Sol-gel polycondensation of methyltrimethoxysilane in ethanol studied by <Superscript>29</Superscript>Si NMR spectroscopy using a two-step acid/base procedure

Sol-gel polymerization of methyltrimethoxysilane (MTMS) in ethanol using a two-step acid/base catalyzed procedure (B2) is followed by ²⁹Si NMR spectroscopy. Analysis of the structural evolution of the B2 system shows that esterification of monomeric and end silicon species is rate-limited while that of linear and cyclic species is able to reach pseudoequilibrium in the second basic step. Condensation reactivity is reduced with increasing network connectivity, however, to a much less degree under B2 conditions than MTMS polymerization under acidic conditions. Steric effects as well as many other factors are attributed to this trend. The concentration of cyclic and polycyclic species of the B2 system is nearly 3 times lower compared to the acid-catalyzed system. The empirical degree of condensation at the gel point is determined to be 0.88. The effects of cyclization and phase separation on MTMS gelation are discussed for both B2 and acid-catalyzed systems. Based on these results it is believed that MTMS-based gels form for B2 and not acid-catalyzed conditions due to reduced cyclization, rapid hydrolysis and condensation, effective use of functional groups, and effective contribution of branched and polycyclic species as crosslinking points to connect polymeric chains in the B2 system.     

Further studies on the chemistry and structure of n-oxides of sparteine and its derivatives—V: Synthesis and structure of 2-phenylsparteine-n16-oxide,a new case of “sponge” proton

The synthesis of 2-phenylsparteine-N₁₆-oxide (7) and its perchlorate salt (7-H⁺) was carried out. On the basis of spectral data, and by comparison with appropriate sparteine-N-oxides, the mechanism of formation and the structures of the two new compounds were proposed. It was found, the basicity of the new N-oxide is unexpectedly high and comparable to the basicity of quaternary ammonium hydroxides. The structure and the strength of intramolecular H-bond in 7-H⁺ makes 7 an excellent “catcher” proton or specific ”sponge” proton.     

Computing the Fukui function from ab initio quantum chemistry: approaches based on the extended Koopmans’ theorem

The extended Koopmans’ theorem is related to Fukui function, which measures the change in electron density that accompanies electron attachment and removal. Two approaches are used, one based on the extended Koopmans’ theorem differential equation and the other based directly on the expression of the ionized wave function from the extended Koopmans’ theorem. It is observed that the Fukui function for electron removal can be modeled as the square of the first Dyson orbital, plus corrections. The possibility of useful generalizations to the extended Koopmans’ theorem is considered; some of these extensions give approximations, or even exact expressions, for the Fukui function for electron attachment.     

Repeat Space Theory Applied to Carbon Nanotubes and Related Molecular Networks. I

The present article is the first part of a series devoted to extending the Repeat Space Theory (RST) to apply to carbon nanotubes and related molecular networks. Four key problems are formulated whose affirmative solutions imply the formation of the initial investigative bridge between the research field of nanotubes and that of the additivity and other network problems studied and solved by using the RST. All of these four problems are solved affirmatively by using tools from the RST. The Piecewise Monotone Lemmas (PMLs) are cornerstones of the proof of the Fukui conjecture concerning the additivity problems of hydrocarbons. The solution of the fourth problem gives a generalized analytical formula of the pi-electron energy band curves of nanotube (a, b), with two new complex parameters c and d. These two parameters bring forth a broad class of analytic curves to which the PMLs and associated theoretical devices apply. Based on the above affirmative solutions of the problems, a central theorem in the RST, called the asymptotic linearity theorem (ALT) has been applied to nanotubes and monocyclic polyenes. Analytical formulae derived in this application of the ALT illuminate in a new global context (i) the conductivity of nanotubes and (ii) the aromaticity of monocyclic polyenes; moreover an analytical formula obtained by using the ALT provides a fresh insight into Hückel’s (4n+2) rule. The present article forms a foundation of the forthcoming articles in this series. The present series of articles is closely associated with the series of articles entitled ‘Proof of the Fukui conjecture via resolution of singularities and related methods’ published in the JOMC.     

Synthesis and characterization of hollandite-type material intended for the specific containment of radioactive cesium

The hollandite Ba₁Cs_0.28Fe_0.82Al_1.46Ti_5.72O₁₆, which has been proposed for the cesium-specific conditioning, can be synthesized either by an alcoxyde or a dry route. In both cases, a two-step protocol is applied, i.e., a calcination at 1000 °C followed by a sintering at 1200 °C. After sintering, both synthetic processes lead to a tetragonal form. According to the X-ray diffraction (XRD) patterns collected at the barium and the cesium K absorption edges, the different positions of these two elements have been evidenced with a more centered position in the oxygen cubic site of the tunnel for Ba than for Cs. On the contrary, after calcination, the two synthetic routes yield different products. The alcoxyde route gives rise to a mixture of the aforementioned Cs- and Ba-containing tetragonal I4/m hollandite, a Cs-only-containing monoclinic I2/m hollandite and an unidentified phase with a weak coherence length containing only Ba. The dry route yields a single tetragonal hollandite material containing Ba and Cs slightly different in composition from the targeted compound.     

