An Investigation of Inclusion Complexes of Cyclodextrins with Phenylurea Herbicides by Photochemically-Induced Fluorescence. Analytical Applications

The effect of -cyclodextrin (-CD) and hydroxypropyl--cyclodextrin (HP--CD) upon the photochemically-induced fluorescence (PIF) properties of four phenylurea herbicides, including linuron, diuron, isoproturon and neburon has been studied. Photochemical conversion of these nonfluorescent herbicides into strongly fluorescent photoproducts was shown to occur in -CD and HP--CD aqueous media. The influence of pH, UV irradiation time and photoproduct stability on the fluorescence intensity was also investigated. In addition, the stoichiometry and formation constants of the complexes formed between herbicides and -cyclodextrin (-CD) or 2-hydroxypropyl--cyclodextrin (HP--CD) were determined. The formation constant values, ranging from 184 ± 40 to 1498 ± 245 M^-1, were calculated by applying the iterative nonlinear regression (NLR) approach to the PIF data. Linear calibrations graphs were established in the interval 1–12 g/mL, for diuron, linuron and neburon. The IUPAC limits of detection ranged between 580 and 700 ng/mL, according to the compound. Application to the analysis of phenylurea herbicides in spiked river water was also described.     

Control of the Properties of Carbon Nanotubes Synthesized by CVD for Application in Electrochemical Biosensors

Interest in carbon nanotubes (CNT) has grown at a very rapid rate in the last decade. Their interesting physical and chemical properties open attractive possibilities in many application areas. These properties depend on the process conditions during synthesis and on subsequent purification steps. Recent studies have demonstrated that CNT can promote the electron transfer of biomolecules. These exceptional properties make them attractive for use in electrochemical biosensors. Multi walled nanotubes have been synthesized by the Chemical Vapor Deposition (CVD) method using methane as a carbon source and Ni–Al₂O₃–SiO₂ as the catalyst. The influence of the variation of certain reaction parameters such as feed gas composition, catalyst mass, temperature and reaction time in the yield of the CVD process has been established. In addition, the structural and chemical characteristics of the CNTs have been studied and a purification process to eliminate the catalyst and amorphous carbon has been developed that involves a gaseous oxidative process and acid treatment. The efficiency of the purification step has been determined by analytical techniques. Atomic force microscopy, Raman scattering, thermogravimetric analysis, inductively coupled plasma atomic spectroscopy are the characterization techniques employed in this work.     

用原子捕获技术提高火焰原子吸收光谱法的灵敏度

采用简易的石英原子捕获器，使Ｃｕ，Ａｇ，Ａｕ，Ｚｎ，Ｃｄ，Ｐｂ，Ｓｂ，Ｂｉ等易挥发元素在空气－乙炔火焰原子吸收光谱法中的灵敏度提高了３～５倍，并有较好的精密度，相对标准偏差在１％左右，方法中用此技术测定了标准物质中Ｐｂ、Ｃｄ的含量，获得了满意的结果，它较之石墨炉原子吸收光地具有快速，简便的特点，具有较大的实用价值。     

Intraframework potential energy function of zeolites

Potential energy functions suitable for the (Cs_1–xNa_xT₂O₄)-A type zeolite family were obtained from the known crystal structure of Cs₇Na₅-A zeolite. Using these potential functions, several other crystal structures in these family were obtained by molecular mechanical calculations. The activation energy - to -cage transmission of the H₂ molecule and the void volume of Cs₃Na₉-A zeolite were calculated.     

Synthesis and characterization of block copolymers from 2‐vinylnaphthalene by anionic polymerization

The anionic polymerization of 2‐vinylnaphthalene (2VN) has been studied in tetrahydrofuran (THF) at ?78 °C and in toluene at 40 °C. 2VN polymerization in THF, toluene, or toluene/THF (99:1 v/v) initiated by sec‐butyllithium (sBuLi) indicates living characteristics, affording polymers with predefined molecular weights and narrow molecular weight distributions. Block copolymers of 2VN with methyl methacrylate (MMA) and tert‐butyl acrylate (tBA) have been synthesized successfully by sequential monomer addition in THF at ?78 °C initiated by an adduct of sBuLi–LiCl. The crossover propagation from poly(2‐vinylnaphthyllithium) (P2VN) macroanions to MMA and tBA appears to be living, the molecular weight and composition can be predicted, and the molecular weight distribution of the resulting block copolymer is narrow (weight‐average molecular/number‐average molecular weight < 1.3). Block copolymers with different chain lengths for the P2VN segment can easily be prepared by variations in the monomer ratios. The block copolymerization of 2VN with hexamethylcyclotrisiloxane also results in a block copolymer of P2VN and poly(dimethylsiloxane) (PDMS) contaminated with a significant amount of homo‐PDMS. Poly(2VN‐b‐nBA) (where nBA is n‐butyl acrylate) has also been prepared by the transesterification reaction of the poly(2VN‐b‐tBA) block copolymer. Size exclusion chromatography, Fourier transform infrared, and ¹H NMR measurements indicate that the resulting polymers have the required architecture. The corresponding amphiphilic block copolymer of poly(2VN‐b‐AA) (where AA is acrylic acid) has been synthesized by acidic hydrolysis of the ester group of tert‐butyl from the poly(2VN‐b‐tBA) copolymer. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 40: 4387–4397, 2002     

