Simultaneous determination of dopa and carbidopa enantiomers by capillary zone electrophoresis

Dopa and carbidopa, components of the dual therapy for Parkinson's disease treatment, are both provided as single enantiomers, since their D-forms are inactive. To ensure the efficiency and safety of the therapy, these D-enantiomers, therefore, should be considered as impurities. In this paper, the enantioseparation power of different types of cyclodextrins, both neutral and charged ones, on dopa and carbidopa enantiomers was tested. Three methods of simultaneous separation of dopa and carbidopa enantiomers were developed, using highly sulfated beta-cyclodextrin and sulfated beta-cyclodextrin as chiral selector, in normal and reversed polarity mode. Two methods among these three were found sensitive enough for the quantitation of 0.1% D-enantiomers in L-forms (impurity level). After the optimization study, the best method was selected, using 16 mM sulfated beta-cyclodextrin in 15 mM sodium phosphate buffer pH 2.45, an uncoated fused-silica capillary (50 num inner diameter, 30 cm total length), and an applied voltage of -12 kV. This method is robust and efficient, with very high resolution for all peaks within a short analysis time of 10 min. Quantitatively, the method offers a limit of detection (LOD) of 0.2 nug/mL and a limit of quantitation (LOQ) of 0.5 nug/mL for both D-dopa and D-carbidopa, which is equivalent to 0.02% and 0.05% against the respective L-enantiomers. A linear relationship was found between the concentration of the analyte and the corresponding peak area in a range of 0.5-2.0 nug/mL.     

In vitro synthesis of (1→3)-β-D-glucan (callose) and cellulose by detergent extracts of membranes from cell suspension cultures of hybrid aspen

The aim of this work was to optimize the conditions for in vitro synthesis of (1→3)-β-D-glucan (callose) and cellulose, using detergent extracts of membranes from hybrid aspen (Populus tremula × tremuloides) cells grown as suspension cultures. Callose was the only product synthesized when CHAPS extracts were used as a source of enzyme. The optimal reaction mixture for callose synthesis contained 100 mM Mops buffer pH 7.0, 1 mM UDP-glucose, 8 mM Ca²⁺, and 20 mM cellobiose. The use of digitonin to extract the membrane-bound proteins was required for cellulose synthesis. Yields as high as 50% of the total in vitro products were obtained when cells were harvested in the stationary phase of the growth curve, callose being the other product. The optimal mixture for cellulose synthesis consisted of 100 mM Mops buffer pH 7.0, 1 mM UDP-glucose, 1 mM Ca²⁺, 8 mM Mg²⁺, and 20 mM cellobiose. The in vitroβ-glucans were identified by hydrolysis of radioactive products, using specific enzymes. ¹³C-Nuclear magnetic resonance spectroscopy and transmission electron microscopy were also used for callose characterization. The (1→3)-β-D-glucan systematically had a microfibrillar morphology, but the size and organization of the microfibrils were affected by the nature of the detergent used for enzyme extraction. The discussion of the results is included in a short review of the field that also compares the data obtained with those available in the literature. The results presented show that the hybrid aspen is a promising model for in vitro studies on callose and cellulose synthesis.     

Determination of the conformation of 1,4-diheterocyclanes. I—The 1H n.m.r. spectrum and ring conformation of 3-methyl-2-oxo-1,4-dioxepane

The ¹H n.m.r. spectrum of 3-methyl-2-oxo-1,4-dioxepane was recorded at 300 and 60 MHz. The ring conformation was considered in terms of the spectral parameters and shown to be a twisted boat where the lactone grouping is approximately planar.     

2D NMR characterization of poly(ethylene-co-5-vinyl-2-norbornene)

Unsaturated poly(ethylene-co-5-vinyl-2-norbornene) was synthetized using the [Ph₂C(Flu)(Cp)]ZrCl₂ metallocene/methylaluminoxane (MAO) catalyst system. ¹H and ¹³C NMR spectra of the copolymer were assigned by means of DEPT, homonuclear 2D ¹H-¹H COSY, and heteronuclear 2D ¹H-¹³C correlation NMR experiments. The used catalyst system produces mainly isolated 5-vinyl-2-norbornene (VNB) sequences. VNB is incorporated selectively via the cyclic double bond. The unreacted double bond of the copolymer exists in the 5-endo: 5-exo positions (3 : 1). Both isomers of VNB are polymerized with the same propability.     

