Inhibitory Effects of Tunisian Marine Algal Extracts on Digestive Lipases

The lipase inhibitory activity of ethanol extracts obtained from some marine algae collected on the Tunisian coast was evaluated. Caulerpa prolifera extract markedly reduced both dog gastric (DGL) and human pancreatic lipase (HPL) activities. Generally, the inhibition reached 100% after 40 to 60 min of incubation depending on lipase types and on substrates used. Moreover, the inhibitory effect of C. prolifera extract on lipases appeared to be accelerated by adding bile salts, which likely modified the interface and allowed the inhibitory compound to inactivate the lipase. The separation of C. prolifera extract by thin-layer chromatography (TLC) resulted in eight fractions showing efficient inhibition rate against DGL, compared to the crude extract. In the case of HPL, TLC fractionation reduced the inhibitory rates, suggesting that the effect of algal extract on lipases may be caused by a synergetic action of several compounds within the extract. High-performance liquid chromatograph separation resulted in isolation of a major compound displaying high inhibition capacity of HPL activity. Caulerpa prolifera extract may therefore be useful in developing antiobesity drugs.     

Physical immobilization of Rhizopus oryzae lipase onto cellulose substrate: activity and stability studies

Rhizopus oryzae lipase (ROL) was immobilized by adsorption onto oxidized cellulose fibers and regenerated films. The maximum adsorption level increases with the raise in the amount of carboxylic groups on cellulose surface confirming that adsorption is being governed mainly by electrostatic interaction between the enzyme and the substrate. This hypothesis was further confirmed by zeta-potential measurements showing a decrease in the zeta-potential of the fibers after enzyme adsorption. XPS analysis showed an intensification of the N 1s peak attesting the presence of the enzyme on the surface. The effect of temperature, pH and solvent polarity on the immobilized enzyme activity and stability was investigated. The catalytic esterification of oleic acid with n-butanol has been carried on using hexane as an organic solvent. A high conversion yield was obtained (about 80%) at 37 degrees C with a molar ratio of oleic acid to butanol 1:1 and 150IU immobilized lipase. The adsorption achieved two successive cycles with the same efficiency, and started to lose its activity during the third cycle.     

New Approaches for the Synthesis of Thiazoles and Their Fused Derivatives with Antimicrobial Activities

The 2‐ethoxy carbonyl methylene thiazol‐4‐one ( 3 ) reacts with acetophenone ( 4 ) to give the ethyl 2‐(4‐oxo‐4,5‐dihydro‐thiazol‐2‐yl)‐3‐phenyl‐2‐butenoate ( 5 ). The reactivity of the latter product towards aromatic aldehydes 6a‐d , cyanomethylene reagents 9a,b , aromatic aldehydes 13a‐d , phenylisothiocyanate ( 16 ), elemental sulfur and aromatic amines ( 20a‐c ) was studied to give arylidene, pyridine, thiophene and anilide derivatives. Some of the newly synthesized derivatives were used to synthesize fused derivatives. The antimicrobial activities of the newly synthesized products were tested in vitro for antimicrobial activity against two bacterial isolates, one saprophytic (Escherichia coli) and the other parasitic (Xanthomonas citri) and for antifungal activity against one saprophytic (Aspergillus fumigatus) and two phytopathogenics (Rhizoctonia solani and Fusarium oxysporum).     

Reactivity of indolizines in organic synthesis

This review reports the reactivity of indolizines. The reactions section covers, in general, electrophilic, oxidation, reduction, addition, cycloaddition, condensation, and Mannich and multicomponent reactions. The synthesis of bis-indolizines and cyclazines are reported. The reaction mechanisms are discussed.     

Development and validation of spectrophotometric, TLC and HPLC methods for the determination of lamotrigine in presence of its impurity

Three reliable, rapid and selective methods have been developed and validated for the determination of lamotrigine in the presence of its impurity, 2,3-dichlorobenzoic acid. The first method is spectrophotometric method using p-chloranilic acid forming a colored product with lambda(max) 519+/-2 nm. All variables affecting the reaction have been investigated and the conditions were optimized. Beer's law was obeyed over a concentration range of 10-200 microg ml(-1) with mean accuracy 100.13+/-0.44%. The molar ratio of the formed ion-association complex is found to be 1 : 1 as deduced by Job's method. The conditional stability constant (K(f)), standard free energy (DeltaG), molar absorptivity(epsilon), and sensitivity index were evaluated. The second method is based on TLC separation of the cited drug (Rf=0.75+/-0.01) from its impurity (Rf=0.23+/-0.01) followed by densitometric measurement of the intact drug spots at 275 nm. The separation was carried on silica gel plates using ethyl acetate : methanol : ammonia 35% (17 : 2 : 1 v/v/v) as a mobile phase. The linearity range was 0.5-10 microg/spot with mean accuracy 99.99+/-1.33%. The third method is accurate and sensitive stability-indicating HPLC method based on separation of lamotrigine from its impurity on a reversed phase C(18) column, using a mobile phase of acetonitrile : methanol : 0.01 M potassium orthophosphate (pH 6.7+/-0.1) (30 : 20 : 50 v/v/v) at ambient temperature 25+/-5 degrees C and UV detection at 275 nm in an overall analysis time of about 6 min., based on peak area. The injection repeatability, intraday and interday repeatability were calculated. The procedure provided a linear response over the concentration range 1-12 microg ml(-1) with mean accuracy of 99.50+/-1.30%. The proposed methods were successfully applied for the determination of lamotrigine in bulk powder, in dosage form and in presence of its impurity. The results obtained were analyzed by ANOVA to assess that no significant difference between each of the three methods and the reported one. The validation was performed according to USP guidelines.     

