Determination of the plasticizer N-butylbenzenesulfonamide and the pharmaceutical Ibuprofen in wastewater using solid phase microextraction (SPME)

A rapid, inexpensive and solvent-free method for the simultaneous determination of the polyamide plasticizer N-butylbenzenesulfonamide (NBBS) and the widely used pharmaceutical Ibuprofen by solid phase microextraction (SPME) combined with gas chromatography/mass spectrometry (GC/MSD) in wastewater samples was developed. Besides the optimized analytical conditions, results of investigations with varying analytical parameters are reported. Problems, which may occur during the analytical procedure (e.g. salt deposits, adsorption phenomena, carry-over), are discussed. For the determination of Ibuprofen, it is important to carry out the extraction under acidic conditions with sufficiently buffered samples; the GC/MSD system must be very clean and well maintained. SPME allows an extraction of Ibuprofen without derivatization of its carboxylic group. For quantification in complex matrices, the standard addition technique is necessary. Limit of detection and limit of determination are 0.1 μg/L for both analytes. NBBS and Ibuprofen were detected in several raw and treated wastewater samples from municipal wastewater treatment plants in the range from < 0.1 to 3.5 μg/L.     

Direct quantitative determination of surface Brønsted acidity of solids by H/D exchange using D2O

A highly flexible method for direct and quantitative determination of surface Br?nsted acidity of solids in terms of number, type and strength of the acid sites based on quantitative H/D exchange kinetics between the acid solid and gaseous D2O has been developed and applied to materials covering the whole range of acidity.     

Determination of Organochlorine Pesticides in Sediments from Authie Bay Using Microwave Assisted Solvent Extraction

The aim of this study was to develop an analytical method to determine the organochlorine concentrations in sediments. Combination of Microwave assisted Solvent Extraction (MASE) and capillary gas chromatography with specific detection (electron capture detector) was a viable approach for the determination of pesticides in solid matrixes. In this study, MASE development was focused on the selection of a suitable extraction solvent for all the target analytes. MASE procedure was validated by comparison with conventional methods such as Soxhlet and sonication extraction. The proposed method was then applied to determine the organochlorine insecticides concentrations in samples from Authie Bay (France). Environmental water samples were analysed and five target analytes were detected in concentrations from 0.03 to 0.56 ng/g of dry sediment. These investigations showed the accumulation and the persistency of these products in sediments in spite of the fact they were banned a few decades ago.     

Radical cyclization cascade involving ynamides: an original access to nitrogen-containing heterocycles

A radical cascade involving a 5-exo-dig cyclization followed by a 6-endo-trig radical trapping transforms ynamides into heterogeneous polycyclic compounds in good yields. This leads interestingly to the formation of isoindols, isoindolinones, and pyridoisoindolones. [reaction: see text]     

Direct measurement of gas solubility and diffusivity in poly(vinylidene fluoride) with a high-pressure microbalance

We present solubility and diffusion data for the gases methane and carbon dioxide in the polymer poly(vinylidene fluoride). The polymer was cut from extruded piping intended for use in offshore oil and gas applications. Measurements were carried out using a purpose-built high-pressure microbalance. These properties were determined in the temperature range 80-120 °C and in the pressure range 50-150 bar for methane and 20-40 bar for carbon dioxide. In general, good agreement was obtained for similar measurements reported in the literature. Solubility follows a Henry’s law (linear) dependence with pressure. Diffusion coefficients for each of the gases in the polymer were also measured using the balance. Activation energies for diffusion and heats of solution for the two gases in the polymer were also determined.     

Assignment of the EPR spectrum of 5,5-dimethyl-1-pyrroline N-oxide (DMPO) superoxide spin adduct

