Photoinduced carbon monoxide migration in a synthetic heme-copper complex

Time-resolved infrared (TRIR) flash photolytic techniques have been employed to initiate and observe the efficient dissociation of CO from a synthetic heme-CO/copper complex, [((6)L)Fe(II)(CO)..Cu(I)](+) (2), in CH(3)CN and acetone at room temperature. In CH(3)CN, a significant fraction of the photodissociated CO molecules transiently bind to copper (nu(CO)(Cu) = 2091 cm(-)(1)) giving [((6)L)Fe(II)..Cu(I)(CO)](+) (4), with an observed rate constant, k(1) = 1.5 x 10(5) s(-)(1). That is followed by a slower direct transfer of CO from the copper moiety back to the heme (nu(CO)(Fe) = 1975 cm(-)(1)) with k(2) = 1600 s(-)(1). Additional transient absorption (TA) UV-vis spectroscopic experiments have been performed monitoring the CO-transfer reaction by following the Soret band. Eyring analysis of the temperature-dependent data yields DeltaH(double dagger) = 43.9 kJ mol(-)(1) for the 4-to-2 transformation, similar to that for CO dissociation from [Cu(I)(tmpa)(CO)](+) in CH(3)CN (DeltaH(double dagger) = 43.6 kJ mol(-)(1)), suggesting CO dissociation from copper regulates the binding of small molecules to the heme within [((6)L)Fe(II)..Cu(I)](+)(3). Our observations are analagous to those observed for the heme(a3)/Cu(B) active site of cytochrome c oxidase, where photodissociated CO from the heme(a3) site immediately (ps) transfers to Cu(B) followed by millisecond transfer back to the heme.     

Efficient photodissociation of O2 from synthetic heme and heme/M (M = Fe, Cu) complexes

Single wavelength excitation (lambdaex = 355 or 532 nm) of low-temperature stabilized (198 K) synthetic heme-dioxygen and heme-dioxygen/M complexes, where M = copper or iron in a non-heme environment, results in the dissociation of dioxygen as indicated by the generation of the ferrous heme (Soret band, 427 nm) and the bleaching of the ferric-superoxide (FeIII(O2-)) 410-nm Soret band in the transient absorption difference spectrum. Dioxygen rebinds to the four heme complexes studied with comparable rate constants ( approximately 6-9 x 105 M-1 s-1). However, the quantum yield for complete dissociation of O2 from our simplest heme-O2 complex (F8)FeIII(O2-) (phi = 0.60) is higher than the other complexes measured (phi = approximately 0.2-0.3) as well as that for oxy-myoglobin (phi = 0.3).     

Polymerization of ethylene catalyzed by diethylaluminum chloride and titanium (III) acetylacetonate

Catalysts for the polymerization of ethylene were prepared from titanium (III) acetylacetonate and diethylaluminum chloride. Titanium (III) acetylacetonate is of interest because it is soluble in hydrocarbon solvents used as polymerization media. As its oxidation product oxobisacetylacetonatotitanium (IV) is also hydrocarbon-soluble, this system provides a vehicle for studying the effects of a change in valence on catalyst activity without an accompanying change of state, as occurs with titanium halides. Relatively high molar ratios (>20:1) of aluminum alkyl to titanium compound were required to give active catalysts. Precipitates generally formed in the catalyst mixtures, although dilute catalyst solutions in which no precipitate was visible still initiated polymerization. Catalyst mixtures were observed to undergo certain changes on standing. Light-scattering studies indicated an increase in catalyst particle size, and a gas identified as ethane was evolved. These changes were accompanied by a reduction in activity of the catalyst. Parallel polymerization tests were run for a comparison of catalysts prepared from titanium(III) acetylacetonate and catalysts prepared from oxobisacetylacetonatotitanium(IV). There was essentially no difference in yield or properties of polymer prepared using the two catalyst systems. The evidence suggests that both the trivalent and tetravalent titanium compounds yield the same catalytic intermediate when reacting with diethylaluminum chloride.     

Pionic Kα X-ray energy and linewidth IN 20Ne and 22Ne

We have measured the energies and linewidths of the pionic K_α X-rays for ²⁰Ne and ²²Ne using a natural liquid-neon target. The results are

     

70.

Boden     

Th. Arnd  Kühne  Sven Odén  U. Pratolongo  Th. Schloesing  E. W. Hilgard  G. Richter  A. Atterberg  J. König  J. Hasenbäumer  O. Kleine-Möllhof  D. J. Hissink  M. L. Plonski  Ch. J. Moore  W. H. Fry  H. E. Middleton  J. B. Rather  O. Lemmermann  L. Fresenius  L. J. Gillespie  L. E. Wise  N. M. Comber  Ch. Brioux  E. A. Fisher  Neuman  O. Nolte 《Analytical and bioanalytical chemistry》1924,64(5-6):241-248

     

[首页] « 上一页 [2] [3] [4] [5] [6] 7 [8] [9] [10] [11] [12] 下一页 » 末  页»

20Ne	22Ne
Neenergy (keV)	239.12±0.14	230.49±0.88
width (keV)	15.43±0.41	12.65±3.51