Reissert compound studies. Cyclization of N-(ω-chloroalkanoyl)reissert compounds

Treatment of 2-(4-chlorobutanoyl)- and 2-(5-chloropentanoyl)-1, 2-dihydroisoquinaldonitrile with sodium hydride gave rise to tricyclic benzoquinolizone and azepino[1,2-α]isoquinoline derivatives. A similar reaction was observed in the quinoline series. Several reactions of 1,2,3,4-tetrahydro-4-oxo-11bH-benzo[α]quinolizine-11b-carbonitrile are reported.     

Reactions of Ru3(CO)12 with Diphosphenes — A New Route to 50‐Electron Ru3P2 nido‐Clusters

The reaction of the symmetric diphosphene 2, 4, 6‐(CF₃)₃‐C₆H₂‐P=P‐C₆H₂‐2, 4, 6‐(CF₃)₃ 4 with Ru₃(CO)₁₂ led to the 50‐electron Ru₃P₂ nido‐cluster Ru₃(CO)₉[μ‐P‐C₆H₂‐2, 4, 6‐(CF₃)₃]₂ 5 , which in solution at room temperature displays hindered rotation of the aromatic rings about the C(aryl)—P bonds. The structure of 5 was determined by X‐ray crystal structure analysis; its Ru₃P₂ centre forms a distorted square pyramid with one ruthenium atom at the apex. One of the two C₆H₂(CF₃)₃ groups is also appreciably distorted. Temperature‐dependent ¹⁹F NMR studies of the [A₃M₃X]₂ spin system (A = M = CF₃, X = ³¹P) of 5 indicated a rotational barrier ΔG^≠ of 82.3 kJ mol^‐1 at 141 °C. The same Ru₃P₂ core was obtained by the reaction of the unsymmetric diphosphene Mes*‐P=P‐Mes 11 with Ru₃(CO)₁₂; hindered rotation about the C(aryl)—P bonds was also observed, in this case.     

Ion excitation in a linear quadrupole ion trap with an added octopole field

Modeling of ion motion and experimental investigations of ion excitation in a linear quadrupole trap with a 4% added octopole field are described. The results are compared with those obtained with a conventional round rod set. Motion in the effective potential of the rod set can explain many of the observed phenomena. The frequencies of ion oscillation in the x and y directions shift with amplitude in opposite directions as the amplitudes of oscillation increase. Excitation profiles for ion fragmentation become asymmetric and in some cases show bistable behavior where the amplitude of oscillation suddenly jumps between high and low values with very small changes in excitation frequency. Experiments show these effects. Ions are injected into a linear trap, stored, isolated, excited for MS/MS, and then mass analyzed in a time-of-flight mass analyzer. Frequency shifts between the x and y motions are observed, and in some cases asymmetric excitation profiles and bistable behavior are observed. Higher MS/MS efficiencies are expected when an octopole field is added. MS/MS efficiencies (N(2) collision gas) have been measured for a conventional quadrupole rod set and a linear ion trap with a 4% added octopole field. Efficiencies are chemical compound dependent, but when an octopole field is added, efficiencies can be substantially higher than with a conventional rod set, particularly at pressures of 1.4 x 10(-4) torr or less.     

Simulation of 59Co NMR chemical shifts in aqueous solution

59Co chemical shifts were computed at the GIAO-B3LYP level for [Co(CN)6]3-, [Co(H2O)6]3+, [Co(NH3)6]3+, and [Co(CO)4]- in water. The aqueous solutions were modeled by Car-Parrinello molecular dynamics (CPMD) simulations, or by propagation on a hybrid quantum-mechanical/molecular-mechanical Born-Oppenheimer surface (QM/MM-BOMD). Mean absolute deviations from experiment obtained with these methods are on the order of 400 and 600 ppm, respectively, over a total delta(59Co) range of about 18,000 ppm. The effect of the solvent on delta(59Co) is mostly indirect, resulting primarily from substantial metal-ligand bond contractions on going from the gas phase to the bulk. The simulated solvent effects on geometries and delta(59Co) values are well reproduced by using a polarizable continuum model (PCM), based on optimization and perturbational evaluation of quantum-mechanical zero-point corrections.     

From anisole to 1,2,4,5‐tetramethoxybenzene: Theoretical study of the factors that determine the conformation of methoxy groups on a benzene ring

Unhindered ortho‐dimethoxy‐substituted phenyl rings often display a coplanar conformation. A theoretical study of a series of methoxybenzenes consisting of methoxybenzene (anisole), the three dimethoxybenzenes, and 1,2,4,5‐tetramethoxybenzene, at the DFT/B3LYP/6‐311++G** level of theory, allows us to identify the factors influencing the conformational preference and attribute the coplanarity of such methoxy groups to mesomeric effects. © 2006 Wiley Periodicals, Inc. Int J Quantum Chem, 2007     

Acrylonitrile polymerization by Cy3PCuMe and (Bipy)2FeEt2

Cy(3)PCuMe (1) undergoes reversible ligand redistribution at low temperature in solution to form the tight ion pair [Cu(PCy(3))(2)][CuMe(2)] (3). The structure of 3 was assigned on the basis of (i) the stoichiometry of the 1 = 3 equilibrium, (ii) the observation of a triplet for the PCy(3) C1 (13)C NMR resonance due to virtual coupling to two (31)P nuclei, and (iii) reverse synthesis of 1 by combining separately generated Cu(PCy(3))(2)(+) and CuMe(2)(-) ions. Complex 1 and [Cu(PCy(3))(2)][PF(6)] (5) coordinate additional PCy(3) to form (Cy(3)P)(2)CuMe and [Cu(PCy(3))(3)][PF(6)], respectively, while 3 does not. Complex 1, free PCy(3), and (bipy)(2)FeEt(2) (2) each initiate the polymerization of acrylonitrile. In each case, the polyacrylonitrile contains branches that are characteristic of an anionic polymerization mechanism. The major initiator in acrylonitrile polymerization by 1 is PCy(3), which is liberated from 1. A transient iron hydride complex is proposed to initiate acrylonitrile polymerization by 2.     