[structure: see text] Spin trapping consists of using a nitrone or a nitroso compound to "trap" an unstable free radical as a long-lived nitroxide that can be characterized by electron paramagnetic resonance (EPR) spectroscopy. The formation of DMPO-OOH, the spin adduct resulting from trapping superoxide (O(2)(*)(-)) with 5,5-dimethyl-1-pyrroline N-oxide (DMPO), has been exploited to detect the generation of superoxide in a wide variety of biological and chemical systems. The 12-line EPR spectrum of DMPO-OOH has been either reported or mentioned in more than a thousand papers. It has been interpreted as resulting from the following couplings: A(N) approximately 1.42 mT, A(H)beta approximately 1.134 mT, and A(H)gamma(1H) approximately 0.125 mT. However, the DMPO-OOH EPR spectrum has an asymmetry that cannot be reproduced when the spectrum is calculated considering a single species. Recently, it was proposed that the 0.125 mT splitting was misassigned and actually results from the superimposition of two individual EPR spectra associated with different conformers of DMPO-OOH. We have prepared 5,5-dimethyl-[3,3-(2)H(2)]-1-pyrroline N-oxide (DMPO-d(2)), and we showed that the EPR spectrum of the corresponding superoxide spin adduct is composed of only six lines, in agreement with the assignment of the 0.125 mT splitting to a gamma-splitting from a hydrogen atom bonded to carbon 3 of DMPO. This result was supported by DFT calculations including water solvation, and the asymmetry of the DMPO-OOH EPR spectrum was nicely reproduced assuming a chemical exchange between two conformers.     

Description of oxygen permeability in various high polymers using a graph theoretical approach

Graph theory methods are shown to complement group additivity methods of predicting oxygen permeability in certain types of polymers. Graph theory is a topological approach that assigns a set of indices to a molecule to describe its structure. Since many physical properties of molecules depend upon their structure, graph theory indices can be used to describe important properties of molecules. In this work a set of graph theory indices are used to describe the property of a polymer based on a modified representation of the monomer unit. More specifically, Randic indices are used to describe the log of the oxygen permeability with 3.2% average relative error. Polymers comprising the basis set contain backbones of sp², sp³, or aromatic carbons, oxygen, or silicon and have substituents that contain chloride, fluoride, alkyl groups, hydrogen, oxygen, aromatic carbons, or chloro and/or fluoro substituted alkyl groups. The correlation coefficient (R²) (0 ≤ R² ≤ 1) of a nonlinear model is 0.91. The graph theory method for describing the oxygen permeability of these selected groups of polymers is in good agreement with that predicted by the permachor model. The permachor method makes oxygen permeability predictions based upon group additivity and distinguishes the degree of crystallinity of a polymer by empirically assigning different permachor (π) values to identical groups based upon the polymer crystallinity. The inability of graph theory to explain the remaining 9% of the scatter in the data is probably due to failure to incorporate into the graph theory model terms which quantify crystallinity.     

Characterization of PEDOT film functionalized with a series of automated synthesis ferrocenyl-containing oligonucleotides

In previous works we have described a fully automated synthesis of new ferrocene labelled oligonucleotides (Fc-ODNs) probes with one or more electroactive markers at different position in the chain. These Fc-ODNs have shown good properties to detect ODN target in solution. Here we describe the post-functionalization of a conducting co-polymer based on ethylenedioxythiophene (EDOT) derivatives by a series of Fc-ODNs. The grafting of the Fc-ODNs probes resulted in the appearance of the ferrocene redox couple which directly confirm the effectiveness of the ODN anchoring compared to traditional approach based on IR spectroscopy and X-ray fluorescence of the films. Moreover, the electrochemical response of the modified electrodes analysed in organic media before and after hybridization with ODN target confirm that properties obtain in solution for Fc-ODNs already exist in the film. The changes in the current intensity were found to be dependant on the structure of the grafted ODN that validate our strategy to synthesize an optimal Fc-ODNs.     

Improved solid-phase peptide synthesis of ‘difficult peptides’ by altering the microenvironment of the developing sequence

Three types of resins, related to the spacer, environmental and microenvironmental models were prepared by grafting commercial AMP polymer with 2-[2-(2-aminoethylamino)-2-oxoethoxy]acetic acid. All resins were highly loaded and functionalized with Rink-amide linker. A comparative synthesis of the classic difficult sequence ACP (65-74) on the prepared resins by Fmoc/t-Bu chemistry is presented. The ‘microenviromental’ model resin afforded the crude peptide in the highest purity (98%).     

Efficient, protection-free Suzuki-Miyaura synthesis of ortho-biphenyltetrazoles

We describe an efficient protocol for the Suzuki-Miyaura synthesis of ortho-biphenyltetrazoles from non-protected 2-bromophenyltetrazole and arylboronic acids. The optimised conditions were achieved using [1,1′-bis(diphenylphosphino)ferrocene]dichloropalladium(II) as catalyst and Na₂CO₃ as base. A panel of structurally diverse arylboronic acids was used to demonstrate the scope of the coupling procedure.