Adsorption-penetration studies of glucose oxidase into phospholipid monolayers at the 1,2-dichloroethane/water interface.

The interaction between glucose oxidase (GOx) and phospholipid monolayers is studied at the 1,2-dichloroethane/water interface by electrochemical impedance spectroscopy. Electrochemical experiments show that the presence of GOx induces changes in the capacitance curves at both negative and positive potentials, which are successfully explained by a theoretical model based on the solution of the Poisson-Boltzmann equation. These changes are ascribed to a reduced partition coefficient of GOx and an increase of the permittivity of the lipid hydrocarbon domain. Our results show that the presence of lipid molecules enhances the adsorption of GOx molecules at the liquid/liquid interface. At low lipid concentrations, the adsorption of GOx is probably the first step preceding its penetration into the lipid monolayer. The experimental results indicate that GOx penetrates better and forms more stable monolayers for lipids with longer hydrophobic tails. At high GOx concentrations, the formation of multilayers is observed. The phenomenon described here is strongly dependent on 1) the GOx and lipid concentrations, 2) the nature of the lipid, and 3) the potential drop across the interface.     

Determination of volatile corrosion inhibitors by capillary electrophoresis

In this work, a capillary electrophoresis (CE) method using indirect UV detection (214nm) for the simultaneous determination of monoethanolamine (MEA), diethanolamine (DEA), triethanolamine (TEA), diethylethanolamine (DEEA), monocyclohexylamine (MCHA) and dicyclohexylamine (DCHA) in water/ethanol extracts of wrapping materials containing volatile corrosion inhibitors (VCIs) was described. A running buffer consisting of 0.010 molL(-1) imidazole, 0.010 molL(-1) 2-hydroxyisobutyric acid (HIBA) and 0.010 molL(-1) 18-crown-6 ether enabled separation of the analytes in less than 7 min. A few method validation parameters were determined revealing good migration time repeatability (<0.7% RSD) and area repeatability (< 1.8% RSD). Limits of detection were in the range of 0.52-1.54 mg L(-1). Recovery values were in the range of 94.8-100.9%. The methodology was successfully applied to the analysis of three commercial products (VCI treated paper, foam and plastic). The concentration of amines in these materials varied from 0.050 to 22.3% (w/w).     

Actinide heterobimetallic oxides (Th, U): reduction studies

In our laboratories we have been studying the synthesis and reactivity of binary actinide and lanthanide intermetallic compounds. In this work, the air-oxidation of ThCu₂ and AnNi₂ (An = Th, U) was followed by thermogravimetry (TG) and the products were characterized by X-ray powder diffraction (XRD). The heterobimetallic oxides obtained are described by the formulas 2MO·ThO₂ (M = Cu, Ni) and 2NiO·UO₃. The thermogravimetric analysis under hydrogen of these heterobimetallic oxides show one mass loss for 2MO·ThO₂ and two mass losses for 2NiO·UO₃ over a wide range of temperature (293–1273 K). The characterization by XRD shows that the reduction products are 2M·ThO₂ (M = Cu, Ni) and 2Ni·UO₂, with all the actinides in the 4+ oxidation state. The actinide heterobimetallic oxides were described as copper or nickel supported catalysts.     

Chiroptical properties of 2-substituted pyrrolidines

The CD spectra of L-2-methylpyrrolidine, L-prolinol, and their N-methylated derivatives have been determined. As in the 2-substituted piperidines, N-methylation results in an inversion of the sign of the Cotton effects (CE). However, the sign of the long-wavelength CE does not follow the simple helicity rule found for 2-substituted piperidines, since the pyrrolidine ring is itself chiral and makes its own contributions to the observed CE's. The rotational contribution due to pyrrolidine ring chirality appears to be opposite in sign to and larger in magnitude than that due to the 2-substituent in both the secondary and the tertiary amines.     

The spatial distribution of poly(methyloctylsiloxane) deposited by solvent evaporation in the pores of HPLC silica particles

Summary Poly(methyloctylsiloxane) (PMOS), sorbed into the pores of HPLC silica particles by solvent evaporation, can function as a useful stationary phase for reversed-phase chromatography. The present work addresses the question of how the PMOS is distributed in the pores. Measurements of the surface area (BET, N₂) of a series of partially loaded samples (0–40% PMOS, m/m) using a typical batch of HPLC silica (10 μm irregular particles with 6 nm pores) show that the specific surface area of the samples decreases linearly with the specific loading (mass of PMOS per gram of silica). This result is not consistent with a “film” model in which the PMOS is deposited uniformly on the pore walls, but is consistent with a model in which long segmented “plugs” of PMOS are deposited within the pore system. Presented at the 21^st ISC held in Stuttgart, Germany, 15^th–20^th September, 1996     

