Determination of lead in natural waters using flow injection with on-line preconcentration and flame AAS detection

A rapid and sensitive method has been developed for the determination of lead in water samples by flame atomic absorption spectrometry using on-line preconcentration on a microcolumn packed with silica gel treated with a mixture of Aliquat 336 and nitroso-R-salt. The lead is retained at pH 5.5. The preconcentrated lead is directly eluted from the column to the nebulizer-burner system using 150 L of 0.1 mol/L hydrochloric acid. The optimum preconcentration conditions are given and the retention efficiency achieved is higher than 80%. The enrichment factor is 37 and 100 for sample volumes of 5 and 30 mL, respectively. The limits of detection are 10.0, 6.0 and 4.0 ng/mL when 5, 10 and 30 mL of water is preconcentrated.     

Direct capillary electrophoretic determination of three chemotherapeutic drugs in human urine

Summary Capillary zone electrophoresis (CZE) has been used for direct determination of 6-thioguanine, methotrexate, and 5-fluorouracil in human urine, by use of a fused-silica capillary (60.2 cm×75 μm i.d.). Separation was performed after hydrodynamic injection for 7 s; the separation potential and capillary temperature were 25 kV and 35°C, respectively. A 45mm borate buffer solution (pH 9.2) was used as separation electrolyte. Under these conditions the analysis takes approximately 10 min and interday precision of migration times and corrected peak areas is satisfactory. A linear response over the concentration range 3.0–20.0 mg L¹ was observed for the three chemotherapeutic drugs in diluted human urine. Detection limits (s/n=3) for 6-thioguanine and methotrexate were approximately 1.60 mg L¹ in diluted human urine; that for fluorouracil was 2.60 mg L¹. A 2-ml volume of human urine was diluted with 2-mL of water and introduced directly into the electrophoresis system. CZE was shown to be a good method with regard to simplicity, satisfactory precision, and sensitivity. This method resulted in especially excellent recoveries for determination of methotrexate in all the different urine samples analysed (n=10).     

Evaluation of surface- and ground-water pollution due to herbicides in agricultural areas of Zamora and Salamanca (Spain)

The pollution of agricultural land due to herbicides was assessed in the Guare?a and Almar river basins, situated in the provinces of Zamora and Salamanca (Spain). A set of fifteen herbicides, including triazines, ureas, amides and others, was selected owing to their frequency of use, the amounts used, their toxicity and their persistence in the environment. Solid-phase extraction with polymeric cartridges, followed by HPLC with diode-array detection, were used to monitor the herbicides. This technique was chosen owing to the wide range of functionality and polarity of the analytes under study. The detection limits obtained were in the 0.004-0.025 microg/l range (lambda=220 nm). Surface and ground waters, taken from different locations in the basins, were analyzed over a 6-month period. The presence of six out of the fifteen herbicides monitored--chlortoluron, atrazine, terbutryn, alachlor, diflufenican and fluazifop-butyl--was detected in several samples at levels ranging from the detection limit to 1.2 microg/l. The relationship of these herbicides to the agricultural activities of the zone is discussed.     

Preparation of new monoanionic "scorpionate" ligands: synthesis and structural characterization of titanium(IV) complexes bearing this class of ligand

The preparation of new "scorpionate" ligands in the form of the lithium derivatives [(Li(bdmpzdta)(H(2)O))(4)] (1) [bdmpzdta = bis(3,5-dimethylpyrazol-1-yl)dithioacetate], [Li(bdphpza)(H(2)O)(THF)] (2) [bdphpza = bis(3,5-diphenylpyrazol-1-yl)acetate], and [Li(bdphpzdta)(H(2)O)(THF)] (3) [bdphpzdta = bis(3,5-diphenylpyrazol-1-yl)dithioacetate] has been carried out. Furthermore, a series of titanium complexes has been prepared by reaction of TiCl(4)(THF)(2) with the lithium reagents [(Li(bdmpza)(H(2)O))(4)] (4) [bdmpza = bis(3,5-dimethylpyrazol-1-yl)acetate] and 1. Under the appropriate experimental conditions neutral complexes, namely [TiCl(3)(kappa(3)-bdmpza)] (5), [TiCl(3)(kappa(3)-bdmpzdta)] (6), and [TiCl(2)(kappa(2)-bdmpzdta)(2)] (7), and cationic complexes, namely [TiCl(2)(THF)(kappa(3)-bdmpza)]Cl (8) and [TiCl(2)(THF)(kappa(3)-bdmpzdta)]Cl (9), were isolated. Complexes 8 and 9 undergo an interesting nucleophilic THF ring-opening reaction to give the corresponding alkoxide-containing species [TiCl(2)(kappa(3)-bdmpza)(O(CH(2))(4)Cl)] (10) and [TiCl(2)(kappa(3)-bdmpzdta)(O(CH(2))(4)Cl)] (11). A family of alkoxide-containing complexes of general formulas [TiCl(2)(kappa(3)-bdmpza)(OR)] [R = Me (12); R = Et (14); R = (i)Pr (16); R = (t)Bu (18)] and [TiCl(2)(kappa(3)-bdmpzdta)(OR)] [R = Me (13); R = Et (15); R = (i)Pr (17)] was also prepared. The structures of these complexes have been determined by spectroscopic methods, and in addition, the X-ray crystal structures of 3, 7, 10, and 11 were also established.     

