Intra‐laser‐cavity microparticle sensing with a dual‐wavelength distributed‐feedback laser

An integrated intra‐laser‐cavity microparticle sensor based on a dual‐wavelength distributed‐feedback channel waveguide laser in ytterbium‐doped amorphous aluminum oxide on a silicon substrate is demonstrated. Real‐time detection and accurate size measurement of single micro‐particles with diameters ranging between 1 µm and 20 µm are achieved, which represent the typical sizes of many fungal and bacterial pathogens as well as a large variety of human cells. A limit of detection of ∼500 nm is deduced. The sensing principle relies on measuring changes in the frequency difference between the two longitudinal laser modes as the evanescent field of the dual‐wavelength laser interacts with micro‐sized particles on the surface of the waveguide. Improvement in sensitivity far down to the nanometer range can be expected upon stabilizing the pump power, minimizing back reflections, and optimizing the grating geometry to increase the evanescent fraction of the guided modes.     

Performance of a 80 W copper vapor laser with “alignment free” unstable CAT-EYE resonator and other configurations using intra-cavity apertures

Performance of a kinetically enhanced copper vapor laser (KE-CVL) with various stable/unstable “alignment free” CAT-EYE resonator configurations are presented here in this paper. The laser used in the experiment was a 45 mm bore (∼2 l discharge volume) kinetically enhanced copper vapor laser developed in our laboratory and capable of generating maximum power of ∼80 W (at ∼9.8 kHz). The efficiency of the laser was ∼1.4% and beam divergence of ∼3.5 mrad in a plane-plane standard multimode cavity. For the first time performance of unstable CAT-EYE resonator is demonstrated with a CVL/KE-CVL. On using unstable CAT-EYE resonator the divergence of the laser beam reduced to ∼0.22 mrad (∼20-fold reduction as compared to conventional plane-plane cavity), ∼40 W output power and with excellent misalignment tolerance. The laser output power was found to be within ∼5% drift/decline with misalignment angle of about 4 mrad between the mirrors. This is a significant improvement in comparison to standard conventional unstable resonator (M ∼ 50) CVL where ∼0.5 mrad divergence is achieved with power drift/decline of about 45% at ∼4 mrad misalignment angle.Off-axis unstable CAT-EYE unstable resonator was also demonstrated for the first time with further reduction in beam divergence to ∼0.13 mrad and with output power of ∼28 W. The misalignment tolerance was found to be highest in case of off-axis unstable CAT-EYE resonator with decline/drift in laser power of only ∼10% for misalignment angle as high as ∼8 mrad. Performance with intra-cavity apertures in plane-plane type CAT-EYE resonator for transverse mode control is also presented for the first time in CVLs. It is observed that the laser beam divergence reduces significantly to 1.25 mrad (a factor of 2) on using an aperture of ∼3.5 mm at the CAT-EYE reflector as compared to its normal (R = F = d) configuration without aperture. In case of stable CAT-EYE resonator the average beam divergence reduces from 8 mrad to 4 mrad (factor of 2) on using intra-cavity aperture of about 3 mm. It was also observed that high misalignment tolerance was retained on using intra-cavity apertures in almost all the CAT-EYE resonators. Use of intra-cavity mesh was also demonstrated for the first time with stable CAT-EYE resonator for improving the beam focus-ability. Average beam divergence was reduced by a factor of 2.5 (from 8 mrad to 3 mrad) on using intra-cavity mesh. These new configurations in CAT-EYE resonators in KE-CVLs are found to be effective in improving and controlling the laser beam divergence significantly with additional characteristic of high misalignment tolerance.     

Montmorillonite-based ceramic membranes as novel lithium-ion battery separators

Novel montmorillonite-based ceramic membrane (CM) has been prepared with poly(vinylidene fluoride-co-hexafluoropropene) (PVdF-HFP) copolymer as binder. Physical properties such as surface morphology, porosity, liquid electrolyte uptake and thermal stability were analysed. The ceramic membrane was activated by soaking it in a non-aqueous liquid electrolyte (1.0 M LiPF₆ solution in 1/1 v/v ethylene carbonate/diethyl carbonate mixture) for 10 min. The compatibility of the membrane with lithium metal anode as a function of storage time was analysed by assembling a Li/CM/Li symmetric cell. Finally, a lab-scale cell composed of Li/CM/LiFePO₄ is assembled and its cycling performance analysed at different C-rates. Although the ceramic membrane is not flexible, it shows high thermal stability and stable interfacial properties when in contact with the lithium metal anode. A stable cycling behaviour is demonstrated even at 1C-rate with limited fade in capacity.     