Kalorimetrische Messungen an Mischungen von Nichtelektrolyten, 1. Mitt.: Molwärme des Systems 1,2-Dibromäthan-Benzol

Zusammenfassung Es wird der Aufbau eines Kalorimeters zur Bestimmung der spezif. Wärme von Flüssigkeiten beschrieben. Die Messungen werden nach einem kontinuierlichen adiabatischen Aufheizverfahren durchgeführt. Der Fehler in der Molwärme beträgt ca. ±0,4%. Die Methode erlaubt auch innerhalb relativ kleiner Temperaturbereiche eine Aussage über die Temperaturabhängigkeit der Wärmekapazität.Die Molwärme des Systems 1,2-Dibromäthan-Benzol wird zwischen 24 und 29°C über den ganzen Konzentrationsbereich vermessen. Die Mischungen zeigen negative C _p-Werte mit unsymmetrischem Konzentrationsverlauf. Für höhere Temperaturen ist eine Zunahme der Symmetrie zu erwarten.

---

A calorimeter has been described which serves to determine the heat capacities of liquids. In the measurements the calorimeter and the surroundings are heated continuously, so that adiabatic conditions prevail. The experimental error in the molar heat capacities is ca. ±0,4%. The method also permits the estimation of the temperature dependence of the heat capacities, even within relatively small temperature intervals.The molar heat capacity of the system 1,2-dibromoethane-benzene has been measured between 24° and 29°C for all concentrations. The C _p-values of the mixtures are negative and show an asymmetrical dependence on the concentration. For higher temperatures it is expected that the concentration dependence will become more nearly symmetrical.

---

---

Mit 3 Abbildungen     

Improvement in steroid screening for doping control with special emphasis on stanozolol

The Medical Commission of the International Olympic Committee forbids the use of anabolic androgenic steroids and beta2-agonists to improve athletic performance. In this work we have selected examples of anabolic androgenic compounds and their metabolites to evaluate the GC-MS analysis of some trimethylsilyl derivatives. The aim is to set the best GC conditions to improve the detection within the whole range of analyte elution temperatures. The initial column temperature was changed to 105 or 140 degrees C followed by 40 degrees C min(-1) to 200 degrees C and then 15 degrees C min(-1) to 300 degrees C. Using 140 degrees C as the initial oven temperature it was possible to obtain narrower initial analyte distributions for the compounds that elutes at the beginning of the chromatogram as clenbuterol, mabuterol, epimethylenediol and norandrosterone, without loss of derivatized metabolites signal. Later. eluting analytes, such as the stanozolol metabolites, furazabol and oxandrolone were not affected. Temperatures below 140 degrees C. resulted in partial derivatization for some analytes mainly stanozolol related structures. Therefore evaluation of derivatization conditions as occurring in three steps, the vial, vaporization chamber and capillary column, was thoroughly assessed. The new program temperature improves the signal-to-noise ratio for some compounds and shows adequate resolution for endogenous compounds. Some of the difficult key separations necessary for doping control enforcement were also obtained with the proposed method.     

Trends in Preconcentration Procedures for Metal Determination Using Atomic Spectrometry Techniques

 Methods for metal preconcentration are often described in the literature. However, purposes are often different, depending on whether the methods are applied in environmental, clinical or technological fields. The respective method needs to be efficient, give high sensitivity, and ideally also is selective which is useful when used in combination with atomic spectroscopy. This review presents the actual tendencies in metal preconcentration using techniques such as Flame Atomic Absorption Spectrometry (FAAS), Electrothermal Atomic Absorption Spectrometry (ETAAS), Hydride Generation Atomic Absorption Spectrometry (HGAAS), Inductively Coupled Plasma Optical Emission Spectrometry (ICP OES) and Inductively Coupled Plasma Mass Spectrometry (ICP-MS). Procedures based on related to electrochemical, coprecipitation/precipitation, liquid–liquid and solid–liquid extraction and atom trapping mechanisms are presented. Correspondence: Department of Analytical Chemistry, Universidade Estadual de Campinas – UNICAMP, P.O. Box 6154, 13083-970 Campinas, Brazil. e-mail: zezzi@iqm.unicamp.br Received December 20, 2001; accepted October 11, 2002     

Electric field effects on roto-vibrational transitions of13CD3OH1

We used a Stark-Optoacoustic cell and hybrid waveguide resonators to perform an Infrared and Far Infrared Stark Spectroscopy study on some transitions of¹³CD₃OH. Different behaviours of the transitions in the presence of a d.c. electric field were observed. The Stark splittings of six FIR laser lines ranging from 34 to 136 MHz/kVcm^–1 were determined. The analysis of the behaviour of the IR and FIR transitions in the presence of the external electric fields gives important and exclusive information on the levels involved in the transitions.Work Supported by FAPESP, CNPq, FAEP - Brazil, and CNR - Italy.