Novel aromatic polyamides bearing pendent diphenylamino or carbazolyl groups

Two new diamines, 2,4‐diaminotriphenylamine ( 3 ) and N‐(2,4‐diaminophenyl)carbazole ( 4 ), were synthesized via the cesium fluoride‐mediated aromatic substitution reactions of 1‐fluoro‐2,4‐dinitrobenzene with diphenylamine and carbazole, followed by palladium‐catalyzed hydrazine reduction. Amorphous and soluble aramids having pendent diphenylamino and carbazolyl groups were prepared by the phosphorylation polycondensation of aromatic dicarboxylic acids with diamines 3 and 4 , respectively. The aramids derived from diamine 3 had sufficiently high molecular weights to permit the casting of flexible and tough films. They exhibited excellent mechanical properties and moderately high softening temperatures in the 221–298 °C range. However, the reactions of diamine 4 with aromatic diacids gave relatively lower molecular weights products that could not afford flexible films. For a comparative purpose, the parent aramids derived from m‐phenylenediamine and aromatic diacids were also prepared and characterized. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 3302–3313, 2004     

On Two Parallel Matched Gratings Demodulation Method of Fiber Grating Strain Sensor

The method of demodulation with two parallel matched fiber Bragg gratings( FBGs)system is introduced to enlarge the range of strain that can be detected by the FBG sensor system.     

2‐Cyanoprop‐2‐yl dithiobenzoate mediated reversible addition–fragmentation chain transfer polymerization of acrylonitrile targeting a polymer with a higher molecular weight

The reversible addition–fragmentation chain transfer (RAFT) polymerization of acrylonitrile (AN) mediated by 2‐cyanoprop‐2‐yl dithiobenzoate was first applied to synthesize polyacrylonitrile (PAN) with a high molecular weight up to 32,800 and a polydispersity index as low as 1.29. The key to success was ascribed to the optimization of the experimental conditions to increase the fragmentation reaction efficiency of the intermediate radical. In accordance with the atom transfer radical polymerization of AN, ethylene carbonate was also a better solvent candidate for providing higher controlled/living RAFT polymerization behaviors than dimethylformamide and dimethyl sulfoxide. The various experimental parameters, including the temperature, the molar ratio of dithiobenzoate to the initiator, the molar ratio of the monomer to dithiobenzoate, the monomer concentration, and the addition of the comonomer, were varied to improve the control of the molecular weight and polydispersity index. The molecular weights of PANs were validated by gel permeation chromatography along with a universal calibration procedure and intrinsic viscosity measurements. ¹H NMR analysis confirmed the high chain‐end functionality of the resultant polymers. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 1272–1281, 2007     

串列加速器头部电极改进方案

通过改变头部电极的局部形状来改善头部电场, 运用Poisson程序计算几种可能形状下表面电场的分布, 并以此给出最佳的改进方案.     

N-Widths and Average Widths of Besov Classes in Sobolev Spaces

In this paper, we consider the n-widths and average widths of Besov classes in the usual Sobolev spaces. The weak asymptotic results concerning the Kolmogorov n-widths, the linear n-widths, the Gel＇fand n-widths, in the Sobolev spaces on T^d, and the infinite-dimensional widths and the average widths in the Sobolev spaces on Ra are obtained, respectively.     

高功率双包层光纤激光器受激拉曼散射和热效应的理论研究

 受激拉曼散射和热效应会限制光纤激光器功率的提高。利用高功率光纤激光器的速率方程和热传导方程，理论研究了双端泵浦和分布泵浦下双包层光纤激光器的受激拉曼散射和热效应，得到了光纤中的泵浦光、激光和斯托克斯光的功率分布，光纤激光器的输出特性以及光纤中的温度分布。分析表明，当泵浦功率增大到一定值时，光纤激光器中出现SRS，一部分激光功率会转移给斯托克斯光，影响激光功率进一步提高;与双端泵浦方式相比，分布泵浦下光纤激光器的斜率效率和最大输出功率相差不大，但是，光纤中的温度分布被有效地降低，因此，分布泵浦方式更为有效。     

相对论效应对激光在等离子体中的共振吸收的影响

采用一维粒子模拟(PIC)方法，研究了相对论效应对P偏振激光斜入射非均匀等离子体时产生的共振吸收的影响. 计算表明，弱相对论情况下，在临界面附近产生的电子等离子体波的相对论非线性效应占主要作用；随着入射光场的逐渐增大，吸收率逐渐降低. 当入射光强超过3.7×10¹⁷W/cm²时，由于超短激光脉冲本身在等离子体中产生相对论效应、等离子体波破裂效应，以及参量不稳定过程激发等，吸收系数随着激光强度又开始增加. 固定等离子体密度标长，取不同的激光入射角、电子初始温度，相对论效应对吸收系数的影响是一致的. 关键词： 激光等离子体 相对论效应 共振吸收 粒子模拟