Analytical approaches to expanding the use of capillary electrophoresis in routine food analysis

Capillary Electrophoresis (CE) is becoming an ever more powerful analytical technique for the separation, identification, and quantification of a wide variety of compounds of interest in many application fields. Particularly in food analysis this technique can offer interesting advantages over chromatographic techniques because of its greater simplicity and efficiency. Nevertheless, CE needs to advance with regard to compatibility with sample matrices, sensitivity, and robustness of the methodologies in order to gain even wider acceptance in food analysis laboratories, specially for routine work. This article presents various approaches to expanding the analytical usefulness of CE in food analysis, discussing their advantages over conventional CE. These approaches focus on sample screening, automated sample preparation with on-line CE arrangements, and the automatic integration of calibration in routine analytical work with CE.     

Transformation of dynamic DSC results into isothermal data for the curing kinetics study of the resol resins

Kinetics of thermosetting polymers curing is difficult to study by isothermal methods based on the differential scanning calorimetry (DSC) technique. The difficulty is due to the low sensitivity of the equipment for total reaction heat measurements during high temperature process. The aim of this paper is to display the equivalence between a dynamic model, the Ozawa method, and an isothermal isoconversional fit, which allows predicting the isothermal behavior of the resol resins cure through dynamic runs by DSC. In this work, lignin–phenol–formaldehyde and commercial phenol–formaldehyde resol resins were employed. In addition, the isothermal kinetic parameters for both resins were performed by means of transformation of the data obtained from the dynamic Ozawa method.     

Self-assembled amphiphilic fluorescent probe: detecting pH-fluctuations within cancer cells and tumour tissues

Abnormal anaerobic metabolism leads to a lowering of the pH of many tumours, both within specific intracellular organelles and in the surrounding extracellular regions. Information relating to pH-fluctuations in cells and tissues could aid in the identification of neoplastic lesions and in understanding the determinants of carcinogenesis. Here we report an amphiphilic fluorescent pH probe (CS-1) that, as a result of its temporal motion, provides pH-related information in cancer cell membranes and selected intracellular organelles without the need for specific tumour targeting. Time-dependent cell imaging studies reveal that CS-1 localizes within the cancer cell-membrane about 20 min post-incubation. This is followed by migration to the lysosomes at 30 min before being taken up in the mitochondria after about 60 min. Probe CS-1 can selectively label cancer cells and 3D cancer spheroids and be readily observed using the green fluorescence channel (λ_em = 532 nm). In contrast, CS-1 only labels normal cells marginally, with relatively low Pearson''s correlation coefficients being found when co-incubated with standard intracellular organelle probes. Both in vivo and ex vivo experiments provide support for the suggestion that CS-1 acts as a fluorescent label for the periphery of tumours, an effect ascribed to proton-induced aggregation. A much lower response is seen for muscle and liver. Based on the present results, we propose that sensors such as CS-1 may have a role to play in the clinical and pathological detection of tumour tissues or serve as guiding aids for surgery.

A self-assembled amphiphilic fluorescent probe allows pH-fluctuations within cancer cells and tumour tissues to be readily detected.     

Optimization of the Microwave-Assisted Saponification and Extraction of Organic Pollutants from Marine Biota Using Experimental Design and Artificial Neural Networks

Several improvements in sample pretreatment for the determination of organic pollutants (i.e. n-alkanes, polycyclic aromatic hydrocarbons, PAHs) in marine biota (mussels) are presented. The use of liquid nitrogen and homogenization of the samples are shown to be an alternative to the time consuming liophilization step required for the analysis of biota samples. Microwave-assisted hydrolysis and extraction are combined to isolate organic pollutants (19 n-alkanes and 27 PAHs) from biota matrices. Experimental design (ED) and artificial neural networks (ANNs) were used to optimize the experimental conditions. NIST-CRM 2978 was used to test the validity of the developed method which shows a good agreement with certified values.     

Beta-elimination reactions by using samarium diiodide

The development of methodologies for the formation of carbon-carbon double bonds could be considered one of the most important challenges in organic synthesis. To this end, beta-elimination reactions in 1,2-difunctionalised substrates have been one of the most important means of generating C=C bonds.This review is intended to highlight the use of SmI2 in beta-elimination procedures, such that the organization of this revision highlights conventional beta-elimination processes which are promoted by samarium diiodide. The synthetic applications of SmI2 will be covered, and 1,2-elimination reactions which are involved in sequential reactions promoted by samarium diiodide, will also be illustrated. These methodologies along with the more recent developments in the area are discussed in this tutorial review.     

Structure activity relationship by NMR and by computer: a comparative study

There has recently been considerable interest in using NMR spectroscopy to identify ligand binding sites of macromolecules. In particular, a modular approach has been put forward by Fesik et al. (Shuker, S. B.; Hajduk, P. J.; Meadows, R. P.; Fesik, S. W. Science 1996, 274, 1531-1534) in which small ligands that bind to a particular target are identified in a first round of screening and subsequently linked together to form ligands of higher affinity. Similar strategies have also been proposed for in silico drug design, where the binding sites of small chemical groups are identified, and complete ligands are subsequently assembled from different groups that have favorable interactions with the macromolecular target. In this paper, we compare experimental and computational results on a selected target (FKBP12). The binding sites of three small ligands ((2S)1-acetylprolinemethylester, 1-formylpiperidine, 1-piperidinecarboxamide) in FKBP12 were identified independently by NMR and by computational methods. The subsequent comparison of the experimental and computational data showed that the computational method identified and ranked favorably ligand positions that satisfy the experimental NOE constraints.