Heat capacity of paramagnetic nickelocene: Comparison with diamagnetic ferrocene

Nickelocene [bis(η⁵-cyclopentadienyl)nickel: Ni(C₅H₅)₂, electron spin S=1, the ground state configuration ³A_2g] is paramagnetic and belongs to a typical molecule-based magnet. Heat capacities of nickelocene have been measured at temperatures in the 3−320 K range by adiabatic calorimetry. By comparing with those of diamagnetic ferrocene crystal, a small heat capacity peak centered at around 15 K and a sluggish hump centered at around 135 K were successfully separated. The low-temperature peak at 15 K caused by the spin is well reproduced by the Schottky anomaly due to the uniaxial zero-field splitting of the spin S=1 with the uniaxial zero-field splitting parameter D/k=45 K (k: the Boltzmann constant). The magnetic entropy 9.7 J K⁻¹ mol⁻¹ is substantially the same as the contribution from the spin-manifold R ln 3=9.13 J K⁻¹ mol⁻¹ (R: the gas constant). The sluggish hump centered at around 135 K arises from rotational disordering of the cyclopentadienyl rings of nickelocene molecule. The enthalpy and entropy gains due to this anomaly are 890 J mol⁻¹ and 6.9 J K⁻¹ mol⁻¹, respectively. As the hump spreads over a wide temperature region, separation of the hump from the observed heat capacity curve involves a little bit ambiguity. Therefore, these values should be regarded as being reasonable but tentative. The present entropy gain is comparable with 5.5 J K⁻¹ mol⁻¹ for the sharp phase transition at 163.9 K of ferrocene crystal. This fact implies that although the disordering of the rings likewise takes place in both nickelocene and ferrocene, it proceeds gradually in nickelocene and by way of a cooperative phase transition in ferrocene. A reason for this originates in loose molecular packing in nickelocene crystal. Molar heat capacity and the standard molar entropy of nickelocene are larger than those of ferrocene beyond the mass effect over the whole temperature region investigated. This fact provides with definite evidences for the loose molecular packing in nickelocene crystal.     

Ganglioside GM3 Derivatives with Truncated Ceramide Moiety: Facial Synthesis and Inhibitory Activity against KB Cell Growth

An expeditious sialylation reaction with phenylthioglycoside 4 as a sialyl donor and MeSOTf as a promoter was developed. These conditions are very useful for synthesizing ganglioside GM₃ (1), its C8‐ceramide analog 2, and 3‐deoxy analog 3 of 2 in an efficient manner. The GM₃ analog 2, whose hydrophilicity is increased by shortening the ceramide moiety, exhibits increased growth inhibiton of KB cells. The 3‐hydoxy group of ceramide does not influence its activity against KB cells.     

Mechanism of Reaction of Polyvinyl Chloride) with Triethylaluminum

Polyvinyl chloride) was treated with triethylaluminum in 1,2-dichloroethane solution. Negligibly small amounts of hydrogen chloride are evolved from the modified polyvinyl chloride) in decomposition at 180°C for 150 min in nitrogen. Quantitative analysis of the rate of dehydrochlorination of the modified polymer gave a calculated activation energy for the alkylation of 8.3 kcal/mole in 1,2-dichloroethane solution; the concentration of the labile chlorines in the original polyvinyl chloride) was less than 0.25 mole % Furthermore, the fact that the average polyene length of the modified polymer for the thermal decomposition was much shorter than that of the starting material suggests that the labile chlorines inherent in the polymer exist not only in the chain end but also in the polymer chain.     

KINETIC STUDIES ON THE ADDITION OF p-TOLUENESULFINIC ACID TO BENZYLIDENEACETOPHENONES

Abstract

Kinetics of the addition of p-toluenesulfinic acid to p-substituted benzylideneacetophenones has been investigated. The reaction was second order, first order each in the concentration of sulfinic acid and chalcone. Effects of the p-substituents on the reaction rate were small (rho = 0.4). The reaction was strongly acid catalyzed.     

Proton Conductivities of Graphene Oxide Nanosheets: Single,Multilayer, and Modified Nanosheets

Proton conductivities of layered solid electrolytes can be improved by minimizing strain along the conduction path. It is shown that the conductivities (σ) of multilayer graphene oxide (GO) films (assembled by the drop‐cast method) are larger than those of single‐layer GO (prepared by either the drop‐cast or the Langmuir‐Blodgett (LB) method). At 60 % relative humidity (RH), the σ value increases from 1×10⁻⁶ S cm⁻¹ in single‐layer GO to 1×10⁻⁴ and 4×10⁻⁴ S cm⁻¹ for 60 and 200 nm thick multilayer films, respectively. A sudden decrease in conductivity was observed for with ethylenediamine (EDA) modified GO (enGO), which is due to the blocking of epoxy groups. This experiment confirmed that the epoxide groups are the major contributor to the efficient proton transport. Because of a gradual improvement of the conduction path and an increase in the water content, σ values increase with the thickness of the multilayer films. The reported methods might be applicable to the optimization of the proton conductivity in other layered solid electrolytes.     

Structural change of a cofactor binding site of flavoprotein detected by single-protein fluorescence spectroscopy at 1.5 k

The visible fluorescence spectrum of single flavoprotein at a temperature of 1.5 K has been measured by one-photon excitation. The flavoprotein studied was a photoswitchable enzyme, photoactivated adenylyl cyclase. The time course of the spectrum revealed a structural change occurring at a rate of 10(-3) s(-1) around hydrogen bonds at the flavin cofactor binding site.     

A Fullerene‐Based Molecular Torsion Balance for Investigating Noncovalent Interactions at the C60 Surface

To investigate the nature and strength of noncovalent interactions at the fullerene surface, molecular torsion balances consisting of C₆₀ and organic moieties connected through a biphenyl linkage were synthesized. NMR and computational studies show that the unimolecular system remains in equilibrium between well‐defined folded and unfolded conformers owing to restricted rotation around the biphenyl C?C bond. The energy differences between the two conformers depend on the substituents and is ascribed to differences in the intramolecular noncovalent interactions between the organic moieties and the fullerene surface. Fullerenes favor interacting with the π‐faces of benzenes bearing electron‐donating substituents. The correlation between the folding free energies and corresponding Hammett constants of the substituents in the arene‐containing torsion balances reflects the contributions of the electrostatic interactions and dispersion force to face‐to‐face arene–fullerene interactions.     

Advances in Artificial Cell Membrane Systems as a Platform for Reconstituting Ion Channels

An artificial cell membrane that is composed of bilayer lipid membranes (BLMs) with transmembrane proteins incorporated within them represents a well‐defined system for the analysis of membrane proteins, especially ion channel proteins that are major targets for drug design. Because the BLM system has a high compatibility with recently developed cell‐free expression systems, it has attracted attention as a next‐generation drug screening system. However, three issues associated with BLM systems, i. e., their instability, the need for non‐volatile organic solvents and a low efficiency of ion channel incorporation, have limited their use as a drug screening platform. In this personal account, we discuss our recent approaches to address these issues based on microfabrication. We also discuss the potential for using the BLM system combined with cell‐free expression systems as a drug screening system for future personalized medicine.