A simple and very sensitive spectrophotometric method for the direct determination of copper ions

A sensitive spectrophotometric method for the direct determination of copper in aqueous samples without a preconcentration step has been developed. It is based on the formation of a yellow complex with the chromogenic reagent di-2-pyridyl ketone benzoylhydrazone (dPKBH) in an alkaline medium. The complex stoichiometry was 1:2 (Cu:dPKBH) and presents maximum absorbance at 370 nm. The influence of chemical variables affecting the behaviour of the system such as pH, concentration of dPKBH, buffer solution and ethanol, order of addition of the reagents and stability of the complex, were evaluated. The molar absorptivity (epsilon) was 3.92x10(4) L mol(-1) cm(-1), and Beer's law was obeyed up to 3 mg L(-1) of copper. The relative standard deviation was 0.46% (n=11) for a sample containing 1 mg L(-1) Cu(II). The limit of detection was 2.5 micro g L(-1) and was therefore more sensitive than the direct methods reported previously. Finally, the method was successfully validated by analysing several real samples with different matrices, such as tap water, natural water or copper alloys, with an average relative error of 2.46%.     

Development of a capillary electrophoretic method for the analysis of amino acids containing tablets

Ketosteril is an enteral medicinal product indicated for prevention and therapy in chronic renal insufficiency in connection with a low protein diet. Tablets of Ketosteril contain five essential amino acids like: Lys, His, Thr, Trp, Tyr and another five amino acids in the form of their hydroxy and keto analogues as calcium salts, that are: alpha-ketoleucine, alpha-ketoisoleucine, alpha-ketovaline, alpha-ketophenylalanine and alpha-hydroxymethionine. The composition of Ketosteril tablets is routinely tested with three LC methods. Capillary electrophoretic method seems to be a good alternative for amino acids and their analogues determination in multicomponent pharmaceuticals because of short analysis time and the possibility to assay all components during a single run without any pretreatment. Electrophoresis was performed in 50 microm I.D. fused-silica capillaries with 65 cm distance to the detector. Capillaries were installed in Waters Quanta 4000 electrophoretic equipment with a positive power supply and on-line UV detection at 214 nm. Separations were done in a buffer containing 40 mM Tris and 160 mM boric acid titrated with NaOH to pH 10. The method developed allows the separation of all investigated analytes with an efficiency of n = 230,000 and 20 min analysis time. The method was applied for determination of all components of Ketosteril in commercial tablets.     

Thermal and mechanical-induced phase transformations during YAG and alumina–YAG syntheses

The preparation of pure Y₃Al₅O₁₂ (YAG) and 50 vol% Al₂O₃–YAG composite powders by a wet chemical route is presented. The role of the synthesis temperature during reverse-strike precipitation has been investigated, showing its relevant effect on the purity and homogeneity of YAG powder. The composite material was prepared by comparing two different synthesis routes. A composite powder was synthesized via reverse-strike temperature-controlled co-precipitation. In the latter case, a pure-alumina precursor was firstly reverse-strike precipitated and then doped with an yttrium salt solution. For both syntheses, the role of thermal and mechanical pre-treatments on the phase development was demonstrated.     

Additional peaks in the cluster size distribution of amphiphile + water systems: a clue for shape/phase transition or statistical uncertainty

In some works on the lattice Monte Carlo simulation of amphiphilic systems additional peaks in the cluster size distribution has been interpreted as a clue for the phase or shape transition of micellar aggregates. On the other hand, some other works showed that the additional peaks are a result of finite size of the lattice box. In this paper using calculating energy-auto-correlation function and statistical error in correlated data, it is shown that how these apparently contradictory results are the same. To do this, we have simulated a pure system containing amphiphile and water molecules. A simple model of potential containing the main feature for these systems (the hydrophobicity of surfactant molecules) that cause the aggregates to be formed is considered to avoid any synthetic results due to additional non-real parameters. To relax the initial configuration faster, configurational bias Monte Carlo move is used in addition to reptation move. Periodic boundary condition and self-avoiding walks are used as former published works in this field. It is shown that the additional peaks is a result of the statistical errors for averaged cluster size distribution and can not be interpreted as a clue for shape or phase transition.     

Kinetics of Oxidation of 4-Oxoacids by <Emphasis Type="Italic">N</Emphasis>-Chlorosaccharin in Aqueous Acetic Acid Medium

The oxidation kinetics of substituted and unsubstituted 4-oxoacids (S) by N-chlorosaccharin (NCSA) have been studied in aqueous acetic acid media. The reaction follows first-order kinetics in each of the 4-oxoacids, NCSA and H⁺. The effect of changes in the electronic nature of the substrate reveals that positive charge develops in the transition state. Based on the kinetic results and product analysis, a suitable mechanism has been proposed for the reaction of NCSA with 4-oxoacids.