Fast determination of the tin content in cassiterite ores by photon activation method

Photon activation analysis has been success-fully applied to the fast and non-destructive analysis of tin in cassiterite ores based on the 159.7 keV gamma line of^123mSn produced in the¹²⁴Sn/γ, n/^123mSn reaction. In order to improve the accuracy of analytical results, corrections for self-absorption and pile-up effects were performed. Under typical conditions /15 μA electron beam current, 15 MeV bremsstrahlung energy, 5 min irradiation time and 10 min measurement/ the sensitivity of the analysis is 10 ppm. The proposed method can be used for routine analysis of tin in geological samples.     

Role of tin in a PtSb alloy and a Pt-Sn/Al2O3 reforming catalyst

The conversion of n-hexane was studied on a Pt-Sn/Al₂O₃ catalyst, a PtSn alloy and on the corresponding Pt catalysts. The results indicate the same catalytic effect of tin in supported and unsupported catalysts. It is concluded that the role of tin is connected with alloy formation.

---

- Pt-Sn/Al₂O₃, PtSn Pt-. . , .

     

Synthesis of N,N-diethyldithiocarbamate functionalized 1,4-polyisoprene, from natural rubber and synthetic 1,4-polyisoprene

N,N-Diethyldithiocarbamate functionnalized 1,4-polyisoprenes were prepared from 1,4-polyisoprenes (natural or synthetic). The syntheses were performed by nucleophilic addition of N,N-diethyldithiocarbamate salts upon oxirane rings of epoxidized units according to a SN2 mechanism with ring opening. Studies on model molecules of epoxidized 1,4-polyisoprene units (1,2-epoxy-1-methylcyclohexane and 4,5-epoxy-4-methyloctane) were previously achieved to develop the procedure. The best yields were obtained at low temperature in polar medium, and more especially in water with sodium N,N-diethyldithiocarbamate (DEDT-Na) as reagent. A diastereospecific addition was noted when reaction was performed in water with DEDT-Na. Afterwards, the developed procedure was successfully generalized to epoxidized synthetic polyisoprenes and epoxidized natural rubber (in THF, then in latex medium). Excellent results were obtained in latex medium with epoxidized natural rubber (ENR) latices. As with the models, a diastereospecific addition of sodium N,N-diethyldithiocarbamate trihydrate onto epoxidized 1,4-polyisoprene units of ENR was observed at the condition to bring the latex medium to pH 8 before introduction of DEDT-Na. Influence of temperature, drc, and DEDT-Na concentration were successively examined to determine the best conditions of the addition on ENR latices.     

Synthesis and properties of an ω,ω′-appended eighteen carbon chains hypericin derivative

Summary An ,-appended eighteen carbon chains hypercin derivative (2) was synthesized starting from emodin. The overall yield of the seven step synthesis was 12%. The¹H and¹³C NMR, absorption, and emission spectroscopic properties were measured;2 can be dissolved even in apolar solvents and polyethylene.

---

Synthese und Eigenschaften eines mit C₁₈-Ketten ,-substituierten Hypericinderivats

Zusammenfassung Ein in den Positionen , mit zwei C₁₈-Ketten substituiertes Derivat des Hypericins (2) wurde ausgehend von Emodin synthetisiert. Die Gesamtausbeute der siebenstufigen Synthese betrug 12%. Die¹H- und¹³C-NMR, absorptions- und emissionsspektroskopischen Eigenschaften wurden gemessen;2 kann sogar in apolaren Lösungsmitteln und Polyethylen gelöst werden.

     

Research on 1-azabicyclic compounds

1-(2-Furyl)-3-amino-4,4-dimethylpentane was used to obtain 3-tert-butyl-1,2-dihydropyrrolizine, the catalytic hydrogenation of which over Rh/Al₂O₃ at room temperature gives a mixture of cis- and trans-3,8-H-3-ter-butylpyrrolizidines with predominance of the cis isomer, whereas hydrogenation at 90–100 °C gives a mixture containing the trans isomer as the principal component. The three-dimensional structures of the isomers follow from data on the catalytic hydrogenation and isomerization and the IR, Raman, and PME spectra. A considerable percentage of the trans-fused form is characteristic for cis-3,8-H-3-tert-butylpyrrolizidine.     

Diffusion of additives and plasticizers in poly(vinyl chloride)—II: The self-diffusion of the stabilizers dibutyltin dilaurate and dibutyltin bismonobutylmaleate in plasticized poly(vinyl chloride)

The self-diffusion coefficient, D, of dibutyltin dilaurate and dibutyltin bismonobutylmaleate have been obtained at 35, 45 and 55° in samples of poly(vinyl chloride) plasticized with 34, 60 and 100 phr of di(2-ethylhexyl)phthalate. D at 2 phr of the laurate is 3–5 times larger than for the smaller maleate molecule. In all cases, D increases with increasing plasticizer concentration, an effect interpreted in terms of the free volume theory of diffusion. D for the laurate increases by a factor of about 2.7 when the laurate diffusant concentration is increased from 0 to 4 phr. The activation energies for diffusion, E_D, lie between 50 and 90 kJ mol^?1. They increase with increasing plasticizer concentration but become constant at higher plasticizer concentrations (60–100 phr). It is impossible to correlate all the known data on diffusion in plasticized PVC with an equation of the form log D₀ = C₁ + C₂ E_D/RT     

Some highly symmetric authentication perpendicular arrays

A set S of permutations of k objects is -uniform, t-homogeneous if for every pair A, B of t-subsets of the ground set, there are exactly permutations in S mapping A onto B. Arithmetical conditions and symmetries are discussed. We describe the character-theoretic method which is useful if S is contained in a permutation group. A main result is the construction of a 2-uniform, 2-homogeneous set of permutations on 6 objects and of a 3-uniform, 3-homogeneous set of permutations on 9 objects. These are contained in the simple permutation groups PSL ₂(5) and PSL ₂(8), respectively. The result is useful in the framework of theoretical secrecy and authentication (see Stinson 1990, Bierbrauer and Tran 1991).     

Partition temperatures ofK 0 andΛ 0 fromπ + p collisions

The rapidity distributions of inclusive ⁺ p ^–,K ⁰, ⁰ andK ^* (892) atP _1ab=16 GeV/c of CERN experiments, are analyzed using the covariant partition temperatureT _p model. In the fireball system, apart fromK ^* (892),T _p ^* m, no indication of thermal equilibrium, the average momentum ofK ⁰ and ⁰ being approximately equal and in the opposite direction, the entropy density is practically the same forK ⁰ and ⁰ but less than that of ^–. It is found that the principle of equipartition holds rather for the momenta of ,K, and in the fireball system.