A study of some trace elements in infant foods

Seven trace elements were determined in milk formulas, powder milk and infant food. Instrumental neutron activation analysis was used for the analysis of Fe, Zn, Co, Cr and Rb, while As and Cu content was determined using radiochemical neutron activation analysis. Differences were found in the trace element content of foods of the same type. Milk formulas are comparable with human milk according to the results obtained for the elements analyzed. The samples of powder cow's milk presented similar concentrations of the elements studied. Liver with vegetables was found to have the highest Cu content. A meal prepared at home, made of beef and fresh vegetables showed a higher trace element content than its similar commercial one. An estimation of the daily intake of the elements analyzed was made and compared with minimum recommended daily ingestion.     

Mineralization mechanism of calcium phosphates under three kinds of Langmuir monolayers

Three kinds of Langmuir monolayers formed by dipalmitoylphosphatidylcholine (DPPC), arachidic acid (AA), and octadecylamine (ODA) were used as templates to study the initial stage of nucleation and crystallization of calcium phosphates. It was demonstrated that the combination of calcium ions (or phosphates) to the monolayer/subphase interface is a prerequisite for subsequent nucleation. It was found that calcium phosphate dihydrate (DPCD) formed at 25.0 degrees C for 12 h has a biphasic structure containing both amorphous and crystalline phases. These results showed that calcium phosphates were formed through a multistage assembly process, during which an initial amorphous phase DPCD was followed by a phase transformation into a crystalline phase and then the most stable hydroxyapatite (HAp). This provided new insights into the template-biomineral interaction and a mechanism for biomineralization.     

金纳米粒子在氨基表面上的组装-pH值的影响

用原子力显微镜（AFM）和表面增强喇曼光谱（SERS）研究了pH值对金纳米粒子在Au／巯基苯胺自组装膜表面上组装效果的影响．AFM结果表明，金纳米粒子在表面上的覆盖度随pH值表现出规律性的变化，巯基苯胺自组装膜的SERS强度随pH值的变化也有类似的趋势．在磁性环境下，氨基未质子化，金粒子难以组装上，而在酸性条件下，氨基质子化带正电，金粒子与基底容易结合．我们认为金纳米粒子和氨基之间的作用属于静电力，pH值同时影响膜表面氨基的质子化程度和金纳米粒子表面的带电量．     

A facile synthesis of highly functionalized dihydrofurans based on 1,4-diazabicyclo[2.2.2]octane (DABCO) catalyzed reaction of halides with enones

Treatment of halides 5 with electrophilic alkenes 2 afforded the corresponding dihydrofurans 3 and 4 in the presence of 1, 4-diazabicyclo[2.2.2]octane (DABCO) with good to excellent yields and in a stereoselective manner in most cases. Moreover, the stereoisomers 3 and 4 could be easily transformed each other in the presence of 1,8-diazabicyclo[5.4.0]undec-7-ene (DBU).     

Long term stability of organic selenium species in aqueous solutions

Long term stability of organic selenium compounds (selenocystine, selenomethionine, trimethylselenonium ion) has been studied over a one year period for 2 analyte concentrations: 25 and 150 μg/L Se, at pH 4.5 in the dark, under different storage conditions: temperature of –20°C, 4°C, 20°C, 40°C; in Pyrex, Teflon, or polyethylene containers; in an aqueous matrix or in the presence of a chromatographic counter ion (pentyl sulfonate at 10^–4 mol/L concentration). Light effects have also been tested. The stability of the selenium species was monitored by HPLC-ICP/MS. Storage conditions can drastically alter the stability of organic selenium species. Organoselenium compounds were shown to be stable in the dark over a one year period in an aqueous matrix at pH 4.5 in Pyrex containers at both 4°C and 20°C. Pyrex vials exposed to natural sunlight at room temperature resulted in a steady decrease of the selenoamino acid concentration. Teflon containers caused losses of less than 25% at both 4° C and 20° C in the dark. However, polyethylene vials presented, at all temperatures tested, a rapid decrease of the TMSe⁺ concentration. The stability of the Se species studied did not show significant differences between 4° C and 20° C in any container material used. Storage of solutions at 40° C led to slight differences between the Pyrex and Teflon containers. However, polyethylene presented a drastic decrease of the three species over time at this higher temperature. Solutions frozen at –20° C in polyethylene vials did not stabilize the TMSe⁺ signal. Finally, concentrations and matrices of the samples did not significantly affect the stability of the species. Received: 15 July 1996 / Revised: 14 July 1997 / Accepted: 18 July 1997