Neutron activation analysis of microgram amounts of thorium in uranium ores and process liquors by means of thorium-233

A method is described for neutron activation analysis of thorium by employing thorium-233. Decontamination steps include anion exchange in 12.5 N HCL, precipitation of fluoride, extraction with mesityl oxide and thorium oxalate precipitation. The time spent is less than 1 h; spurious activities in counting samples amount only to 2% and can easily be corrected for. The sensitivity of the method is ca. 0.02 μg of thorium in a neutron flux of 10¹²n/cm²/sec with an irradiation time of 5 min.     

Concentration effects in gel permeation chromatography : IV. Contribution of viscosity phenomena and macromolecular expansion

The changes in elution volumes with the changes in the concentration of an injected polymer solution are caused by several contributing effects. Under model conditions, it is possible to assume only the effect of a viscosity gradient in a zone moving along the column and the effect of the concentration dependence of the hydrodynamic volume of a macromolecular coil. The non-Gaussian shape of the zone and the dependence of the width of the elution curve on concentration are factors that complicate the theoretical treatment of concentration effects. The described physico-chemical model allows to evaluate the ratio of mentioned two contributions in the concentration dependence of elution volumes. According to this model, the contribution of the concentration dependence of the hydrodynamic volume does not exceed about 20% of the total change in elution volume with the varying concentration under real experimental conditions. The efficiency of the columns used and the total injected volume of the polymer solution affect this ratio only negligibly. It is obvious from a comparison with earlier results that these conclusions are not fundamentally changed even by the revised model of the concentration dependence of the swelling factor.     

Synthetische Versuche in der Gruppe hypotensiv wirksamer Alkaloide, 13. Mitt.: Synthese vondl-10-Methyldeserpidin,dl-10-Äthoxydeserpidin unddl-10-Methylmercapto-deserpidin

Zusammenfassung Die durch Umsetzung von 5-Methyltryptamin, 5-Äthoxytryptamin und 5-Methylmercapto-tryptamin (I, R=CH₃, OC₂H₅ bzw. SCH₃) mit dem racemischen Aldehyd-Ester II entstandenenSchiffschen Basen wurden durch Natriumborhydrid-Reduktion in Methanol unter gleichzeitiger Cyclisierung und Desacetylierung in die entsprechenden 10-substituiertendl-Methyl-2,3-seco-3-oxodeserpidate (IV) übergeführt. Die bei der Einwirkung von 3,4,5-Trimethoxybenzoylchlorid in Pyridin erhaltenen Ester V wurden weiter mit Phosphoroxychlorid cyclisiert und die Produkte als Perchlorate (VI) mit Zink in sauerer Lösung zu den entsprechenden 10-substituiertendl-Deserpidinen (VII, R=CH₃, OC₂H₅ bzw. SCH₃) reduziert. Mit Hilfe der Chromatographie gelang es in zwei Fällen, aus den Rohprodukten auch die entsprechendendl-3-Isodeserpidine (VIII, R=CH₃ bzw. OC₂H₅) zu isolieren. Zum Unterscheiden der Produkte der normalen Reihe (VII) und der 3-Iso-Reihe (VIII) wurden IR-Spektren und die Papierchromatographie angewendet.Mit 2 Abbildungen     

On-line filtration system for determining total chromium and chromium in the soluble fraction of industrial effluents by flow injection flame atomic absorption spectrometry

Two manifolds were assessed for the purpose of determining both the total chromium content and that present as a soluble form in industrial effluents by flow injection flame atomic absorption spectrometry (FI-FAAS). To determine the chromium content in the soluble fraction the samples were used without additional treatment, a 0.45 microm filter being included in the FI system. To determine the total chromium content, the samples were acidified with nitric acid 20% (v/v) and heated for 30 s in a microwave oven (temperatures of about 70 degrees C were reached). The problem posed by the very different concentration range in which total and soluble chromium are present was overcome by using programmed flow rate methodology and by only partially emptying the sample loop. A personal computer controlled both the rotation speed of a peristaltic pump and the volume of sample injected into the system, thus obtaining the dispersion degree required. Using the manifold proposed, the chromium content in the soluble fraction can be determined in the 0.5-20 microg mL(-1) range using a 10 microg mL(-1) single standard for calibration. To determine the total chromium content, a calibration line in the 20-200 microg mL(-1) range was obtained using a single 50 microg mL(-1) chromium standard solution. The reliability of the semi-automatic devices was verified by comparing the results obtained with those found by treating the samples and using both FAAS in a conventional way and a spectrophotometric method using diphenylcarbazide at the 95% confidence level (ANOVA test). The proposed procedures showed a RSD lower than +/-3%.     

