Recent progress in two-photon small molecule fluorescent probes for enzymes

This review aims to provide a summary of the progress in TP small molecule fluorescent probes for enzymes in recent years and displays the main fluorescent mechanisms that have been applied to design probes.     

Electrospun cellulose acetate fibers: effect of solvent system on morphology and fiber diameter

This paper reports an investigation of the effects of solvent system, solution concentration, and applied electrostatic field strength (EFS) on the morphological appearance and/or size of as-spun cellulose acetate (CA) products. The single-solvent systems were acetone, chloroform, N,N -dimethylformamide (DMF), dichloromethane (DCM), methanol (MeOH), formic acid, and pyridine. The mixed-solvent systems were acetone–DMAc, chloroform–MeOH, and DCM–MeOH. Chloroform, DMF, DCM, MeOH, formic acid, and pyridine were able to dissolve CA, forming clear solutions (at 5% w/v), but electrospinning of these solutions produced mainly discrete beads. In contrast, electrospinning of the solution of CA in acetone produced short and beaded fibers. At the same solution concentration of 5% (w/v) electrospinning of the CA solutions was improved by addition of MeOH to either chloroform or DCM. For all the solvent systems investigated smooth fibers were obtained from 16% (w/v) CA solutions in 1:1, 2:1, and 3:1 (v/v) acetone–DMAc, 14–20% (w/v) CA solutions in 2:1 (v/v) acetone–DMAc, and 8–12% (w/v) CA solutions in 4:1 (v/v) DCM–MeOH. For the as-spun fibers from CA solutions in acetone–DMAc the average diameter ranged between 0.14 and 0.37 μm whereas for the fibers from solutions in DCM–MeOH it ranged between 0.48 and 1.58 μm. After submersion in distilled water for 24 h the as-spun CA fibers swelled appreciably (i.e. from 620 to 1110%) but the physical integrity of the fibrous structure remained intact.     

Studies on metal — protein interactions: Inter-comparison among various approaches

Binding ability of mercury, thallium, lead and bismuth with Erythrina variegata seed protein have been investigated using tracer packet technique. Due to the lack of standard methods, inter-comparisons have been made among three different approaches, like trichloroacetic acid (TCA) precipitation, isoelectric precipitation and dialysis of protein after incubation with the metals. Good agreement was observed for all the cases except that of lead.     

水溶性高聚物的研究进展

自八十年代初，水溶性高聚物再次成为高分子科学研究热点，评述了水溶性高聚物，特别是疏水缔合型改性水溶性高聚物的最新进展。     

个旧超大型锡多金属矿稀土元素地球化学特征

对比研究了个旧不同类型岩(矿)石(蚀变花岗岩、钙质泥岩、大理岩、矽卡岩矿石、层状矿石和脉状矿石)的稀土元素、微量元素地球化学特征,借以示踪不同类型矿床的成矿物质来源。研究表明不同类型矿石中的稀土元素配分曲线较为相似,成矿物质具有同源性,并与本区的花岗岩具有一定的成因联系。由于其成矿方式的不同,不同类型矿石中的稀土元素特征和矿物组合特征略有差异,脉状矿石和层状矿石中稀土含量相对较少且富集轻稀土,而矽卡岩矿石中稀土含量相对较多且轻、重稀土的含量变化较大。     

Shear and NMR experiments of materials with flow behaviour depending on the deformation history

Oxide ceramic masses react to simple shearing with hardening (peptisation: increase in the shear stress with the shear deformation). In the present study the correlation between the increase in the shear stress and the porosity, agglomeration processes and the type of flow are analysed. For this purpose oxide ceramic masses are tested in a shear device especially developed for pastes and analysed by rheometric experiments, NMR methods and particle size analysis. The results support the hypothesis that structural changes (hardening, increase in the mean porosity) of the material during the peptisation mainly depend on the magnitude and not on the kind of the energy input and thus of the type of flow. The fraction of bound (more generally, the immobilised) water increases with the shear displacement. Also crushing of primary particles could be observed. Both the crushing of solid particles causing an increased solid surface and the formation of a three-dimensional gel structure are microscopic effects capable of resulting in the binding or retaining water. On a macroscopic scale these phenomena cause hardening. Magnetic resonance imaging visualises flow-induced agglomerates, which form owing to the shear flow and increase the porosity averaged over the whole sample. After the shear experiment rolls of paste can be seen which indicate that the general assumption of a plane shear flow in the shear device is not warrantable. Received: 19 July 2001 Accepted: 25 October 2001     

Chemical ionization mass spectrometry of nitrosamines

The mass spectra of eight nitrosamines have been recorded, with excitation by chemical ionization (CI) and electron impact (EI). Comparison of the intensities of the base peaks under CI and El conditions gives intensity ratios in the range 1.4-1.9 for low resolution measurements and up to 10 for high resolution measurements, confirming the enhanced sensitivity available in the CI mode.     

Resolution method for overlapping peaks based on the fractional-order differential

Equations between the differential order and the maximum of the fractional-order differential for the specified peak signals are developed based on the variation of the maximum of the specified peak signals at different orders. Also, equations between the differential order and the zero-crossing of the fractional-order differential of the specified peak signals are proposed according to the variation of the zero-crossing of the specified peak signals at different orders. Characteristic paramters of the Gaus- sian peak, Lorentzian peak, and Tsallis peak can be estimated using estimator I and estimator II which are obtained by the equations above. As a result, a new method is presented to resolve the overlapped peaks signal. Firstly, a fractional-order differential of the specified peak signals is obtained with the fractional-order differentiation filter. Then, characteristic paramters of the specified peak signals can be extracted using estimator I and estimator II. Finally, the Tsallis peak is used as a model to assign the overlapping peak signals correctly. Experimental results show that the proposed method is efficient and effective for the simulated overlapping peaks and detected overlapping voltammetric peak signals.     

透明导电玻璃(ITO)基材自加热传感静态芯片聚合酶链反应(PCR)

利用商品化ITO玻璃导电层的温阻效应, 无需任何微加工手段, 实现了自加热和传感的芯片温度自动程序控制, 最大程度地减小了传感滞后对温度控制稳定性的影响, 温度控制的稳定性达到了0.2 ℃, 升温速度最快可达20 ℃/s以上, 在冷却风扇辅助下降温速度最快达到了8 ℃/s. 芯片温控单元的引线从传统的两对(一对用于传感, 一对用于加热)减少为一对. 通过在该芯片上直接构建多个开放微池反应器的方法成功地实现了λDNA 157 bp片段的并行扩增. 将该芯片置于倒置荧光显微镜样品台上, 以蓝色(575 nm)发光二极管为光源, 以光电倍增管为检测手段检测了dsDNA和SYBR Green Ⅰ嵌合物的荧光强度随温度的实时变化曲线.     

Growth of ramification-like ZnO rods in the presence of polyaniline

To obtain new materials with synergetic or complementary behaviors, polyaniline composite filled with ZnO rods in ramification-like structure was prepared by a hydrothermal approach. Comparative experiments of ZnO preparation in the presence of some metal ions were also carried out. The results indicated that the morphology of ZnO was strongly affected by the preparation condition. The method to grow ZnO rods in the presence of polyaniline offers a simple approach to obtain polyaniline composite filled with linear ZnO structure. The results of X-ray photoelectron spectroscopy show that the strong interaction between ZnO and polyaniline possibly exists to cause the charge transfer.