimental data.     

Vacancy ion-exclusion chromatography of aromatic carboxylic acids on a weakly acidic cation-exchange resin

Determination of aromatic carboxylic acids by conventional ion-exclusion chromatography is relatively difficult and methods generally rely on hydrophobic interaction between the solute and the resin. To overcome the difficulties in determining aromatic carboxylic acids a new approach is presented, termed vacancy ion-exclusion chromatography, which is based on use of the sample as mobile phase and an injection of aqueous 10% methanol onto a weakly acidic cation-exchange column (TSKgel OApak-A). Highly sensitive conductivity detection occurred with sharp and well-shaped peaks, leading to very efficient separations. The effects of sulfuric acid concentration added to the mobile phase, flow-rate, and column temperature on the retention volume of tested aromatic carboxylic acids was investigated. Retention times were found to be affected by the concentration of the analytes in the mobile phase and to some extent also by the addition of an organic modifier such as methanol to the injected water sample. Separation of sulfuric acid (SA), naphthalenetetracarboxylic acid (NTCA), phthalic acid (PA) and benzoic acid (BA) was satisfactory using this new approach. Detection limits were 0.66, 0.67, 0.42 and 0.86 microM and detector responses were linear in the range 1-100, 1-80, 2.5-100 and 10-40 microM, for SA, NTCA, PA and BA, respectively. Precision for retention times was 0.36% and for peak areas was 1.5%.     

Spectroscopic investigation of ground state pyrrole (C4H5N): the NH stretch

We have recorded the infrared absorption spectrum of pyrrole at 0.005 cm⁻¹ spectral resolution using a Fourier transform interferometer. The rotational analysis of the fundamental N---H stretch (1¹₀) at 3530.811343(82) cm⁻¹ was performed. A set of 13 upper state rovibrational parameters was determined, allowing the 2715 assigned rovibrational lines to be reproduced with a standard deviation of 1.3 10⁻³ cm⁻¹. An attempt to record the fundamental band under slit-jet conditions is reported. The role of hot bands accompanying the series of the N---H stretch excitation is investigated. Effective vibrational parameters — ω⁰₁, X⁰₁₁, Y₁₁₁, X_1,24 — are obtained. The lower level in the hot band series is unambiguously identified as the V₂₄ = 1 level, by retrieving X_1,24 independently, from other spectral data. The observation of the complex band pattern accompanying the N---H series in the higher overtone range is discussed with the help of new data, recorded around the 1⁵₀ band at different temperatures using intracavity laser optoacoustic spectroscopy.     

Preparation and characterization of p-tert-butylcalix[8]arene bonded capillaries for open-tubular capillary electrochromatography

p-tert-Butylcalix[8]arene bonded capillaries for open-tubular capillary electrochromatography were prepared with γ-glycidoxypropyltrimethoxysilane as a bridge. The bonded capillary displayed low and steady electroosmotic flow (EOF) values over the pH range from 4 to 9. Detection limits for direct spectrophotometric detection at 277 nm for benzenediols (at a signal to noise ratio of 2) were 0.96 mg l⁻¹ for the unbonded capillary and 1.48 mg l⁻¹ for the bonded capillary, showing that the bonded layer did not show significant absorbance and hence decreased sensitivity. The bonded capillaries showed good separation selectivity for o-, m- and p-benzenediols, α- and β-naphthols, and α- and β-naphthylamines. This selectivity was attributed to significant interactions between the analytes and the bonded p-tert-butylcalix[8]arene, which contributed to the electrochromatographic separation mechanism. The bonded capillaries gave high stability and reproducibility.     

Microphase separation of cationic poly(N-isopropylacrylamide) copolymers in water: Effect of the migration of charges

The structures of aqueous copolymer solutions have been examined through small angle neutron scattering. The copolymers contained mostly N-isopropylacrylamide (NIPAM) monomers. Poly (NIPAM) solutions have a lower critical solution temperature (LCST), above which the macromolecules separate from water. A small fraction of ionizable N,N-[(dimethylamino) propyl] methacrylamide (MADAP) monomers was introduced into the macromolecules. This had dramatic consequences on the solution behavior at temperatures above the LCST of PNIPAM, where phase separation would have been expected for the homopolymer. When all MADAP monomers were ionized, it was found that the solutions resisted the phase separation. At short spatial scales, the chains were collapsed but at large scales they formed branched aggregates that did not separate out of water. When only half of the MADAP monomers are ionized, the electrical charges were able to redistribute themselves along the chains. In this case, the rise in temperature caused a microphase separation where the electrical charges were relocated on a fraction of the chains that remained in solution.The other chains (or section of chains) formed large nodules of a polymer rich phase.     

Investigations on the behaviour of acidic, basic and neutral compounds in capillary electrochromatography on a mixed-mode stationary phase

This work describes the separation of acidic, basic and neutral organic compounds as well as inorganic anions in a single run by capillary electrochromatography employing a stationary phase which exhibits both strong anion-exchange and reversed-phase chromatographic characteristics. The positive surface charge of this stationary phase provided a substantial anodic electroosmotic flow. The analytes were separated by a mixed-mode mechanism which comprised chromatographic interactions (hydrophobic interactions, ion-exchange) as well as electrophoretic migration. The influence of ion-exchange and hydrophobic interactions on the retention/migration of the analytes could be manipulated by varying the concentration of a competing ion and/or the amount of organic modifier present in the background electrolyte. Additionally the effects of pH changes on both the chromatographic interactions as well as the electrophoretic migration of the analytes were investigated.