Trifluoromethylated amino alcohols as chiral ligands for highly enantioselective Reformatsky reaction

The enantioselective Reformatsky reaction of PhCHO was achieved by the use of trifluoromethylated amino alcohols as chiral ligands to afford the corresponding optically active β-hydroxy ester with up to 90% ee.     

Simultaneous polymerization and formation of polyacetylene film on the surface of concentrated soluble Ziegler-type catalyst solution

A direct method of simultaneously polymerizing and forming acetylene monomer to produce uniformly thin films of polyacetylene was investigated in terms of catalyst system, catalyst concentration, and polymerization temperature. The best catalyst was a Ti(OC₄H₉)₄–Al(C₂H₅)₃ system (Al/Ti = 3–4) and the critical concentration was 3 mmole/l. of Ti(OC₄H₉)₄. Below the critical concentration, only a solid or a powder was obtained. The configuration of the polymers obtained depends strongly upon the polymerization temperature. Thus an all-cis polymer was obtained at temperatures lower than ?78°C, whereas an all-trans polymer resulted at temperatures higher than 150°C. Observations either in an electron microscope by direct transmission or in a scanning electron microscope showed that the film is composed of an accumulation of fibrils about 200–300 Å in width and of indefinite length.     

Gas Chromatographic Separation of Carbonyl Compounds as Their 2,4-dinitrophenylhydrazones Using Glass Capillary Columns

The gas chromatographic separation of 22 carbonyl compounds as their 2,4-dinitrophenylhydrazones was investigated using glass capillary columns. Complete separation of the 2,4-dinitrophenylhydrazones of ten aliphatic aldehydes, eight aliphatic ketones and four aromatic aldehydes was obtained, except for the derivatives of n-valeraldehyde and isobutyl methyl ketone, whose peaks overlapped, and the o- and m-tolualdehyde derivatives, which were poorly separated. The optimum conditions were as follows: stationary phase, SF-96; column size, 20 m × 0.25 mm I.D. ; column temperature, 200-240°; injection and detector temperatures, 280-290°; carrier gas flow-rate, helium 1.0-1.2 ml/min or nitrogen 1.1-1.2 ml/min. The method was applied to the analysis of aliphatic carbonyl compounds in car exhaust fumes and cigarette smoke.     

Synthesis of block copolymer with polystyrene and nylon units

Bis-ε-aminocaproylaminocaproylhexamethylenediamine ( I ) was synthesized as an analog of 6-nylon pentamer diamine, and its incorporation into block copolymers was studied with the use of α,ω-dihydroxyl, α,ω-bisdimethylchlorosilyl, and α,ω-diepoxy polystyrene. In the course of the experiments, the stability and the reactivity of 4,4′-diphenylmethane diisocyanate and tetramethylene diisocyanate in aprotic dipolar solvents were examined by infrared spectroscopy. The only usable solvent, N-methylpyrrolidone, was found still inadequate for the synthesis involving I, diisocyanate, and α,ω-dihydroxyl polystyrene. A block copolymer having M _n = 18,000 was obtained by the reaction of I and α,ω-diepoxy polystyrene. All T_g values of the block copolymers were above 90°C, higher than for polystyrenes with corresponding molecular weight.     

Solid sampling technique for direct detection of condensed tannins in bark by matrix-assisted laser desorption/ionization mass spectrometry

A novel method for the direct analysis of condensed tannin components in bark was developed on the basis of matrix-assisted laser desorption/ionization mass spectrometry (MALDI-MS) combined with a simple solid sampling technique. The MALDI mass spectra obtained from the wood (bark) powder sample clearly showed a series of peaks corresponding to the sodium ion adducts of condensed tannin oligomers up to around m/z 3000. The results indicate that the condensed tannins in the bark sample used in this work mostly consist of combinations of flavan-3-ol units such as profisetinidin (PF), prorobinetinidin (PR) and prodelphinidin (PD), at least up to 10-mers (m/z approximately 3000).     

Electrochemical and spectral studies on the reductive nitrosylation of water-soluble iron porphyrin

The reaction of iron(III) (meso-tetrakis(N-methylpyridinium-4-yl)porphyrin (Fe(III)TMPyP) with nitric oxide (NO) was studied by electronic absorption spectroscopy, ESR, and electrochemical and spectroelectrochemical techniques in aqueous solutions with pH from 2.2 to 12.0. Fe(III)TMPyP has been found to undergo a reductive nitrosylation in all pHs, and the product of nitric oxide binding to the porphyrin has been determined as iron(II) porphyrin nitrosyl complex ([Fe(II)(NO)TMPyP]). The rate of the reductive nitrosylation exhibits a tendency to get faster with increase in pH. An intermediate species was observed around neutral pH by spectroelectrochemical technique and was proposed to be the iron(II) nitrosyl complex of the mu-oxo dimeric form of FeTMPyP, which is known to be a predominant in neutral solutions.     

Reaction of tetraazathiapentalene and thiadiazolopyrimidine derivatives with heterocumulenes: Cycloaddition and elimination reactions via hypervalent sulfur intermediates

Tetraazathiapentalene derivative 1 reacts with heterocumulenes such as diphenylketene (2) and 2‐pyridylisothiocyanate (5) to give heterocycles 3, 6 and 7 with elimination of methylisothiocyanate. The reactions of thiadiazolopyrimidine derivatives 8a‐b with ethoxycarbonyl isothiocyanate (9) and carbon disulfide (11) gives heterocycles 10 and 12 via thermal decomposition of 1:1 cycloadducts C and D which have a hypervalent sulfur. The mechanistic and reactivity features of these reactions are described.     

Novel polycationic biocides: Synthesis and antibacterial activity of polymeric phosphonium salts

Various polymeric phosphonium salts and the corresponding low-molecular-weight model compounds were prepared and their antibacterial activities against Staphylococcus aureus and Escherichia coli were explored by the viable cell counting method in sterile distilled water. Antibacterial activity of the polymers was found to be higher than that of the corresponding model compounds, particularly against S. aureus. Furthermore, the polymeric phosphonium salt exhibited a higher activity by 2 orders of magnitude than the polymeric quaternary ammonium salt with the same structure except the cationic part. Compounds with the longest alkyl chain (octyl) studied were found to exhibit particularly high activity, and this finding may be ascribed to the contribution of the increased hydrophobicity of the compounds to the cidal activity. © 1993 John Wiley & Sons, Inc.     

The characteristic fragment ions and visualization of cationic starches on pulp fiber using ToF‐SIMS

Time‐of‐flight secondary ion mass spectrometry (ToF‐SIMS) was used to investigate the distribution of cationic starch on pulp fiber. To identify the characteristic fragment ions of the cationic starches, deuterium‐labeled cationic starches were prepared and analyzed using ToF‐SIMS. The starch 2‐hydroxypropyltrimethylammonium chloride derivative generated characteristic fragments at m/z 58 and 59, which were identified as [H₂C?N(CH₃)₂]⁺ and [N(CH₃)₃]^+·, respectively. The fragmentation patterns were also suggested. From the imaging analysis, the adsorption of the cationic starch on fibers was uneven on individual fibers, as well as between fibers. This may have been on account of fiber morphology and structure. On examining scanning electron microscope (SEM) images, the quaternary ammonium starch derivative (QS) did not penetrate the fiber. No migration of cationic starch was observed under various drying conditions. Copyright © 2007 John Wiley & Sons, Ltd.