Deposition of Hydrogen-Free Silicon Nitride Thin Films by Microwave ECR plasma Enhanced Magnetron Sputtering at Room Temperature

Hydrogen-free silicon nitride （SiNx） films were deposited at room temperature by microwave electron cyclotron resonance （MW-ECR） plasma enhanced unbalance magnetron sputtering system. Both Fourier-transform infrared spectroscopy and x-ray photoelectron spectroscopy are used to study the bonding type and the change of bonding structures of the silicon nitride films. The results indicate that the chemical structure and composition of SiNx films deposited by this technique depend strongly on the N2 flow rates, the stoichiometric SiNx film, which has the highest hardness of 22.9 GPa, could be obtained at lower N2 flow rate of 4 sccm.     

双奇核136La的集体带结构

通过重离子核反应与在束γ谱的实验技术, 对A=130缺中子核区的双奇核¹³⁶La的高自旋态进行了研究, 所用核反应为¹³⁰Te(¹¹B,5n). 实验结果扩展了¹³⁶La的能级纲图, 包括3个集体转动带, 最高自旋态达20h. 对于\uppi h_{11/2}\otimes \upnu h_{11/2}$~带, 观测到了旋称反转与集体回弯现象. 通过系统学比较, 对旋称反转特性进行了讨论. 由推转壳模型的计算指出, 此集体回弯是由一对中子的角动量顺排引起的. 另外两个集体带为具有~$\gamma\approx -60^\circ$~的扁椭形变带, 其可能的组态为: $\uppi h_{11/2}\otimes \upnu g_{7/2}h_{11/2}^2$~与~$\uppi g_{7/2}\otimes\upnu g_{7/2}^2 d_{5/2} h_{11/2}^2$.     

相对论平均场理论中各种有效相互作用对中子星性质的影响

基于相对论平均场理论，研究了各种相互作用参数组(NL1、NL3、NLSH、TM1和GL-97)对中子星物质的性质和中子星整体结构的影响．发现参数组NL1、NL3和NLSH所给出的中子星内部的介子场强度、物质的组成比例、物态方程和中子星的整体特点基本相同，但与TM1和GL-97之间有较大的差别．相对于其他参数组，GL-97给出的介子场强度最弱，中子星的相对数密度最大，物态方程也最软，同时采用GL-97参数组计算的中子星的最大质量也最小．     

一维粗糙表面散射特征的数值分析

使用Monte Carlo模拟的方法得出了随机粗糙表面，在Kirchhoff近似的基础上，利用数值分析的方法分析了一维随机粗糙表面的散射特征，得出了一维随机粗糙表面散射分布曲线，我们还考虑了遮蔽效应的影响，并且讨论了Kirchhoff近似的有效性。     

Atomic-scale simulation of nano-grains:structure and diffusion properties

Nanograins are characterized by a typical grain size from lto 100 nm.Mclecular dynamics aimubations have been carried out for the nanograin sphere with the diameters from 1.45 to 10.12 nm.We study the influence of grain size on structure and diffusion properties of the nanograins.The results reveal that as the grain size is reduced,the fraction of grain surface increases significantly,and the surface width is approximately constant；the diffusicn coefficlent is increased sharply,and the relation of the diffusion coefficient and the grain size is close to exponential relation below 10nm.     

Control of LHCD on the HL-2A Tokamak

in order to study non-indutive plasma current production, the lower hybrid current drive（LHCD） experiment on the HL-2A tokamak is carried out. Simultaneously a microcomputer has been used to control the whole LHCD system. During the experiment this year, we can monitor and protect the LHCD system by use of the microcomputer control system, which will imediately switch off the microwave power to be launched into the tokamak if the plasma is disrupted. All this ensure that the microwave is injected into the equipment correctly.     

A New Cycloartane from Sphaerophysa salsula

A novel cycloartane,named sphaerophysone A,9,19-cycloart-7β,24β,25-triol-1-en-3-one,was isolated from the ethanol extract of Sphaerophysa salsula DC.The structure was elucidated on the basis of spectral evidences and confirmed by X-ray analysis,the stereochemistry of the compound was also defined by X-ray analysis.     

A new stochastic method of reconstructing porous media

We present a new stochastic method of reconstructing porous medium from limited morphological information obtained from two-dimensional micro- images of real porous medium. The method is similar to simulated annealing method in the capability of reconstructing both isotropic and anisotropic structures of multi-phase but differs from the latter in that voxels for exchange are not selected completely randomly as their neighborhood will also be checked and this new method is much simpler to implement and program. We applied it to reconstruct real sandstone utilizing morphological information contained in porosity, two-point probability function and linear-path function. Good agreement of those references verifies our developed method’s powerful capability. The existing isolated regions of both pore phase and matrix phase do quite minor harm to their good connectivity. The lattice Boltzmann method (LBM) is used to compute the permeability of the reconstructed system and the results show its good isotropy and conductivity. However, due to the disadvantage of this method that the connectivity of the reconstructed system’s pore space will decrease when porosity becomes small, we suggest the porosity of the system to be reconstructed be no less than 0.2 to ensure its connectivity and conductivity.     

基于椭圆型方程的扭叶片造型方法的研究

本文以偏微分方程造型为基础,提出了一种基于椭圆型方程的扭叶片三维型面直接设计方法,详细推导了叶型曲面函数,给出了型面方程的求解及其前后缘修正。该方法具有设计叶型曲面自然光顺,设计参数少且各参数具有明显的几何意义,叶型曲面调整方便,利于采用非数值优化算法对其进行气动优化等优点。文中给出了设计实例,并通过数值实验分析了所设计叶片型面的流动特性。分析结果表明设计叶片具有良好的气动性能,同时也证明了本文提出的基于椭圆型方程的扭叶片三维型面设计方法的可靠性和实用性。