Comparative studies on radiolytic degradation of deuterium labeled and unlabeled tributyl phosphates

Deuterium labeled tributyl phosphates were synthesized and their solutions in n-dodecane have been investigated for γ-radiolytic degradation up to an absorbed dose of 2,000 kGy from a ⁶⁰Co source. The performance was compared with undeuterated TBP. Radiolysis extent and pattern of formation of major degradation products, viz. dibutyl hydrogen phosphate and monobutyl dihydrogen phosphate were found to be very similar from deuterated or undeuterated samples. Extraction behavior for UO₂ ²⁺ and Pu(IV) was studied after the radiolysis, and the results showed similarity in extraction/stripping behavior for all labeled or unlabeled TBP samples. The isotope effect (k _H/k _D) observed is minimal in this γ-radiolytic degradation study.     

An Yb(OTf)3‐catalyzed,convergent synthesis of new pyranyl‐ and chromenyl‐substituted quinolines through an eco‐friendly approach

A one‐pot, multicomponent, convergent microwave synthesis of some new pyranyl‐ and chromenyl‐substituted quinolines has been reported. Twenty compounds were prepared by the reaction of 2‐methoxy‐3‐formyl quinoline ( 1a‐d ), malononitrile ( 2 ), and kojic acid ( 4a‐d )/1,3‐cyclohexadione or dimedone ( 6a ‐ h )/α‐ or β‐naphthol ( 8a ‐ d , 8e ‐ h ). The structures were confirmed by infrared (IR), ¹H nuclear magnetic resonance (NMR), ¹³C NMR, mass, and single‐crystal X‐ray analyses. On comparison with the use of conventional Lewis acid catalysts and various metal triflates under microwave conditions, the latter contributed to good yields, in specific use of the recyclable Yb(OTf)₃ catalyst attributed to high yields of the desired product. The protocol reported herein is solvent free, cost effective, and eco‐friendly.     

2D hydrogen-bonded manganese–picolinate coordination network: ionic liquid-induced synthesis,crystal structure and thermogravimetric analysis

A new manganese coordination complex of formula [Mn(2-picolinate)₂·2H₂O]·H₂O based on 2-picolinic acid has been synthesized hydrothermally at 120 °C for 48 h in presence of ionic liquid tetraethylammonium hydroxide (25% methanolic solution). 1 crystallizes in monoclinic crystal system and is hydrogen-bonded metal-organic network in which aqua ligands are instrumental in deciding structural features. The reported complex 1 is insoluble in almost all organic solvents as well as in water and shows good thermal stability upto 450 °C.     

Structural stability and electrical conductivity of amorphous Ge-metal alloy films

Stable homogeneous amorphous alloy¹ films of Ge with different concentrations of Al, Cu and Fe have been prepared by the simultaneous vapor deposition technique. Ge-Metal films are amorphous up to a concentration of ～ 40 at.% Al, ～ 20 at.% Cu and ～ 20 at.% Fe. The cyclic annealing and crystallization temperature of these films show that whereas Al increases the stability of the amorphous phase, the addition of Cu and Fe decreases it. The electrical resistivity decreases gradually with increasing Al content. In contrast, a rapid decrease in the electrical resistivity is observed for the Ge-Cu and Ge-Fe systems. The thermoelectric power (TEP) of Ge-Cu and Ge-Fe system assumes small values ～ few μV/deg for concentrations greater than few atomic percent. Ge-Al system exhibits large positive thermoelectric power at all compositions. The temperature dependence of the electrical resistivity of these alloy films show that the addition of Cu and Fe to Ge results in a drastic decrease in the activation energy of conduction whereas the addition of Al increases the activation energy. Ge-Al films exhibit intrinsic like conduction in the temperature range 100–300 K. The Ge-Cu and Ge-Fe films exhibit hopping conduction from 100–300 K and the related density of states is up to 100 times larger than in pure a-Ge films.     

Fragmentation patterns of newly isolated cassane butenolide diterpenes and differentiation of stereoisomer by tandem mass spectrometry

Different stereoisomers of active molecules often cause different physiological responses and hence pose a challenge for their identification. This study involves perceptive fragmentation behavior of newly isolated cassane butenolides, caesalpinolide A [1] and caesalpinolide B [2] (epimeric at the hemiketal position) by tandem MS. The electrospray ionization-mass spectrometry (ESI-MS)/collision-induced dissociation (CID; ESI-MS(2) and ESI-IT-MS(n)) were investigated. The effect of orientations of hemiketal hydroxyl at C-12 was clearly observed in the mass spectrum. Tandem mass spectra of 1, 1(A) or 2, 2(A) show stereospecific fragmentation resulting in significant abundance dissimilarity of [MH - H(2)O](+) as well as differences in fragmentation pathway. Both of these pathways seem to be influenced by the stereochemistry of the molecule. The differentiation can be clearly visualized from the [M + H - H(2)O](+)/[M + H](+) ratio of the two isomers where beta-isomer 2 was found to be five times higher than that of alpha-isomer 1 in full scan liquid chromatography-electrospray ionization mass spectrometry(LC-ESI-MS). In high-energy CID, the mass fingerprint of 1, 2, 1(A), and 2(A) was found to be different from one another.