3. Biochemische und klinische Analyse

Ohne Zusammenfassung     

Automatic coulometric titration with photometric end-point detection : Part I. A coulometric titrator based on differential photometric detection

A system for automatic coulometric titrations with photometric end-point detection is described. To compensate for errors caused by gas bubbles and turbidity, the beam is split after passing the titration cell. The intensities of the respective light beams are registered by means of two photodiodes operating in the current mode. The currents are converted to voltages and the logarithm of the quotient is taken. The measured absorbance is only slightly dependent on the variation in the intensity of the incident light. A diminution of one absorbance unit causes a relative error of less than 5%. The deviations due to carbon particles (37–75 μm) were less than 0.002 absorbance units per mg of carbon present in 10 ml of solution. The improvement with respect to errors caused by gas bubbles is illustrated. The fundamental advantage of a one-lamp system over a twolamp system is shown.     

Determination of the light-induced degradation rate of the solar cell sensitizer N719 on TiO2 nanocrystalline particles

The oxidative degradation rate, kdeg, of the solar cell dye (Bu4N+)2[Ru(dcbpyH)2(NCS)2]2-, referred to as N719 or [RuL2(NCS)2], was obtained by applying a simple model system. Colloidal solutions of N719-dyed TiO2 particles in acetonitrile were irradiated with 532-nm monochromatic light, and the sum of the quantum yields for the oxidative degradation products [RuL2(CN)2], [RuL2(NCS)(CN)], and [RuL2(NCS)(ACN)], Phideg, was obtained at eight different light intensities in the range of 0.1-16.30 mW/cm2 by LC-UV-MS. The Phideg values decreased from 3.3 x 10-3 to 2.0 x 10-4 in the applied intensity range. By using the relation kdeg = Phidegkback and back electron-transfer reaction rates, kback, obtained with photoinduced absorption spectroscopy, it was possible to calculate an average value for the oxidative degradation rate of N719 dye attached to TiO2 particles, kdeg = 4.0 x 10-2 s-1. The stability of N719 dye during solar cell operation was discussed based on this number, and on values of the electron-transfer rate between [Ru(III)L2(NCS)2] and iodide ion that are available in the literature.     

Generalized anisotropic scaling theory and the transverse meissner transition

We consider a depinning transition in vortex systems with columnar disorder and tilted applied magnetic fields. From scaling arguments and Monte Carlo simulations, we find that this transverse Meissner transition is governed by a fixed point which is anisotropic in all three directions. This generalization of conventional anisotropic scaling means that the correlation length in different directions diverges with different rates, and we derive exact results for the anisotropy exponents. We make predictions which can be tested in experiments on superconductors with columnar disorder.     

Lip kinematics in long and short stop and fricative consonants

This paper examines lip and jaw kinematics in the production of labial stop and fricative consonants where the duration of the oral closure/constriction is varied for linguistic purposes. The subjects were speakers of Japanese and Swedish, two languages that have a contrast between short and long consonants. Lip and jaw movements were recorded using a magnetometer system. Based on earlier work showing that the lips are moving at a high velocity at the oral closure, it was hypothesized that speakers could control closure/constriction duration by varying the position of a virtual target for the lips. According to this hypothesis, the peak vertical position of the lower lip during the oral closure/constriction should be higher for the long than for the short consonants. This would result in the lips staying in contact for a longer period. The results show that this is the case for the Japanese subjects and one Swedish subject who produced non-overlapping distributions of closure/ constriction duration for the two categories. However, the peak velocity of the lower lip raising movement did not differ between the two categories. Thus if the lip movements in speech are controlled by specifying a virtual target, that control must involve variations in both the position and the timing of the target.     

Single-optical-element soft-x-ray interferometry with a laser-plasma x-ray source

We report on a compact interferometer for the water-window soft-x-ray range that is suitable for operation with laser-plasma sources. The interferometer consists of a single diffractive optical element that focuses impinging x rays to two focal spots. The light from these two secondary sources forms the interference pattern. The interferometer was operated with a liquid-nitrogen jet laser-plasma source at lambda=2.88 nm. Scalar wave-field propagation was used to simulate the interference pattern, showing good correspondence between theoretical and experimental results. The diffractive optical element can simultaneously be used as an imaging optic, and we demonstrate soft-x-ray microscopy with interferometric contrast enhancement of a phase object.     

Single-frequency operation of a high-power, long-wavelength semiconductor disk laser

An optically pumped, high-power, single-frequency semiconductor disk laser is demonstrated. A thin (50 microm) diamond bonded to an InGaAsP gain chip provides the combined functions of heat removal and spectral filtering, thus eliminating the need for the additional intracavity etalons that are usually employed for single-frequency operation. In a short cavity (4 mm) configuration we obtained a maximum output power of 470 mW at 0 degrees C and 170 mW at 20 degrees C in a near-diffraction-limited beam (M2 < 1.2). The emission wave-length was 1549 nm and the linewidth was less than 200 MHz.     

A new ac electrospray mechanism by Maxwell-Wagner polarization and capillary resonance

We report a new high-frequency (>10 kHz) ac electrospray that is capable of generating micron-sized electroneutral drops. Unlike its dc counterpart, the drops are not ejected continuously from a sharp Taylor cone but intermittently from a resonating meniscus at the orifice. We attribute the resonant frequency to the capillary-inertia vibration time of the meniscus and the drop ejection to the Maxwell-Wagner electric stress at the drop tip, which is observed to reverse its direction across a crossover frequency. Above this frequency, the oppositely directed Maxwell-Wagner force causes the liquid to recede up the microneedle as an apparent electrowetting effect.     

Coupled folding-binding versus docking: a lattice model study

Using a simple hydrophobic/polar protein model, we perform a Monte Carlo study of the thermodynamics and kinetics of binding to a target structure for two closely related sequences, one of which has a unique folded state while the other is unstructured. We obtain significant differences in their binding behavior. The stable sequence has rigid docking as its preferred binding mode, while the unstructured chain tends to first attach to the target and then fold. The free-energy profiles associated with these two binding modes are compared.     

Isomorphic pairs of homogeneous functions and their morphisms

Summary. In this paper we determine all iseomorphic pairs (isomorphic pairs with monotonic, thus continuous isomorphisms) of continuous, strictly increasing, linearly homogeneous functions defined on cartesian squares I ² and J ² of intervals of positive numbers or on their restrictions or and or We prove that, if the iseomorphy is nontrivial, then each homogeneous function is a (weighted) geometric or power mean or a joint pair of such means. In functional equations terminology this means that all nontrivial continuous strictly increasing linearly homogeneous solutions G, H (with the continuous strictly monotonic F also unknown) of the equation on D _< or D _> are weighted geometric or power means, while on I ² they are joint pairs of weighted geometric means or of weighted power means.