Isolation and purification of inflacoumarin A and licochalcone A from licorice by high-speed counter-current chromatography

High-speed counter-current chromatography (HSCCC) technique in semi-preparative scale has been applied to isolate and purify bioactive flavone compounds from the ethanol extract of Glycyrrhiza inflata Bat., a particular plant species of licorice. HSCCC separation was performed with a two-phase solvent system composed of n-hexane-chloroform-methanol-water (5:6:3:2, v/v) by eluting the lower mobile phase at a flow rate of 1.8 ml/min and a revolution speed of 800 rpm. Purification was performed with a two-phase solvent system composed of n-hexane-chloroform-methanol-water (1.5:6:3:2, v/v) by eluting the lower mobile phase at a flow-rate of 1.5 ml/min and a revolution speed of 800 rpm. Two major flavone peaks: inflacoumarin A and licochalcone A were collected and the respective yields of the peaks amount to 6 mg (8.6%, w/w) and 8 mg (11.4%, w/w) from 70 mg of the crude extract sample. The purities of inflacoumarin A and licochalcone A reached 99.6% and 99.1%, respectively, after a sequential purification run. The structures of inflacoumarin A and licochalcone A were positively confirmed by 1H NMR and 13C NMR, 1H-13C-COSY, UV, FT-IR and electron ionization MS analyses.     

Screening,library-assisted identification and validated quantification of fifteen neuroleptics and three of their metabolites in plasma by liquid chromatography/mass spectrometry with atmospheric pressure chemical ionization

A liquid chromatographic/mass spectrometric assay with atmospheric pressure chemical ionization (APCI-LC/MS) is presented for the fast and reliable screening and identification and for the precise and sensitive quantification of 15 neuroleptic (antipsychotic) drugs and three of their relevant metabolites in plasma. It allows confirmation of the diagnosis of a neuroleptic overdose and monitoring of psychiatric patients' compliance. The neuroleptics amisulpride, bromperidol, clozapine, droperidol, flupenthixol, fluphenazine, haloperidol, melperone, olanzapine, perazine, pimozide, risperidone, sulpiride, zotepine and zuclopenthixol and the pharmacologically active metabolites norclozapine, clozapine N-oxide and 9-hydroxyrisperidone were extracted from plasma using solid-phase extraction and were separated on a Merck LiChroCART column with Superspher 60 RP Select B as the stationary phase. Gradient elution was performed using aqueous ammonium formate and acetonitrile. After screening and identification in the scan mode using the authors' new LC/MS library, the neuroleptics were quantified in the selected-ion mode. The quantification assay was fully validated. It was found to be selective and proved to be linear from sub-therapeutic to over therapeutic concentrations for all analytes. The corresponding reference levels are listed. The accuracy and precision data were within the required limits. The analytes were stable in frozen plasma for at least 1 month. The method was successfully applied to several authentic plasma samples from patients treated or intoxicated with various neuroleptics. The validated LC/MS assay has proved to be appropriate for the isolation, separation, screening, identification and quantification of various neuroleptics in plasma for clinical toxicology and therapeutic drug monitoring purposes.     

Fe3O4-LiMo3Se3 nanoparticle clusters as superparamagnetic nanocompasses

A scaleable chemical approach to functional nanoscale analogues of the magnetic compasses in magnetotactic bacteria is described. LiMo(3)Se(3)-Fe(3)O(4) nanowire-nanoparticle composites were synthesized by a reaction of 3-iodopropionic acid treated LiMo(3)Se(3) nanowire bundles with oleic acid-stabilized Fe(3)O(4) nanoparticles of 2.8, 5.3, and 12.5 nm size in tetrahydrofuran. Transmission electron micrographs show that the composite consists of Fe(3)O(4) nanoparticles attached to the surfaces of the 4-6 nm thick nanowire bundles. UV/vis spectra reveal absorptions from the nanowire (506 nm) and magnetite components (280-450 nm), and IR spectra show characteristic bands for the propionic acid linkers and for the residual oleic acid ligands on the magnetite particles. In the presence of excess oleic acid, the nanocomposites undergo rapid disassembly, suggesting that Fe(3)O(4) nanoparticles are bonded to nanowires via carboxylate groups from the linkers. Ultrasonication of a dispersion of the composite in THF produces individual LiMo(3)Se(3)-Fe(3)O(4) clusters, which are 340 +/- 107 nm long and 20 +/- 5 nm thick, depending on the sonication time and Fe(3)O(4) nanoparticle size. Field cooled and zero-field cooled magnetization measurements reveal that the blocking temperature (T(B) = 100 K) of the clusters with 5.3 nm Fe(3)O(4) is increased as compared to the free nanoparticles (T(B) = 30 K). Directional dipolar interactions in the clusters lead to magnetic anisotropy, which makes it possible to align the clusters in a magnetic field (900 Oe).     

Determination of Mn,Fe, Cu,Zn, and Pb in particulate matter,raw and final materials of a brick factory by radionuclide X-ray fluorescence analysis

Radionuclide X-ray fluorescence method with a Si/Li semiconductor detector and²³⁸Pn exciting source was used in the study of Mn, Fe, Cu, Zn, and Pb content of solid emissions, raw and final materials of a brick factory. From the point of view of metal content, the working environment of the brick factory is safe for workers.