Spectrochemical determination of lithium,sodium, potassium and rubidium in rocks and minerals using the stallwood jet

A D C, spectrochemical method using the STALLWOOD jet has been developed for the determination of Li, Na, K and Rb in silicate minerals and rocks. Samples are mixed with graphite and Cs₂CO₃ in tho ratio 2 : 1 : 1, and Cs serves as internal standard. Precision and accuracy is satisfactory.     

Developments in suppressor technology for inorganic ion analysis by ion chromatography using conductivity detection

A review is presented detailing the development and use of suppression devices for the conductimetric detection of inorganic ions by ion chromatography (IC). An overview of the general response equation for conductivity detection is also given. Topics of discussion include the role and function of suppressors, the development of early suppressors including packed column and membrane devices from 1975 to 1990 and the subsequent progression towards present day commercially available suppressors and recent innovations. Post-suppression devices for signal enhancement are also discussed.     

Mutual Solubilities of Water and Alkanes

Summary.  The evaluation of mutual solubility data for systems water with n-alkanes, isoalkanes, and cycloalkanes along the three phase line is reported and a formula for the prediction of solubility of alkanes in water is developed. Then a cubic equation of state with an added term, which accounts for hydrogen bonding is used for correlation of liquid–liquid equilibrium data and for prediction of solubility of water in hydrocarbons using alkane in water solubility data. Comparison of the predicted and experimental solubilities is performed using all accessible experimental data. With this approach it is possible to predict the solubilities of water in alkanes with good accuracy over the temperature range up to about 20 K below critical temperature. Solubility of alkanes in water can also be calculated using experimental data for solubility of water in alkanes but results of these calculations are more sensitive to experimental errors of the data. Corresponding author: E-mail: macz@ichf.edu.pl Received August 5, 2002; accepted (revised) September 13, 2002 Published online March 13, 2003 RID="a" ID="a" Dedicated to Prof. Dr. H. Gamsj?ger on the occasion of his 70^th birthday anniversary     

Isomerization of hydrocarbon ions. VIII—The electron impact induced decomposition of n-dodecane

The literature on the mass spectrometry of ²H and ¹³C labelled higher alkanes is reviewed and the decomposition behaviour of both the molecular and the fragment ions of n-dodecane, n-dodecane-1, 12-[¹³C₂] and n-dodecane-1,1,1,12,12,12-[²H₆] studied with special emphasis on metastable decompositions. It is shown that the elimination of alkane molecules and alkyl radicals from the n-dodecane molecular ion occurs primarily by simple splitting of the C? C bond. In addition, both small alkane molecule and alkyl radicals are eliminated with low probability from centreal parts of the molecular ion. The alkane elimination is less specific than the alkyl elimination. The methyl elimination shows an exceptionally high non-specificity, but is of negligible abundance in the 70 e V electron impact spectrum. The metastable ion spectra suggest, but do not prove unambiguously, that those small alkyl ions (with up to four carbon atoms) originating directly from the molecular ion, may be formed both by direct cleavage of the terminal groups and from central parts of the molecular ion. However, the majority of the small alkyl fragment ions in the 70 eV spectrum are formed by secondary decomposition explaining their apparent non-specific formation. The strikingly different fragmentation behaviour of even electron, [C_nH_2n+1]⁺, and odd electron fragment ions, results from differences in the product stabilities. Using collisional activation and metastable ion spectra it is shown that the odd electron fragments have the structure of the linear alkene (most probably the 1-alkene) molecular ion. In contrast to the molecular ions, alkyl fragment ions decompose with complicated skeletal rearrangements, which lead to substantial, but not complete, carbon randomization. The terminal hydrogen atoms, however, show little scrambling.     

Amino acid analysis by micellar electrokinetic chromatography with laser-induced fluorescence detection: application to nanolitre-volume biological samples from Arabidopsis thaliana and Myzus persicae

Amino acids were derivatised with 4-fluoro-7-nitrobenzo-2,1,3-oxadiazol (NBD-F), separated by micellar electrokinetic chromatography (MEKC), and detected by argon-ion (488 nm) laser-induced fluorescence. The optimised MEKC background electrolyte conditions were: 40 mM sodium cholate, 5 mM beta-cyclodextrin in 20 mM aqueous borate buffer, pH 9.1, with 7% v/v acetonitrile. Using these conditions, 19 amino acids were separated within 17 min. The limits of detection were in the range of 7.6-42.2 pmol/mL and limits of quantitation from 0.05-0.14 nmol/mL. The method was systematically validated for injection volume error, migration time variation, calibration linearity, accuracy, precision, and recovery. Nanolitre volume samples of phloem sap of individual sieve element cells from the plant Arabidopsis thaliana and honeydew from the aphid Myzus persicae were directly analysed with this method. Quantitative amino acid concentrations in these two biological matrices were profiled for the first time. This method is particularly important because it allows the complete profile of the amino acids obtained from individual phloem elements, allowing cell to cell and plant to plant variation to be quantified, which to date has not been possible with Arabidopsis thaliana.     

Quantum yield of the iodide-iodate chemical actinometer: dependence on wavelength and concentrations

The quantum yield (QY) of the iodide-iodate chemical actinometer (0.6 M KI-0.1 M KIO3) was determined for irradiation between 214 and 330 nm. The photoproduct, triiodide, was determined from the increase in absorbance at 352 nm, which together with a concomitant measurement of the UV fluence enabled the QY to be calculated. The QY at 254 nm was determined to be 0.73 +/- 0.02 when calibration was carried out against a National Institute of Standards and Technology traceable radiometer or photometric device. At wavelengths below 254 nm the QY increased slightly, leveling off at -0.80 +/- 0.05, whereas above 254 nm the QY decreases linearly with wavelength, reaching a value of 0.30 at 284 nm. In addition, the QY was measured at different iodide concentrations. There is a slight decrease in QY going from 0.6 to 0.15 M KI, whereas below 0.15 M KI the QY drops off sharply, decreasing to 0.23 by 0.006 M KI. Calibration of the QY was also done using potassium ferrioxalate actinometry to measure the irradiance. These results showed a 20% reduction in QY between 240 and 280 nm as compared with radiometry. This discrepancy suggests that the QY of the ferrioxalate actinometer in this region of the spectrum needs reexamination.     

