On-line coupling of sequential injection extraction with restricted-access materials for sample clean-up and analysis of drugs in biological matrix

In this contribution, the on-line coupling of solid phase extraction (SPE), based on a restricted-access material (RAM), with sequential injection technique (SIA) for the analysis of biological samples, is described. The SIA-RAM system was tested with a new potential antileucotrienic drug (VUFB-19363 (Quinlukast)) for serum analysis. The method is based on SPE with the novel internal-surface reversed-phase column packing material-alkyl-diol silica (ADS). The supports tolerate direct and repetitive injection of proteinaceous fluids (plasma, serum) and allow reversed-phase partitioning at the internal surface. A column packed with a 25 microm C18 alkyl-diol support was used for direct serum injection. Using a 6-port selection valve and the system of three mobile phases, the polar matrix compounds and metabolites are removed by sequentially aspirated mobile phases with lower content of the organic part (methanol-water (2:98) and following acetonitrile-water (20:80)) to the waste, and then, the analyte enriched on the column is eluted by a strong mobile phase (acetonitrile-methanol-water (40:20:40)) to the UV detector without transfer loss. With the fully automated SIA system, a total analysis time of less than 10 min was achieved. The only off-line sample pre-treatment step required to remove particulate matter was centrifugation. The studies showed a range of linearity (2-40 microg ml(-1)) and a high recovery (93.6-96.8%) of drug from the biological matrix with coefficients of variation (RSD) less than 5.0% (n = 6). This paper introduces a new, simple and robust analytical technique suitable for screening determination and direct analysis of drugs in biological materials.     

Diastereoselective Spirocyclization of C-(Alkyloxycarbonyl)formimines of 2-Substituted 1HIndole-3-ethanamines (= Tryptamines): Basic Studies. 5th Communication on Indoles,Indolenines, and Indolines

C-(Alkoxycarbonyl)formimines of type 15–18 were derived from the 2-substituted tryptamines 2 , 9 , 10 , and 11 and transformed with tosyl chloride into tricyclic 3-spiroindoles of types 19–22 (Scheme 3). The influence of the homochiral alkoxy moieties A–D on the stereochemical outcome of this reaction was studied. Good-to-excellent diastereoselectivities were observed with the (?)-8-(phenylmenth-3-yl)oxy group ( B ) as homochiral auxiliary. The structures of the tricycles 4 , (2′R,3S)- 19B , and (2′S,3R) 20C were established by X-ray analysis, the structures of the others by NOE and CD studies, and by chemical correlation. Possibilities to explain the steric course of the spirocyclizations are discussed.     

Synthesis of a simplified bryostatin C-ring analogue that binds to the CRD2 of human PKC-alpha and construction of a novel BC-analogue by an unusual Julia olefination process

[structure: see text] The synthesis of two truncated bryostatin analogues 2 and 3 is described. High-field NMR measurements on the C-ring analogue 3 in C(2)H(3)CN containing 25% (2)H(2)O have shown that it binds to the CRD2 of human PKC-alpha at virtually the same position as phorbol-13-acetate (PA) and bryostatin 1 (1). NMR titration studies have also revealed that 3 binds to the CRD2 with a potency similar in magnitude to PA but much less potently than 1.     

Beitr?ge zur Bestimmung von Spurenverunreinigungen in UO2-Kernbrennstoff

Zusammenfassung Die für die Bestimmung geringer Gehalte an Phosphor, Silicium, Fluor, Chlor, Lithium, Natrium, Calcium und Kohlenstoff in UO₂-Kernbrennstoff angewandten chemischen Analysenverfahren werden beschrieben. Durch Kombination einfacher und blindwertfreier Abtrennungsverfahren (Extraktionen und Pyrohydrolysen) mit empfindlichen physikalischchemischen Bestimmungsmethoden (Spektralphotometrie, Flammenphotometrie, coulometrische Titration) lassen sich Nachweisgrenzen zwischen 0,1 und 10 ppm bei Probeneinwaage von 0,5–1 g UO₂ erreichen. Der Zeitaufwand für die Analysen kann durch simultane Bestimmung zweier oder dreier Elemente in einem Arbeitsgang niedriggehalten werden. Die beschriebenen Verfahren haben sich bei Reinheitskontrollen von Kernbrennstoffen gut bewährt.

---

Summary Analytical methods have been developed for the determination of trace amounts of phosphorus, silicon, fluorine, chlorine, lithium, sodium, calcium, and carbon in UO₂ of nuclear purity. By combination of simple and rapid separation procedures (extraction, pyrohydrolysis) with highly sensitive methods of determination (spectrophotometry, flame photometry, coulometric titration) detection limits of 0.1–10 ppm have been obtained with sample sizes of 0.5–1 g. In order to reduce the time needed for analysis, some of the above elements are determined simultaneously. The methods described have been successfully applied to the purity control of nuclear fuels.

---

---

Herrn Dr. W. Gebauhr danken wir für wertvolle Anregungen und Diskussionen.     

