Thermal decomposition of the composite hydrotalcites of iowaite and woodallite

The thermal stability and thermal decomposition pathways for synthesized composite iowaite/woodallite have been determined using thermogravimetry analysis in conjunction with evolved gas mass spectrometry. Dehydration of the hydrotalcites occurred over a range of 56–70°C. The first dehydroxylation step occurred at around 255°C and, with the substitution of more iron(III) for chromium(III) this temperature increased to an upper limit of 312°C. This trend was observed throughout all decomposition steps. The release of carbonate ions as carbon dioxide gas initialised at just above 300°C and was always accompanied by loss of hydroxyl units as water molecules. The initial loss of the anion in this case the chloride ion was consistently observed to occur at about 450°C with final traces evolved at 535 to 780°C depending of the Fe:Cr ratio and was detected as HCl (m/z=36). Thus for this to occur, hydroxyl units must have been retained in the structure at temperatures upwards of 750°C. Experimentally it was found difficult to keep CO₂ from reacting with the compounds and in this way the synthesized iowaite-woodallite series somewhat resembled the natural minerals.     

纸基质室温燐光法测定痕量核黄素的研究

本文以国产滤纸为基质,醋酸汞作重原子微扰剂,详细研究了 RTP 的各种条件,成功地建立了测定核黄素的纸基质室温燐光法(PS-RTP)。结果表明,核黄素标准曲线线性范围为5×10~(-6)～1×10~(-3)mol/L,检出限为0.75ng。将该法用于血清中核黄素的测定,标准回收率在93.5％～103％之间。     

气相色谱法分析氯氰菊酯异构体

比较了DB-1和HP-5石英毛细管柱在不同柱流速、柱温下对氯氰菊酯异构体的分离效果,表明采用DB-1石英毛细管柱(30m×0.25mmi.d.,0.25μm)较好,柱温为240℃,柱流速为12cm/s,分析时间40min。该分析方法重现性好,分析结果准确、可靠。     

α-杂环硫代苯乙酮衍生物的合成

以5-氨基-3-巯基-(1H）-1，2，4-三唑和2-巯基苯并噻唑为主要原料在碱性条件下与α-氯代苯乙酮反应合成了10个新的标题化合物。其结构经元素分析、IR，^1H NMR和MS确证。     

Mesoporous micelle templated silica with incorporated C<Subscript>8</Subscript> and C<Subscript>18</Subscript> phase

Mesoporous silica material of MCM-41 type was synthesized by co-condensation of highly concentrated octyltriethoxysilane (OTEOS), octadecyltriethoxysilane (ODTEOS) and tetraethoxysilane (TEOS). The obtained hybrid materials were characterized using XRD, TG-DSC and low temperature adsorption/desorption of nitrogen. It was shown that the applied method of synthesis allows to obtain silica of MCM-41 type with a high degree of hydrocarbon saturation.     

Preparation of HPMC–EA–DMAEMA nanosized latex

Nanosized copolymer latex of hydroxypropylmethylcellulose (HPMC) grafted with ethyl acrylate (EA) and dimethylaminoethyl methacrylate (DMAEMA) has been prepared by acidifying submicron-sized latex particles synthesized by soap-free emulsion graft copolymerization using potassium persulfate (KPS) as initiator. The effects on the diameter of the latex particles of different conditions, for example concentration of DMAEMA, amount of HPMC, and ratio of HCl to DMAEMA for acidification, were investigated. It was found that increasing the mole ratio of HCl to DMAEMA to 1.0 and increasing the DMAEMA content both resulted in a decrease in particle diameter, whereas increasing the amount of HPMC resulted in larger particle sizes. Measurement by dynamic light scattering (DLS) revealed the diameter of the latex particles was >200 nm before acidification and <100 nm after acidification. Evidence of grafting was obtained by use of Fourier transform infrared (FTIR) spectroscopy. Transmission electron microscopy (TEM) was used to characterize the morphology of the copolymer particles before and after acidification.     

Influence of thermal and thermo-mechanical treatment

Two lipids with similar melting ranges but of different composition were analyzed using differential scanning calorimetry and X-ray diffraction. The lipids were processed via extrusion or were tempered at different temperatures; they were analyzed directly after extrusion and after storage at 40°C. Precirol ATO 5® showed high sensitivity to storage time and varied temperature exposure. Extrusion showed only marginal influences on the solid state. Melting peaks were narrower and shifted to higher temperatures in comparison to the untreated powder. Dynasan 114® was more robust, changes in the solid state could only be shown for samples treated above the melting range. Thus, Dynasan 114® is more appropriate for solid lipid extrusion of pharmaceutical products.     

Calorimetric approach to tetronic/water interactions

Tetronic^®comprises X-shaped copolymers formed by four poly(propylene oxide) (PPO) andpoly(ethylene oxide) (PEO) block chains bonded to an ethylene diamine centralgroup. Micellization behaviour of three representative Tetronics (T304, T904and T1307) was characterized to gain an insight into the interactions betweenthe copolymer unimers and the state of water in their solutions. The enthalpyof demicellization, recorded at 37°C in an isoperibol microcalorimeter,indicated that the process was in all cases exothermic and the enthalpy rankedin the order T1307≥T904>>T304. Micellization is entropy-driven owing tohydrophobic interactions between the PPO chains.DSC analysisshowed that the crystallization and melting peaks of the free water remainingin T304 and T904 solutions were progressively shifted toward lower temperaturesas the surfactant proportion increased, owing to a colligative effect. Boundwater corresponded to 3 water molecules per EO repeating unit. In the caseof T1307, which has longer PEO chains, a splitting of the melting peak wasobserved, one peak appearing around 0°C due to free water and anotherat –15°C due to interfacial water. As T1307 proportion raised, theenthalpy of the former decreased, whilst the enthalpy of the latter increased.In 40% T1307 solutions, interfacial water overcame the proportion of freewater; there being 1 interfacial and 3 bound water molecules per EO repeatingunit. Gaussian deconvolution of FTIR spectra also enabled to characterizethe evolution of free water as a function of Tetronic proportion. The dependenceof micellization and water interaction behaviour on Tetronics structure shouldbe taken into account to use these copolymers as drug solubilizers and micellarcarriers.     

毛蕊杜鹃挥发油化学成分研究

毛蕊杜鹃(Rhododendron tubulosum Ching ex wang wei-yei)系杜鹃花科杜鹃花属植物,分布于四川、西藏、甘肃和青海,其中青海分布最广,藏民常作为单方草药用于治疗肺炎和老年慢性气管炎,具有镇咳、祛痰作用,本文用自制的同时水汽蒸馏-溶剂萃取装置,从采自青海玉树州的毛蕊杜鹃鲜叶和嫩枝提取挥发油,用毛细管气相色谱-质谱和Kovats指数双重定性法对