Infrared spectroscopic studies of polystyrene emulsion polymers: Effect of oxidation during polymerization

Infrared spectroscopy was empolyed to study the nature of the structural changes which occurred through oxidation during the emulsion polymerization of styrene. Aliphatic carboxylic, amino, and phosphate emulsifiers and hydrogen peroxide and potassium persulfate initiators were empolyed for polymer preparation. In addition, a polystyrene dispersion prepared in the absence of any emulsifier or stabilizer was examined. Irrespective of the nature of the initiator–emulsifier combination employed, all of the polymer spectra revealed bands at 1705 and 1770 cm.^?1. The band at 1705 cm.^?1 was assigned in part to the carbonyl stretching mode of dimertic carboxylic acid, formed by oxidation, in the polystyrene chains. Absorption at 1770 cm.^?1, which was very weak, was tentatively attributed to the carbonyl stretching mode of the monomeric form of this acid. The structure of the acid endgroup was not established, but the results obtained suggest that it was possibly a phenylacetic acid residue or a residue with a similar structure.     

THE CHLOROPHYLL-SENSITIZED REACTION BETWEEN BENZOQUINONE AND ETHANOL*

The electron-transfer reaction between triplet excited chlorophyll and quinones has been extensively studied as a model of the primary reaction in photosystem II. There has also been reported a minor reaction in which the chlorophyll cation radical ostensibly oxidizes the alcohol solvent or even water, leading to a gradual net reduction of quinone, but the exact mechanism and even the existence of this reaction has been uncertain. We have examined the consequences of prolonged irradation of ethyl chlorophyllide and benzoquinone in acidulated ethanol, and find a chlorophyllide-sensitized reaction which is not analogous to the better-known autosensitized reduction of quinones in blue or UV light. In the chlorophyllide-sensitized reaction, benzoquinone is apparently converted to ethoxy-substituted quinones and quinols, and polymeric material. Ethyl chlorophyllide (or chlorophyll) is simultaneously oxidized to more polar products which themselves continue to photosensitize the reaction of quinones. The production of acetaldehyde could not be demonstrated in the sensitized reaction. Chlorophyllide-sensitized reaction of (l-hydroxyethyl)benzoquinone, ethoxybenzoquinone and 2.5-diethoxybenzo-quinone were examined for additional information. A reaction sequence, tentatively proposed to accommodate the known facts, starts with oxidative attack by quinone on an oxidized chlorophyllide radical formed by loss of a hydroxyl proton from alcohol bound as a ligand to Mg²⁺. It is not likely that this reaction is closely related to events at the oxidizing side of photosystem II.     

Insertion of CO2, CS2, and COS into iron(II)-hydride bonds

The reactions between cis-Fe(dmpe)2H2 (dmpe = Me2PCH2CH2PMe2) (1) or cis-Fe(PP3)H2 (PP3 = P(CH2CH2PMe2)3) (2) and carbon dioxide (CO2), carbon disulfide (CS2), and carbonyl sulfide (COS) are investigated. At 300 K, additions of CO2 (1 atm), CS2 (2 equiv), and COS (1 atm) to 1 result in the formation of a stable transformato hydride, trans-Fe(dmpe)2(OCHO)H (3a), a trans-dithioformato hydride, trans-Fe(dmpe)2(SCHS)H (4a), and a trans-thioformato hydride, trans-Fe(dmpe)2(SCHO)H (5a), respectively. When CS2 and COS are added to cis-Fe(dmpe)2H2 at 195 K, a cis-dithioformato hydride, 4b, and a cis-thioformato hydride, 5b, respectively, are observed as the initially formed products, but there is no evidence of the corresponding cis-formato hydride upon addition of CO2 to cis-Fe(dmpe)2H2. Additions of excess CO2, CS2, and COS to 1 at lower temperatures (195-240 K) result in the formation of a trans-bis(formate), trans-Fe(dmpe)2(OCHO)2 (3b), a trans-bis(dithioformate), trans-Fe(dmpe)2(SCHS)2 (4c), and a cis-bis(thioformate), cis-Fe(dmpe)2(SCHO)2 (5c), respectively. trans-Fe(dmpe)2(SCHO)2 (5d) is prepared by the addition of excess COS at 300 K. Additions of CO2 (1 atm), CS2 (0.75 equiv), and COS (1 atm) to 2 at 300 K result in the formation of a thermally stable, geometrically constrained cis-formato hydride, cis-Fe(PP3)(OCHO)H (6a), a cis-dithioformato hydride, cis-Fe(PP3)(SCHS)H (7a), and a cis-thioformato hydride, cis-Fe(PP3)(SCHO)H (8a), respectively. Additions of excess CO2 and COS to 2 yield a cis-bis(formate), cis-Fe(PP3)(OCHO)2 (6b), and a thermally stable cis-bis(thioformate), cis-Fe(PP3)(SCHO)2 (8b), respectively. All complexes are characterized by multinuclear NMR spectroscopy, with IR spectroscopy and elemental analyses confirming structures of thermally stable complexes where possible. Complexes 3b and 5a are also characterized by X-ray crystallography.