Electrodeposition of cobalt on stainless steel foils. Preparation of57Co sources for Mössbauer experiments

Conditions for the electrodeposition of⁵⁹Co and⁵⁷Co on stainless steel foils have been studied. A set of electrolytic parameters has been determined to get a reasonably good electrodeposited sample. The⁵⁷Co electrodeposited foil was then introduced in a quartz tube to be annealed in an argon flow. The final product was a 11 Ci Mössbauer source for college experiments which was succesfully tested by obtaining spectra of stainless steel and sodium nitroprusside.     

Effects of genesis and ionizing radiation on the kinetics of reduction of NiO-CeO2 mixed oxides with hydrogen

The reduction of mixed oxides NiO-CeO₂ of various composition with hydrogen was studied at 290–470° by means of thermogravimetry. Some physicochemical properties of the system were also investigated and compared with earlier studied analogous samples of different “origin”. The degree of mutual interaction of the two components, the reduction kinetics and the sensitivity to the different sorts of radiation (gamma-rays, fast neutrons and electrons), applied in different doses, are strongly affected by the “pre-history” and by the composition in both compared series of mixed oxides.     

Determination of iron at ng/ml level by solid phase spectrophotometry after preconcentration on cation exchange filters

A cationic exchanger paper is used to retain analytes in solution and, after drying, to analyze directly by measuring the UV-Vis absorbance of the paper. The method was applied to determination of iron using its known 1,10-phenanthroline complex. Using 100 ml of sample the applicable concentration range was between 1.0 and 10.0 ng/ml with a detection limit of 0.2 ng/ml and a RSD around 2%. The method was applied to determination of iron total in snow, human serum and wine.     

Nucleocyclitols. Synthesis of substituted purinyl-muco-inositol derivatives

Several carbocyclic nucleoside analogs possessing a 6-substituted purine linked to a mesylated muco-inositol were synthesized. The coupling of triethylamine-activated 6-chloropurine with 2,3-anhydro-l,5,6-tri-O-(methanesulfonyl)-epi-inositol gave a 6-chloro purinyl muco-inositol amenable to further synthetic transformations in the heterocyclic moiety by substitution of the chlorine atom by nitrogen nucleophiles such as methylamino, diethylamino, benzylamino, hydrazino, morpholino, hydroxylamino, piperidino, and glycyl groups.     

Some applications of gel-permeation chromatography in investigations of structure and the solution properties of radical-initiated poly(vinyl chloride)

The applicability of the published universal calibration parameters for gel-permeation chromatography on polystyrene standards and poly(vinyl chloride) samples with a defined structure has been compared. It was shown experimentally that of several theoretically possible molecular weight averages attributed to the elution volume at the position of the peak maximum, the root mean-square average molecular weight M _Rms = (M _wM _n)^0.5 shows the best accordance. The molecular weights obtained by gel-permeation chromatography were compared with those determined by viscometry, osmometry, and the light-scattering method. The reproducibility of gel-permeation chromatography measurements is 3%, and the average variance of the results as compared with results obtained by the above methods is about 8%. It was also found that the gel-permeation chromatography does not involve any anomalies interfering with results obtained by other methods.     

Molecular dynamics simulations of the dinuclear zinc-beta-lactamase from Bacteroides fragilis complexed with imipenem

Herein, we present results from MD simulations of the Michaelis complex formed between the dizinc beta-lactamase from B. fragilis and imipenem. We considered two catalytically important configurations, which differ in the presence or absence of a hydroxide bridge connecting the two zinc ions in the active site. The structural and dynamical effects induced by substrate binding, the specific roles of the conserved residues and the zinc-bound water molecules, the near attack conformers of the Michaelis complex, and so forth, are discussed in detail. The relative stability of the two configurations was estimated from QM linear scaling calculations on the enzyme-substrate complex combined with Poisson-Boltzmann electrostatic calculations and normal mode calculations. Importantly, we find that the two configurations have similar energies, indicating that these two structures could readily be interchanged, thereby facilitating catalysis. The configuration with the hydroxide bound to the two zinc ions is predicted to be the resting form of the enzyme, while the configuration without the bridge is the reactive form that was found to place the hydroxide in position to attack the carbonyl of the beta-lactam ring. Thus, we propose that the enzyme initiates catalysis by converting from the hydroxide bridge form into the configuration that lacks the hydroxide bridge. This interconversion increases the nucleophilicity of the hydroxide ion and exposes it to the beta-lactam carbonyl, which ultimately facilitates nucleophilic attack. The implications of the observed modes of binding, the possible influence of mutating the Lys184 and Asn193 residues on substrate binding, and the reaction mechanism are also discussed in detail.