Quantitative Bestimmung der Catechine und Hydroxyzimts?uren in pflanzlichen Lebensmitteln

Zusammenfassung Die Problematik der Bestimmung von Catechinen und Hydroxyzimtsäuren in pflanzlichen Lebensmitteln wird diskutiert und gezeigt, daß es notwendig ist, eine ausreichende Vorreinigung (Säulen-Chromatographie an Polyamid und Dünnschicht-Chromatographie an Cellulose bzw. Kieselgel) mit einem geeigneten Bestimmungsverfahren (Spektralphotometrie mit Vanillin/Salzsäure bzw. direkt) zu kombinieren. Beispiele werden beschrieben.Plenarvortrag anläßlich der Tagung Spurenanalyse, 2.–5. April 1973 in Erlangen.     

Zur Fehlerermittlung bei der photometrischen Eisenbestimmung in Glassanden

Zusammenfassung Zur Bestimmung des Eisengehaltes in Glassanden eignet sich die o-Phenanthrolinmethode, da diese Methode frei ist von störenden Einflüssen der im Sand neben dem Eisen vorliegenden Fremdionen.Der Analysenfehler wird dabei aus den Eichmessungen nach den Methoden der Ausgleichsrechnung und mathematischen Statistik rechnerisch ermittelt und bei der Auswertung des Analysenergebnisses in geeigneter Form berücksichtigt.

---

Summary For the determination of the iron content in glass sands the o-phenanthroline method is suitable because it is unaffected by foreign ions occuring in the sand besides iron.The analytical error is calculated from the calibrating measurements according to the methods of balancing computation and mathematical statistics, and is taken into account on interpreting the analytical result in a suitable form.

---

---

Herrn Dr. Moritz danken wir für die Anregung zu dieser Arbeit, Herrn Dr.-Ing. habil. Klaus Doerffel für wertvolle Hinweise zur mathematischen Auswertung.     

Propane fuel cells using phosphoric-acid-doped polybenzimidazole membranes

Propane fuel cells using H(3)PO(4)-doped polybenzimidazole polymer membranes produce low and unsustainable current densities at temperatures up to 250 degrees C under anhydrous conditions. Stable intermediate species blocked the surface of noble metal anode catalysts, and the intermediate species could not react further into desorbable final products. In contrast, when water was introduced by light humidification (S(r) 0.08%) of the propane stream, sustainable and higher current densities were achieved. Water participated in the reaction sequence to form surface-bound hydrocarbon and then oxygen-containing intermediates and thereby generated CO and CO(2) as the only carbon-containing products.     

Surface tension of quantum fluids from molecular simulations

We present the first molecular simulations of the vapor-liquid surface tension of quantum liquids. The path integral formalism of Feynman was used to account for the quantum mechanical behavior of both the liquid and the vapor. A replica-data parallel algorithm was implemented to achieve good parallel performance of the simulation code on at least 32 processors. We have computed the surface tension and the vapor-liquid phase diagram of pure hydrogen over the temperature range 18-30 K and pure deuterium from 19 to 34 K. The simulation results for surface tension and vapor-liquid orthobaric densities are in very good agreement with experimental data. We have computed the interfacial properties of hydrogen-deuterium mixtures over the entire concentration range at 20.4 and 24 K. The calculated equilibrium compositions of the mixtures are in excellent agreement with experimental data. The computed mixture surface tension shows negative deviations from ideal solution behavior, in agreement with experimental data and predictions from Prigogine's theory. The magnitude of the deviations at 20.4 K are substantially larger from simulations and from theory than from experiments. We conclude that the experimentally measured mixture surface tension values are systematically too high. Analysis of the concentration profiles in the interfacial region shows that the nonideal behavior can be described entirely by segregation of H(2) to the interface, indicating that H(2) acts as a surfactant in H(2)-D(2) mixtures.     

The thiazolium-catalyzed Sila-Stetter reaction: conjugate addition of acylsilanes to unsaturated esters and ketones

A new acyl anion addition reaction between acylsilanes and alpha,beta-unsaturated conjugate acceptors promoted by a nucleophilic organic catalyst has been disclosed. The 1,4-dicarbonyl products produced in this reaction are highly useful synthons. Neutral carbenes (or zwitterions) generated in situ from commercial thiazolium salts are used as effective catalysts for the reaction which is in contrast to established anionic catalysts typically employed to promote the required Brook rearrangement (1,2-silyl shift from carbon to oxygen) involved in the reported reaction. This process successfully utilizes acylsilanes as tunable acyl anion progenitors and is tolerant of a wide range of structural diversity on the acylsilane or the conjugate acceptor.     

Pyrolysis studies of aromatic polyesters

The products of pyrolysis, at 400°C in vacuo (1 Pa), of poly(ethyleneterephthalate) (PET) and poly(butyleneterephthalate) (PBT) were studied. The products were identified by gas chromatography/mass spectrometry technique. The highly volatile products of PET contained acetaldehyde, benzene, toluene, styrene and ethylbenzene and in the case of PBT, butadiene, tetrahydrofuran, vinylcyclohexene and ethylbenzene were the major products. A qualitative analysis of the products of low volatility revealed that the main components were benzoic acid, terephthalic acid, monovinyl esters of terephthalic acid and higher oligomers in the case of PET, whereas benzoic acid, monobutenyl esters of terephthalic acid and higher oligomers were the main products from PBT. The results obtained were in good agreement with those obtained from pyrolysis experiments, carried out directly in the mass spectrometer. Mechanisms to explain the occurrence of the different products are proposed.