Quantitative analysis of methylguanidine and guanidine in physiologic fluids by high-performance liquid chromatography-fluorescence detection method.

A rapid and sensitive high-performance liquid chromatographic method has been developed for the quantitative analysis of methylguanidine and guanidine in physiological fluids. These quanidino compounds are separated on a 6 x 0.23 cm cation-exchange column with 0.5 M sodium hydroxide solution. The guanidino compounds are detected with a fluorometer, which monitors the fluorescent guanidine derivatives produced by the reaction of the eluted constituents with 9,10-phenanthrenequinone. Sensitivity to sub-nanomole levels of methylguanidine and guanidine is demonstrated. The method was successfully applied to physiological fluids such as serum and cerebrospinal fluid from uremic patients.     

Determination of trace elements in carbonates by instrumental neutron activation analysis

A systematic non-destructive determination of eighteen trace elements (F, Na, Cl, Sc, Mn, Zn, Br, Sr, I, Ba, La, Ce, Sm, Eu, Tb, Yb, Th and U) in carbonate samples by thermal neutron activation analysis was developed. Three 0.2–0.5g samples were irradiated for 15 sec (in the case of determination of F), for 3 min (in the case of Na, Cl, Mn, Sr and I) and for 60 hrs (in the case of Sc, Zn, Br, Ba, La, Ce, Sm, Eu, Tb, Yb, Th and U) in the TRIGA MARK II Reactor at a thermal neutron flux of 5·10¹¹ n·cm⁻²·sec⁻¹ (15 sec and 3 min irradiation) and 1.5·10¹²n·cm⁻²·sec⁻¹ (60 hrs irradiation), respectively. According to the half life of the nuclides formed, the activities were measured with a Ge(Li) spectrometer as follows,²⁰F∶15 sec counting after 20–25 sec cooling,²⁴Na,³⁸Cl,⁵⁶Mn,^87mSr and¹²⁸I∶600 sec couting after 30–120 min cooling,⁸²Br,¹⁴⁰La,¹⁵³Sm,¹⁷⁵Yb and²³⁹Np (daughter of²³⁹U)∶3000 sec counting after 1 week cooling,⁴⁶Sc,⁶⁵Zn,¹³¹Ba,¹⁴¹Ce,¹⁵²Eu,¹⁶⁰Tb and²³³Pa (daughter of²³³Th)∶5000 sec counting after 1 month cooling. The errors due to the fluctuation of the neutron flux and the counting geometry were minimized by the use of calcium determined previously with EDTA-titration as an internal standard. The interferences from²⁴Mg(n, p)²⁴Na and²³⁵U(n, fission) reactions were corrected by the activities produced by the reactions in unit weight of magnesium and uranium, and their concentrations in samples measured experimentally. The data of Na, Mn, Zn and Sr were compared with the results obtained by atomic absorption analysis.     

Determination of traces of lead and copper in foods by electrothermal atomic absorption spectrometry with metal atomizer

Summary A method is described for the determination of traces of lead and copper in foods by a microcomputer-processed atomic absorption spectrometry with a molybdenum micro-tube atomizer. Accurate results of lead and copper are obtained by atomization in the presence of thiourea. Thiourea contributes to a highly reproducible atomization profile and reduction of interferences from concomitant elements in foods. Solid samples are digested with nitric acid in the Uni-seal decomposition vessel, while liquid or water-soluble samples are directly atomized.

---

Bestimmung von Blei- und Kupferspuren in Lebensmitteln durch elektrothermische AAS mit einem Metallzerstäuber

Zusammenfassung Ein Verfahren zur Bestimmung von Blei- und Kupferspuren in Lebensmitteln mittels mikrocomputer-gesteuerter AAS mit einem Zerstäuber aus Molybdän wurde beschrieben. Die Zerstäubung in Gegenwart von Thioharnstoff gibt genaue Resultate. Dieser führt zu einem gut reproduzierbaren Zerstäubungsprofil und setzt die Störung von Begleitelementen herab. Feste Proben werden mit Salpetersäure aufgeschlossen, flüssige oder wasserlösliche Proben werden unmittelbar eingesetzt.

     

Simultaneous ion-exclusion/cation-exchange chromatography of anions and cations in acid rain waters on a weakly acidic cation-exchange resin by elution with sulfosalicylic acid

A simple, selective, and sensitive method for the simultaneous determination of anions (sulfate, nitrate, and chloride) and cations (sodium, ammonium, potassium, magnesium, and calcium) in acid rain waters was developed using ion-exclusion/ cation-exchange chromatography with conductimetric detection. A weakly acidic cation-exchange resin column (Tosho TSKgel OA-PAK-A) and a sulfosalicylic acid-methanol-water eluent was used. With a mobile phase comprising 1.25 mM sulfosalicylic acid in methanol-water (7.5:92.5) at 1.2 ml/min, simultaneous separation and detection of the above anions and cations was achieved in about 30 min. Linear calibration plots of peak area versus concentration were obtained over the concentration ranges 0-1.0 mM for anions (R=0.9991) and 0-0.5 mM for cations (R=0.9994). Detection limits calculated at S/N=3 ranged from 4.2 to 14.8 ppb for the anions and from 2.4 to 12.1 ppb for the cations. The reproducibility of retention times was 0.14-0.15% relative standard deviation (RSD) for anions and 0.18-0.31% for cations, and reproducibility of chromatographic peak areas was 1.22-1.75% RSD for anions and 1.81-2.10% for cations. The method was applied successfully to the simultaneous determination of anions and cations in aerosols transported from mainland China to central Japan, as determined by a meteorological satellite data analyzer.     

