Photocured characteristics of fast photocurable acrylic formulations and investigations by differential photo calorimeter

Nanofluids are obtained by suspending metallic or non-metallic nanoparticles in conventional base liquids and can be employed to increase heat transfer rate in various applications. In this study, the effects of adding three types of nanofluids on turbulent convective heat transfer at the entrance region of a constant wall heat flux tube were experimentally studied. The nanofluids were mixtures of aluminium oxide, copper oxide, and silicon carbide at various nanoparticle volume fractions ranging from 0.0002 to 0.002 in water. The convective heat transfer coefficient was measured at different Reynolds numbers of 10,000–50,000. At these concentrations and Reynolds numbers, a maximum of 11–18% of convection heat transfer coefficient was observed as compared to the base fluid, showing a 6–9% increase on average. In this study, it was observed that changes in the nanoparticle type had no considerable effect on heat transfer coefficient increase. According to the model proposed here, the dimensionless thickness of laminar sub-layer is specified as a functional equation of the volume fraction of nanoparticles for each material.

     

Independent measurement of the total active 8B solar neutrino flux using an array of 3He proportional counters at the Sudbury Neutrino Observatory

The Sudbury Neutrino Observatory (SNO) used an array of 3He proportional counters to measure the rate of neutral-current interactions in heavy water and precisely determined the total active (nu_x) 8B solar neutrino flux. This technique is independent of previous methods employed by SNO. The total flux is found to be 5.54_-0.31;+0.33(stat)-0.34+0.36(syst)x10(6) cm(-2) s(-1), in agreement with previous measurements and standard solar models. A global analysis of solar and reactor neutrino results yields Deltam2=7.59_-0.21;+0.19x10(-5) eV2 and theta=34.4_-1.2;+1.3 degrees. The uncertainty on the mixing angle has been reduced from SNO's previous results.     

New chalcone based liquid crystals with allylidene amino linking unit: Synthesis and characterization

In this study, the synthesis, structural characterization and mesomorphic properties of newly thirteen calamitic shaped compounds derived from allylidene amino chalcone and 4-n-alkoxy benzoyloxy benzoic acid. Comp.H₁ to H₃ exhibited nonliquid crystalline nature, while comp.H₄ to comp.H₁₈ displayed enantiotropical smectic C phase. Phase transition temperatures of present synthesised compounds were determined by optical polarising microscopy (POM), differential scanning calorimetric (DSC) and powder X-ray diffraction (PXRD) techniques. Thermal stabilities of smectic to isotropic phase are 150.0 °C and temperature range of mesophase is in decreasing order from comp.H₃ to comp.H₁₈ respectively. The presences of SmC phase are the type of broken fan and needle type in present synthesized series. It is also shown that presence of chalcone amino allylidene central linking group favors a calamitic liquid crystalline behaviour in molecules with lower member to higher member aliphatic side chain in alkoxy group (-OR).     

tert-Butyl nitrite induced radical dimerization of primary thioamides and selenoamides at room temperature

A simple and efficient method for the dimerization of primary thioamides into 1,2,4-thiadiazoles using tert-butyl nitrite is described. The optimized condition was also found to be suitable for the dimerization of benzoselenoamides into 1,2,4-selenadiazoles. All the reactions proceed smoothly at room temperature and gave the desired products in excellent yields in a short span of time.     

N‐Heterocyclic Carbene Catalysis via Azolium Dienolates: An Efficient Strategy for Remote Enantioselective Functionalizations

N‐heterocyclic carbene (NHC) catalysis has emerged as a powerful strategy in organic synthesis. In recent years a number of reviews have been published on NHC‐catalyzed transformations involving Breslow intermediates, acyl azoliums, α,β‐unsaturated acyl azoliums, homoenolate equivalents, and azolium enolates. However, the azolium dienolate intermediates generated by NHCs have been employed in asymmetric synthesis only very recently, especially in cycloadditions dealing with remote functionalization. This Minireview highlights all the developments and the new advances in NHC‐catalyzed asymmetric cycloaddition reactions involving azolium dienolate intermediates.     

Quantitative characterization and pharmaceutical compatibility between teneligliptin and widely used excipients by using thermal and liquid chromatography tandem mass spectrometry techniques

Journal of Thermal Analysis and Calorimetry - The aim of this work was to evaluate the quantitative characterization and pharmaceutical compatibility study of teneligliptin (TNG) with the commonly...     