Heterogenization of racemic ethylenebis(1-indenyl)zirconium dichloride on trimethylaluminum vapor modified silica surface

Heterogeneous metallocene catalysts were prepared by adsorbing rac-Et(Ind)₂ZrCl₂ on a modified silica surface in solution. The modification of silica was conducted in gas phase with atomic layer chemical vapor deposition (ALCVD) technique, where the silica, preheated at either 350 or 600°C, was allowed to react with vaporized trimethylaluminum (TMA) at 250°C. Modified carriers and heterogeneous catalysts were characterized with FTIR, ¹H MAS (magic-angle spinning) NMR, ¹³C, and ²⁹Si CP (cross-polarization) MAS NMR spectroscopies and elemental analyses. In the reaction of TMA with silica, a saturated surface was formed consisting of different (---O)_4−nSi(CH₃)_n (n=1, 2 or 3) and ---AlCH₃ groups. The ratio of ---SiMe to ---AlMe groups was approximately 1.5 in the TMA/SiO₂ carriers. When the metallocene was adsorbed onto the carrier it seemed to react with the surface ---AlCH₃ groups and possibly ---ZrCH₃ groups were formed. Heterogeneous catalysts were tested in the polymerization of ethylene and propylene in the presence of methylalumoxane (MAO). And they produced similar polymer as the homogeneous rac-Et(Ind)₂ZrCl₂ catalyst, but with lower activity. A catalyst with the best activity was achieved from silica that was preheated at 600°C. Moreover, leaching of catalyst was examined whereupon a part of zirconium was observed to desorb from the carrier.     

Determination of Stoichiometric Dissociation Constants of Benzoic Acid in Aqueous Sodium or Potassium Chloride Solutions at 25°C

Equations were determined for the calculation of the stoichiometric (molality scale) dissociation constant K_m of benzoic acid in dilute aqueous NaCl and KCl solutions at 25°C from the thermodynamic dissociation constant K_a of this acid and from the ionic strength I_m of the solution. The salt alone determines mostly the ionic strength of the solutions considered in this study and the equations for K_m were based on the single-ion activity coefficient equations of the Hückel type. The existing literature data obtained by conductance measurements and by electromotive force (EMF) measurements on Harned cells were first used to revise the thermodynamic value of the dissociation constant of benzoic acid. A value of K_a = (6.326 ± 0.005) × 10^-5 was obtained from the most precise conductivity set [Brockman and Kilpatrick] and this value is supported within their precisions by the less precise conductivity set of Dippy and Williams and by the EMF data set measured by Jones and Parton with quinhydrone electrodes. The new data measured by potentiometric titrations in a glass electrode cell were then used for the estimation of the parameters of the Hückel equations of benzoate ions. The resulting parameters were also tested with the existing literature data measured by cells with and without a liquid junction. The Hückel parameters suggested here are close to those determined previously for anions resulting from aromatic and aliphatic carboxylic acids. By means of the calculation method based on the Hückel equations, K_m can be obtained almost within experimental error at least up to I_m of about 0.5 mol-kg_-1 for benzoic acid in NaCl and KCl solutions.     

Activation of crystalline cellulose surfaces through the chemoenzymatic modification of xyloglucan

Cellulose constitutes an important raw material for many industries. However, the superb load-bearing properties of cellulose are accompanied by poor chemical reactivity. The hydroxyl groups on cellulose surfaces can be reacted but usually not without loss of fiber integrity and strength. Here, we describe a novel chemoenzymatic approach for the efficient incorporation of chemical functionality onto cellulose surfaces. The modification is brought about by using a transglycosylating enzyme, xyloglucan endotranglycosylase, to join chemically modified xyloglucan oligosaccharides to xyloglucan, which has a naturally high affinity to cellulose. Binding of the chemically modified hemicellulose molecules can thus be used to attach a wide variety of chemical moieties without disruption of the individual fiber or fiber matrix.