Langmuir-Blodgett films of cellulose nanocrystals: preparation and characterization

The goal of this work is the preparation of monolayers of cellulose I nanocrystals providing flat crystalline cellulose surfaces. Suspensions of cellulose nanocrystals were prepared by hydrolyzing ramie and tunicin fibers with sulfuric acid. Due to surface grafted sulfate groups, the negatively charged, rod-like cellulose nanocrystals were found to form stable layers at the air-water interface in the presence of a cationic amphiphilic molecule such as dioctadecyldimethylammonium (DODA) used in this work. These layers were formed at different cellulose-DODA weight ratios, compressed and analyzed by tensiometry, ellipsometry and Brewster angle microscopy. At low cellulose concentrations the layers are discontinuous, becoming dense and homogeneous upon reaching a critical weight ratio, which depends on the aspect ratio of the cellulose nanocrystals. After transfer onto silicon wafers, the surface composition and morphology as well as the thickness of the films were examined by X-ray photoelectron spectroscopy, ellipsometry and atomic force microscopy. The results indicate that they are monolayer films, well structured, relatively smooth and pure. These films offer a crystalline and easily reproducible model cellulose surface.     

The N-terminal His-tag affects the enantioselectivity of staphylococcal lipases: a monolayer study

In order to check the influence of the polyhistidine tag at the N-terminus of recombinant lipases, a comparative study on the interfacial properties of native and recombinant Staphylococcus simulans (SSL and rSSL) or Staphylococcus xylosus lipase (SXL and rSXL) was investigated using the monomolecular film technique. No phospholipase activity was detected with rSSL or rSXL when using different phospholipids spread as monomolecular films maintained at various surface pressures, suggesting that the His-tag in the N-terminus of the recombinant proteins, do not affect the substrate recognition. The critical surface pressure measured with monomolecular films of egg-PC was slightly lowered with the two recombinant proteins compared to the native SSL or SXL one. A kinetic study on the surface pressure dependency, stereoselectivity and regioselectivity of native and recombinant SSL or SXL was performed using three dicaprin isomers spread as monomolecular films at the air-water interface. Our results show clearly that the presence of polyhistidine tag at the N-terminus of SSL or SXL changes their stereo- and regioselectivity.     

Influence of a surfactant and electrolytes on adsorbed polymer layers

Solvent relaxation NMR and small-angle neutron scattering have been used to characterize adsorbed poly(ethylene oxide) (PEO) layers on silica at a range of surfactant and electrolyte concentrations. Below the critical aggregation concentration (cac), the results suggest that sodium dodecyl sulfate (SDS) interacts relatively weakly, perhaps analogously to a simple salt reducing the solvency of PEO. This is evidenced by a decrease in the adsorbed layer thickness combined with an increase in the bound fraction, although the total adsorbed amount is not greatly affected. The layer thickness goes through a minimum at the cac, after which further SDS addition results in the formation of PEO/SDS aggregates that repel each other and, hence, tend to desorb. The adsorbed amount therefore decreases, from 0.7 mg m(-2) initially to 0.2 mg m(-2) with 32 mM SDS. The aggregates that remain adsorbed also repel, and hence, there is an increase in the layer thickness and the persistence length, while the bound fraction is reduced. In comparison, the effects of electrolyte at the ionic strength studied are relatively minimal. There is, however, evidence that the repulsions between adsorbed PEO/SDS aggregates are partially screened, allowing them to approach each other more readily. This leads to a contraction of the adsorbed layer when the SDS concentration is sufficiently high.     

Reconstructible and Half-Reconstructible Tournaments: Application to Their Groups of Hemimorphisms

Let T and T¹ be tournaments with n elements, E a basis for T, E′ a basis for T′, and k ≥ 3 an integer. The dual of T is the tournament T” of basis E defined by T(x, y) = T(y, x) for all x, y ε E. A hemimorphism from T onto T′ is an isomorphism from T onto T” or onto T. A k-hemimorphism from T onto T′ is a bijection f from E to E′ such that for any subset X of E of order k the restrictions T/X and T¹/f(X) are hemimorphic. The set of hemimorphisms of T onto itself has group structure, this group is called the group of hemimorphisms of T. In this work, we study the restrictions to n – 2 elements of a tournament with n elements. In particular, we prove: Let k ≥ 3 be an integer, T a tournament with n elements, where n ≥ k + 5. Then the following statements are equivalent: (i) All restrictions of T to subsets with n – 2 elements are k-hemimorphic. (ii) All restrictions of T to subsets with n – 2 elements are 3-hemimorphic. (iii) All restrictions of T to subsets with n – 2 elements are hemimorphic. (iv) All restrictions of T to subsets with n – 2 elements are isomorphic, (v) Either T is a strict total order, or the group of hemimorphisms of T is 2-homogeneous.     

Transfer measurements for the Ti+Ni systems at near barrier energies

Large enhancements have been observed in the sub-barrier fusion cross sections for Ti+Ni systems in our previous studies. Coupled channel calculations incorporating couplings to 2⁺ and 3⁻ states failed to explain these enhancements completely. A possibilty of transfer channels contributing to the residual enhancements had been suggested. In order to investigate the role of relevant transfer channels, measurements of one- and two-nucleon transfer were carried out for ^46,48Ti+⁶¹Ni systems. The present paper gives the results of these studies.