A two-step procedure for the supercritical fluid extraction (SFE) of polycyclic aromatic hydrocarbons from soil samples was developed. The procedure consists of a static supercritical fluid treatment in a closed extraction cell at a high temperature (T=250 or 340degreesC for 20 min) and an SFE with a solvent trapping. During the static phase, the sample is exposed to a supercritical organic solvent (methanol, toluene, dichloromethane, ACN, acetone, and hexane). The solvent penetrates particles of the matrix to substitute strongly bonded molecules and dissolves the analytes in the supercritical phase. At ambient temperature, supercritical fluids became liquid and lost their solvation abilities. Most of the analytes condense on the surface of the particles or on the extraction cell walls without forming strong bonds or penetrating deep into the matrix. Thus, the pretreatment liberates the analytes and they behave similar to those in freshly spiked samples. The common SFE with toluene-modified CO2 as an extraction fluid follows the static phase. With the use of the most suitable extraction phases (toluene, ACN), the extraction efficiency of the combined procedure is much higher (approximately100%). The results of the combined procedure are compared to the SFE procedure of the same untreated sample (difference less than 5%) and to the Soxhlet extraction. The extracts were analyzed using a GC with the flame ionization detection. 相似文献
An improved version of the disposable multichannel immunochemical biosensor for the herbicide 2,4-dichlorophenoxyacetic acid (2,4-D) based on a screen-printed amperometric transducer and monoclonal antibodies (MAb) against 2,4-D is reported. Entrapment within a thin Nafion film was used for the direct immobilization of MAb at the electrode surface. The amount of the tracer (2,4-D conjugated to acetylcholinesterase) bound in a competitive immunochemical reaction was determined amperometrically using acetylthiocholine iodide as substrate. The measuring procedure (times of incubation with tracer and substrate, pH, tracer concentration) was optimized. The sensor was able to detect less than 0.01 μg/L of free 2,4-D in water. One analysis (8 samples) was completed in 30 min (20 min for immunochemical reaction, 5 min incubation with substrate, 5 min measurement). The performance of the immunosensor (two configurations) was evaluated on real samples (tap water) with added 2,4-D. The determined amounts (mean values 0.097 to 0.105 and 0.89 to 1.13) corresponded well with the added contents of 2,4-D (0.100 and 1.00 μg/L, respectively). 相似文献
A new and fast high-performance liquid chromatography (HPLC) method using technology of fused-core columns for separation of fenoxycarb and cis-, trans-permethrin has been developed and used for their determination in antiparasitic veterinary shampoo. Separation of insecticides and internal standard sudan II was achieved on the fused-core column Ascentis Express RP-Amide (100 × 3.0 mm), particle size 2.7 μm, with mobile phase acetonitrile/water (55:45, v/v) at a flow rate of 1.0 mL min−1 and at temperature 60 °C. The detection wavelength of detector was set at 225 nm for both compounds and internal standard sudan II. Under the optimum chromatographic conditions standard calibration curves were measured with good linearity [r2 = 0.99991 for fenoxycarb, r2 = 0.99987 for trans-permethrin, and r2 = 0.99984 for cis-permethrin (n = 8)]. Commercial samples of antiparasitic veterinary shampoo were extracted with ethanol in ultrasound bath for 5 min. A 2-μL sample volume of the filtered solution was directly injected into the HPLC system. Accuracy of the method defined as a mean recovery of insecticides from shampoo matrix was in the range 100.43–103.85 % for both insecticides.
An uncertainty of an estimated parameter can be, in general, decomposed into two parts, i.e. an uncertainty caused by errors in the actual experiment (the type A uncertainty) and an uncertainty caused by errors in preceding experiment, where some wanted constants were estimated (the type B uncertainty). These constants are necessary for an estimation of the useful parameters. The aim of the paper is to find a condition for elimination of the type B uncertainty. 相似文献
Acrylamide and acrolein are two short-chained hazardous compounds with neurotoxic, carcinogenic, and mutagenic effects. The aim of this paper is to describe a fast and simple procedure for simultaneous determination of both acrylamide and acrolein under standard conditions, suggest a suitable calibration protocol for custom analysis, and demonstrate its applicability to the analysis of gaseous products from, e.g., cigarettes, cigars, or electronic cigarettes. A gas chromatography–mass spectrometry (GC–MS) method was developed to quantify acrylamide and acrolein in smoke vapor from electronic cigarettes, tobacco cigarettes, and cigars. Nonionic and highly polar molecules with a low boiling point and molecular mass need a suitable derivatization method to achieve appropriate retention and selectivity on commonly used relatively nonpolar stationary phases and to enhance the molecular mass for easy MS detection. The derivatization of acrylamide and acrolein was carried out by a bromination method with elemental bromine. The dibromo derivatives were extracted into an organic solvent and following a dehydrobromination procedure the samples were injected into the GC–MS system. Important experimental parameters were varied, after which the bromination time was defined as 30 min, and the injector temperature and the starting temperature of gradient were set at 280 and 50 °C respectively. Acrolein was found in all tested samples, while acrylamide was detected only in smoke from normal tobacco. Possible mechanisms for the formation of these unsaturated compounds in the samples are discussed. After its validation the newly developed method was successfully and reliably applied to the analysis of both compounds. This short method provides an easy way to determine acrylamide and acrolein in gaseous samples.