Effect of lattice oxygen on optical absorption, radiation hardness and thermally stimulated luminescence of BaF2 crystal

The influence of the presence of BaO impurity on the optical absorption, radiation hardness and thermally stimulated luminescence of BaF₂ has been investigated. The presence of oxygen impurity gives rise to three absorption bands in the UV region, peaking around 220, 280 and 335 nm. Further, the impurity is found to be detrimental to crystal hardness against ionizing radiations. The thermally stimulated luminescence (TSL) has been studied from gamma-irradiated crystals containing different fractions of BaO impurity. Four prominent glow peaks around 100°C (peak I), 150°C (peak II), 220°C (peak III) and 290°C (peak IV) are observed for crystals containing BaO impurity concentrations lower than 0.5% (by wt). For crystals containing higher impurity concentrations, two additional peaks around 75°C and 260°C are also observed. The kinetics of TSL emission is observed to be of first order, implying that the absorption and the emission centers responsible for TSL are the same. The normalized TSL output for peak I is found to vary linearly with the concentration of oxide impurity. This fact can be utilized to detect the presence of minute amounts of oxygen in BaF₂ lattice, which is crucial to the growth of crystals exhibiting high radiation hardness.     

Electrophoretic migration of proteins in semidilute polymer solutions

We present a systematic study of the electrophoretic migration of 10-200 kDa protein fragments in dilute-polymer solutions using microfluidic chips. The electrophoretic mobility and dispersion of protein samples were measured in a series of monodisperse polydimethylacrylamide (PDMA) polymers of different molecular masses (243, 443, and 764 kDa, polydispersivity index <2) of varying concentration. The polymer solutions were characterized using rheometry. Prior to loading onto the microchip, the polymer solution was mixed with known concentrations of SDS (SDS) surfactant and a staining dye. SDS-denatured protein samples were electrokinetically injected, separated, and detected in the microchip using electric fields ranging from 100 to 300 V/cm. Our results show that the electrophoretic mobility of protein fragments decreases exponentially with the concentration c of the polymer solution. The mobility was found to decrease logarithmically with the molecular weight of the protein fragment. In addition, the mobility was found to be independent of the electric field in the separation channel. The dispersion is relatively independent of polymer concentration and it first increases with protein size and then decreases with a maximum at about 45 kDa. The resolution power of the device decreases with concentration of the PDMA solution but it is always better than 10% of the protein size. The protein migration does not seem to correspond to the Ogston or the reptation models. A semiempirical expression for mobility given by van Winkle fits the data very well.     

Drug and surfactant transport in Cyclosporine A and Brij 98 laden p-HEMA hydrogels

Surfactants are commonly incorporated into hydrogels to increase solute loading and attenuate the release rates. In this paper we focus on understanding and modeling the mechanisms of both surfactant and drug transport in hydrogels. Specifically, we focus on Brij 98 as the surfactant, Cyclosporine A (CyA) as the hydrophobic drug, and poly-hydroxy ethyl methacrylate (p-HEMA) as the polymer. The models developed here are validated by experiments conducted with gels of different thicknesses and surfactant loadings. Also the model is compared with prior experimental studies in literature. The model predicts that the percentage surfactant as well as drug release scales as 1/(surfactant loading)(0.5), and thus a four fold increase in surfactant loading leads to a two fold reduction in percentage release for both drug and surfactant at a given time. The models for the surfactant and drug release are fitted to the experimental data to obtain values of 1.44 x 10(-14) m(2)/s for CyA diffusivity and 414.4 for the partition coefficient between drug concentration inside the micelle and that in the gel. These models can be very helpful in tuning the drug release rates from hydrogels by controlling the surfactant concentration. The results also show that Brij 98 loaded p-HEMA exhibit an extended release of CyA and so contact lenses made with this material can be used for extended ocular delivery of CyA, which is an immunosuppressant drug commonly used for treatment of various ocular ailments.     

A novel and versatile entry to asymmetrically substituted pyrazines

A novel and convenient procedure for the synthesis of asymmetrically tri- and tetrasubstituted pyrazines starting from para-methoxybenzyl-protected 3,5-dichloro-2(1H)-pyrazinones was elaborated. The key step is the conversion of the intermediate para-methoxybenzyl-protected thiopyrazinone upon treatment with MeI/I(2), into a pyrazine, rendering the chlorine in the C5-position susceptible to substitution. This approach entails the orthogonal introduction of the four substituents of the pyrazine scaffold. The application of microwave irradiation during different steps of the sequence has been shown to be highly valuable for speeding up reactions.