Investigation of the crystal structure and the structural and magnetic properties of SrCu2(PO4)2

SrCu2(PO4)2 was prepared by the solid-state method at 1153 K. Its structure was solved by direct methods in the space group Pccn (No. 56) with Z = 8 from synchrotron X-ray powder diffraction data measured at room temperature. Structure parameters were then refined by the Rietveld method to obtain the lattice parameters, a = 7.94217(8) A, b = 15.36918(14) A, and c = 10.37036(10) A. SrCu2(PO4)2 presents a new structure type and is built up from Sr2O16 and Cu1Cu2O8 units with Cu1...Cu2 = 3.256 A. The magnetic properties of SrCu2(PO4)2 were investigated by magnetic susceptibility, magnetization up to 65 T, Cu nuclear quadrupole resonance (NQR), electron-spin resonance, and specific heat measurements. With spin-dimer analysis, it was shown that the two strongest spin-exchange interactions between Cu sites result from the Cu1-O...O-Cu2 and Cu2-O...O-Cu2 super-superexchange paths with Cu1...Cu2 = 5.861 A and Cu2...Cu2 = 5.251 A, and the superexchange associated with the structural dimer Cu1Cu2O8 is negligible. The magnetic susceptibility data were analyzed in terms of a linear four-spin cluster model, Cu1-Cu2-Cu2-Cu1 with -2J(1)/kB = 82.4 K for Cu1-Cu2 and -2J(2)/k(B) = 59 K for Cu2-Cu2. A spin gap deduced from this model (Delta/kB = 63 K) is in agreement with that obtained from the Cu NQR data (Delta/kB = 65 K). A one-half magnetization plateau was observed between approximately 50 and 63 T at 1.3 K. Specific heat data show that SrCu2(PO4)2 does not undergo a long-range magnetic ordering down to 0.45 K. SrCu2(PO4)2 melts incongruently at 1189 K. We also report its vibrational properties studied with Raman spectroscopy.     

Appearance of pure fluorocarbon micelles surveyed by fluorescence quenching of amphiphilic quinoline derivatives in fluorocarbon and hydrocarbon surfactant mixtures

A halide-sensitive fluorescence probe was utilized to evaluate the miscibility of fluorocarbon and hydrocarbon surfactants in aqueous micellar systems. The fluorescence of 6-methoxy-N-1,1,2,2-tetrahydroheptadecafluorodecylquinolinium chloride, FC10MQ, was quenched by halide ions dissociated from the surfactant. The fluorescence in micellar solutions showed an initially rapid decay. This suggests that halide ions effectively quench FC10MQ fluorescence at the micellar surface. The subsequent slow decay corresponds to the quenching of FC10MQ fluorescence in the aqueous bulk phase by the free counterions. The Stern-Volmer plots for fluorescence quenching gave a distinct break at the critical micelle concentration of the cationic surfactants. The abrupt increase in fluorescence quenching is attributed to the solubilization of the probe in the micelles. The fluorescence quenching behavior provides direct information about the immiscibility of fluorocarbon and hydrocarbon species in micelles, and the results indicate that almost pure fluorocarbon micelles appear in surfactants mixtures.     

Analysis of the temperature dependence of the high-frequency EMR spectra of Mn ions in the lithium-ion battery material LiMn<Subscript>2</Subscript>O<Subscript>4</Subscript>

This paper deals with the analysis of the temperature dependence of high-frequency EMR (HF-EMR) spectra due to Mn³⁺ and Mn⁴⁺ ions in the lithium manganese spinel LiMn₂O₄. A range of powder samples obtained by the sol-gel method with calcinations in several temperature ranges were prepared for this study. Based on the initial characterization carried out by a number of techniques, the physicochemical and structural properties of the samples were earlier determined. Independently, temperature magnetization and HF-EMR measurements were carried out. The EMR spectra vary strongly between samples, indicating possible structural or chemical changes. Quantitative analysis of the temperature dependence of the HF-EMR spectra due to Mn³⁺ and Mn⁴⁺ ions in LiMn₂O₄ is presented in this paper. The spectral analysis concerns the line shape, linewidth, intensity and g-factors. Fittings using the Lorentzian spectral shape and, to a certain extent, the Gaussian spectral shape have been carried out in order to parameterize the temperature dependence of the HF-EMR spectra. This parameterization of the HF-EMR experimental data enables a deeper characterization of the samples. Subsequently, a better insight into the role of the Mn³⁺ and Mn⁴⁺ ions in accounting for the characteristics most suitable for application of LiMn₂O₄ as a cathode material may be gained.     

Efficient synthesis of an optically active tetrahydrozerumbone exhibiting a fragrance and the application of zerumbone derivatives with a medium ring structure

(R)-Tetrahydrozerumbone 2, which has a powerful balmy fragrance, contains a stereogenic carbon at the C2 position and can be easily prepared from zerumbone 1, one of the most important materials displaying an NMRDOS character. The reduction of 2 gave two diastereomers of tetrahydrozerumbol 3, and the optically active (>99%ee) alcohols were obtained by a lipase-catalyzed stereoselective transesterification of each racemic alcohol. A barrier to this development is a long reaction time (about four weeks) and the need to separate the diastereoisomers. The desired (2R)-form of 3 was efficiently obtained by a lipase-catalyzed transesterification under optimized conditions using a diastereomeric mixture of racemic 3 as the starting material without separation of the diastereomers. Using this method, the reaction of other zerumbone derivatives is greatly improved.