氮杂冠醚与碱金属离子配位反应的研究

滴定量效法是研究反应热化学和热力学的重要手段之一．用这种方法对冠醚与金属离子的配位反应热力学性质进行研究一直受到很大关注【且S习．但是对氨杂冠林，尤其是一系列结构相似的氨杂冠醚体系进行系统的热力学性质研究的报导不多．前文K则曾报导了用自组装的消定量热计对银（I）－a吹体系和铜（11）·N，N’一问位取代革基乙二胺体系的配位反应热化学研究结果·本文报导从（对位取代革基）k杂15冠5卜RPW15CS，R＝CIZH；CHa；CHso）与碘化钠和碘化钾在25T、无水乙过溶液中进行配位反应的消定量效研究结果．讨论了配体上取代基的电…     

健康猕猴血液和毛发微量元素含量的正常值测定和差异比较

对猕猴(Macaca mulatta)血液和毛发的镁、锰、钼、镍、铅、铬、镉、锌、铁、铜、钙等11种元素的含量，用电感耦合高频等离子体发射光谱仪进行了测定．给出了各个元素在血液和毛发中的平均含量值和变动范围．指出毛发中的微量元素含量一般较血液为高，且变动较小．与人体内含量比较，猴毛发的Cu、Mo、CA、Ni的含量与人发接近；猴血液的Zn、Fe、Ca、Mn、Ca亦与人的接近．对猴血液微量元素含量随年龄、体重、性别变化及血液含量和毛发含量的相关关系进行了统计学检验．通过对测定值的比较分析，认为尽管动物体内的微量元素含量随种类、环境、个体差异变化较大，就群体平均含量而言，仍存在着相似的变化规律。本文的测定结果对了解猕猴对微量元素的需要提供了初步依据．     

正交试验法优化CS汽化吸附条件

通过正交试验设计,优化了影响西埃斯(CS)标准样品管制备的参数:汽化温度、采样流速、采样时间。结果表明,CS标准样品管的最佳吸附条件为汽化吸附温度:260℃,采样N2流速:330mL/min,采样时间:15min。在15~1500ng范围内,色谱峰面积与进样量有良好的线性关系,线性相关系数为0.9995,检出限为6.0ng。     

高效液相色谱法测定细胞分裂素的方法研究

利用高效液相色谱法测定水稻愈伤组织和微生物发酵产品中的玉米素，二氢玉米素，核糖基玉米素和核糖基二氢玉米素。样品用抽提液抽提，经Ｂｉｏ－Ｒｅｘ７０弱阳离子交换柱和ＸＡＤ－７／Ｓｅｐ－ｐａｋＣ１８复合柱净化和富集后，直接用ＨＰＬＣ分析，方法回收率达９４％～８４％，相对标准偏差小于３．３％。最低检测限达２．０ｎｇ。     

壳聚糖衍生物的制备及其吸附性能

壳聚糖衍生物的制备及其吸附性能曲荣君，马千里，郑秀丽，孙言志（烟台师范学院化学系烟台２６４０２５）关键词壳聚精衍生物，制备，吸附壳聚糖（ＣＴＳ）是重金瞩离子的吸附剂￣［１，２］，由于壳聚精分子中的－ＮＨ＿２在ｐＨ较低的水溶液易形成而使ＣＴＳ溶于水，造...     

Fabrication of hexaphenylsilole nanowires and their morphology-tunable photoluminescence.

Immersion of nanoporous alumina membranes into saturated solutions of hexaphenylsilole with subsequent solvent evaporation affords aligned organic nanowires. The luminescent properties of the hexaphenylsilole nanowires can be manipulated by varying their morphologies, which were controlled by changing the channel sizes of the alumina templates.     

在硅磷酸镧中Ce^3＋离子对Tb^3＋离子的敏化

实验表明在La2O3·0.01SiO2·0.95P2O5基质中Ce^3 对Tb^3 有强的敏化作用。254nm紫外光激发下温度对Tb^3 激活的Ce^3 、Tb^3 共激活试样的发射强度的Ce^3 、Tb^3 共激活的试样Tb^3 的^5D4→^7F6:5:4跃迁的发射强度随湿度的变化。计算了Ce^3 到Tb^3 的能量传递效率。初步探讨了Ce对Tb的能量传递机理。     

A spectroscopic study on the 12-heteropolyacids of molybdenum and tungsten (H3PMo12−nWnO40) combined with cetylpyridinium bromide in the epoxidation of cyclopentene

The epoxidation of cyclopentene with hydrogen peroxide catalyzed by 12-heteropolyacids of molybdenum and tungsten (H₃PMo_12−nW_nO₄₀, n = 1–11), 12-tungstophosphoric acid and 12-molybdophosphoric acid combined with cetylpyridinium bromide as a phase transfer reagent was carried out in acetonitrile. Among 13 heteropolyacids investigated, catalyst of H₃PMo₆W₆O₄₀ showed the highest activity, giving a conversion of 60% and a selectivity of 95% in the epoxidation of cyclopentene. The fresh catalysts and the catalysts under reaction condition were characterized by UV–vis, FT-IR and ³¹P NMR spectroscopy, which has revealed that all of the molybdotungstophosphoric acids were degraded in the presence of hydrogen peroxide to form a considerable amount of phosphorus-containing species. The active species resulted from H₃PMo₆W₆O₄₀ are new kinds of phosphorus-containing species, which is different from {PO₄[WO(O₂)₂]₄}³⁻.     

钙钛矿型La_((1 x)/2)Sr_((1-x)/2)Co_(1-x)Cu_xO_3催化CO氧化活性与表征

研究了钙钛矿型LaSrCoCu_xO_3催化剂对CO氧化反应的催化活性及其表面氧的催化作用．结果表明，x＝0．4的催化剂对CO氧化具有最高催化活性，常压及本实验条件下CO完全氧化的最低温度为168℃；催化剂均为氧缺陷化合物，吸附于表面晶格氧缺陷上的吸附氧是CO氧化反应的活性氧物种；并发现催化剂中存在有非常价态的C04 ，认为CO氧化反应是通过吸附氧调变Co3 和Co4 价态而进行．     

Use of SPE—TLC for Quality Control of Rhodiola rosea Extracts

SPE and TLC have been used for qualitative and quantitative analysis of salidroside, rosavin, rosarin, and rosin in commercially available dry extracts from Rhodiola rosea roots. The best separation of all the compounds was achieved on silica gel TLC plates with ethyl acetate—methanol—water, 77 + 13 + 10 (v/v), as mobile phase. UV detection was performed at λ = 215 nm for salidroside and at λ= 245 nm for the rosavins (rosavin, rosarin, and rosin). Detection limits for salidroside and the rosavins were 90 ng and 60 ng per spot, respectively. Results from quantitative analysis confirmed the manufacturer’s declaration of the amounts of salidroside and the rosavins in the extracts.