A warehouse-based design model for reverse logistics

In this paper, an MILP formulation is proposed for the design of a reverse logistics network based on a warehouse location–allocation model, which optimizes, simultaneously, the forward and reverse networks. A single product model with unlimited capacity is first defined. Subsequently, the model is extended to a multi-product capacitated recovery network model, where capacity limitations and a multi-product system can be considered. The proposed model is compared to published work in the field, where different model assumptions have been proposed. Two cases are described so as to gain a better insight into the model and allow a comparative analysis.     

CONCEPTUAL DESIGN STUDIES OF AN 84 GHz, 500 kW, CW GYROTRON

The feasibility of an 84 GHz, 500 kW, CW gyrotron for ECRH on an experimental tokamak will be presented in this paper. Mode competition and mode selection procedures are carefully investigated by considering various candidate modes and the TE_10,4 mode is chosen as the operating mode. A conventional cylindrical cavity resonator with weak input and output tapers and parabolic roundings is considered for interaction studies. Self-consistent, both single mode and time-dependent, calculations are carried out and power and efficiencies are computed for a typical set of beam parameters. The results show that an output power of well over 500 kW, CW and efficiency around 40% can be reached without a depressed collector.     

Well-Posedness by Perturbations of Variational Problems

In this paper, we consider the extension of the notion of well-posedness by perturbations, introduced by Zolezzi for optimization problems, to other related variational problems like inclusion problems and fixed-point problems. Then, we study the conditions under which there is equivalence of the well-posedness in the above sense between different problems. Relations with the so-called diagonal well-posedness are also given. Finally, an application to staircase iteration methods is presented.     

Mass Power Spectrum in a Universe Dominated by the Chaplygin Gas

The mass power spectrum for a Universe dominated by the Chaplygin gas is evaluated numerically from scales of the order of the Hubble horizon to 100 Mpc. The results are compared with a pure baryonic Universe and a cosmological constant model. In all three cases, the spectrum increases with k, the wavenumber of the perturbations. The slope of the spectrum is higher for the baryonic model and smaller for the cosmological constant model, the Chaplygin gas interpolating these two models. The results are analyzed in terms of the sound velocity of the Chaplygin gas and the moment the Universe begins to accelerate.     

The polar ionosphere at Zhongshan station on May 11, 1999, the day the solar wind almost disappeared

The solar wind almost disappeared on May 11, 1999: the solar wind plasma density and dynamic pressure were less than 1cm⁻³ and 0.1 nPa respectively, while the interplanetary magnetic field was northward. The polar ionospheric data observed by the multi-instruments at Zhongshan Station in Antarctica on such special event day was compared with those of the control day (May 14). It was shown that geomagnetic activity was very quiet on May 11 at Zhongshan. The magnetic pulsation, which usually occurred at about magnetic noon, did not appear. The ionosphere was steady and stratified, and the F₂ layer spread very little. The critical frequency of day-side F₂ layer, f₀F₂, was larger than that of control day, and the peak of f₀F₂ appeared 2 hours earlier. The ionospheric drift velocity was less than usual. There were intensive auroral E_s appearing at magnetic noon. All this indicates that the polar ionosphere was extremely quiet and geomagnetic field was much more dipolar on May 11. There were some signatures of auroral substorm before midnight, such as the negative deviation of the geomagnetic H component, accompanied with auroral E_s and weak Pc3 pulsation.

     

Analysis of anharmonic and thermoelastic properties of non-centrosymmetric crystals

In the present paper an analytical potential form is used for overlap repulsive energy, derived by Harrison from quantum mechanical considerations, along with the composite effect of three-body forces and intersublattice displacement. The short-range overlap parameters in Harrison's potential form have direct correlation with the valence state energies for outermost electrons. The potential model is applied to calculate the third and fourth order elastic constants, first and second pressure derivatives of second order elastic constants, Grüneisen parameter and its volume dependence, Anderson parameter, and thermal expansion coefficient for three non-centrosymmetric crystals, viz. CaF₂, SrF₂ and BaF₂. The calculated values of various physical quantities are found to be in good agreement with experimental data.The authors are grateful to Dr. Mansour Khalef, the Head of Physics Department, TNRC, Tajura (Tripoli) for the facilities and encouragements.     

Temperature dependence of corundum roentgenoluminescence and thermoluminescence

Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 54, No. 3, pp. 438–444, March, 1991.     

Investigation of the structure of a melt and molecular dynamics of ortho- and pyrophosphates by Raman spectroscopy

Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 55, No. 4, pp. 535–540, October, 1991.     

Inverse Process with Independent Positive Increments: Finite-Dimensional Distributions

An inverse process with independent positive increments is considered. For such a process, the first hitting time τ_x of level x as a function of x ≥ 0 is a proper process with independent positive increments. In terms of first hitting times and their Levy measures, multidemensional distribution densities and Laplace transformations are derived. Stationary distributions of increments of the process are investigated. Bibliography: 8 titles. __________ Translated from Zapiski Nauchnykh Seminarov POMI, Vol. 311, 2004, pp. 286–297.     

Germanium growth on Br-terminated Si(1 0 0)

The consequences of Ge deposition on Br-terminated Si(1 0 0) were studied with scanning tunneling microscopy at ambient temperature after annealing at 650 K. One monolayer of Br was sufficient to prevent the formation of Ge huts beyond the critical thickness of 3 ML. This is possible because Br acts as a surfactant whose presence lowered the diffusivity of Ge adatoms. Hindered mobility was manifest at low coverage through the formation of short Ge chains. Further deposition resulted in the extension and connection of the Ge chains and gave rise to the buildup of incomplete layers. The deposition of 7 ML of Ge resulted in a rough surface characterized by irregularly shaped clusters. A short 800 K anneal desorbed the Br and allowed Ge atoms to reorganize into the more energetically favorable “hut” structures produced by conventional Ge overlayer growth on Si(1 0 0).