Methane Conversion to C2 Hydrocarbons Using Dielectric-barrier Discharge Reactor: Effects of System Variables

The partial oxidation of methane to C₂ hydrocarbons was investigated experimentally in a dielectric-barrier discharge (DBD) reactor. The effects of reactor wall temperature, input gas flow rate and volumetric ratio of methane to oxygen over methane conversion and C₂ production were investigated. The highest C₂ selectivity of about 50% was achieved at 1.8% methane conversion. Finally the model equations were used to correlate methane conversion and ethylene selectivity with the system variable within the studied range of them. The correlation equation shows the sole effects and interaction effects of system variables on methane conversion and ethylene selectivity.     

Effect of iodine doping on the electrical transport mechanism in plasma polymerized 2,6-diethylaniline thin films

The current density–voltage characteristics of pure and iodine doped plasma polymerized 2,6-diethylaniline (PPDEA) thin films of different thicknesses ranging from 150 to 450 nm with aluminum (Al)/PPDEA/Al structure have been investigated at room temperature. The direct current electrical conductivity has showed a higher value due to iodine doping of PPDEA thin film. In contrast to pure PPDEA thin films where the most probable conduction mechanism is electrode limited Schottky type, Poole–Frenkel (PF) conduction mechanism is found to be operative in iodine doped PPDEA thin films. The PF conduction mechanism in iodine doped PPDEA thin films may have generated due to the charge transfer complex formation through donor type monomer and acceptor type iodine. The presence of charge transfer complex is confirmed by a new absorption shoulder/peak in ultraviolet–visible spectrum of iodine doped PPDEA thin film.     

An Anonymous Surveying Protocol via Greenberger-Horne-Zeilinger States

A new experimentally feasible anonymous survey protocol with authentication using Greenberger-Horne-Zeilinger (GHZ) entangled states is proposed. In this protocol, a chief executive officer (CEO) of a firm or company is trying to find out the effect of a possible action. In order to prepare a fair voting, the CEO would like to make an anonymous survey and is also interested in the total action for the whole company and he doesn’t want to have a partial estimate for each department. In our proposal, there are two voters, Alice and Bob, voting on a question with a response of either ”yes” or ”no” and a tallyman, whose responsibility is to determine whether they have cast the same vote or not. In the proposed protocol the total response of the voters is calculated without revealing the actual votes of the voters.     

Effects of Brownian Motion and Thermophoresis on the Mixed Convection of Nanofluid in a Porous Channel Including Flow Reversal

This article is devoted to combined convection heat transfer of nanofluids through a vertical channel filled with a homogeneous and isotropic porous medium. The flow is assumed to be fully developed and the “Brinkman extended Darcy” model is used for the flow in the porous media and “clear compatible” viscous dissipation model is considered. Also the model utilized for the nanofluid incorporates the effects of Brownian motion and thermophoresis. The governing momentum, energy, and nanopartices volume fraction equations are solved both analytically and numerically. The effects of the influential dimensionless parameters such as Brownian and thermophoresis parameters, mixed convection parameter (Gr/Re), Brinkman, Darcy and Lewis numbers on dimensionless velocity and temperature distributions and pressure drop are studied. Also, the results of the Nusselt number for the both left and right walls are presented and discussed.     

Quantification of sofosbuvir in human serum by liquid chromatography with negative ionization mass spectrometry using the parent peak and its source‐induced fragment: Application to a bioequivalence study

In the mass spectrometry of sofosbuvir, a new orally administered antihepatitis C drug, a weak peak is detected at the m/z value of the parent ion (m/z 530) as a result of in‐source dissociation and current methods to its quantification, is based on monitoring of the parent peak using ultra high‐performance liquid chromatography with tandem mass spectrometry. With these methods serum concentration of the drug is quantifiable only up to 4–5 h postdose. However, the fragmentation of the molecule generates a more stable ion at m/z 287 (base peak) with a signal intensity of about tenfold compared to the parent ion. Our study was aimed to improve sensitivity of analysis by acquisition of the m/z value of the daughter ion from which it originated instead of the parent molecule. This novelty allows us to measure serum concentrations of the drug for a longer time postdose and provides more opportunity for pharmacokinetic studies of sofosbuvir. Our method was linear over the concentration range of 2–2560 ng/mL of sofosbuvir in human serum with a limit of quantification of 2 ng/mL compared to 10 ng/mL reported previously. The coefficient variation values of both inter and intraday analysis were less than 13.8%, and the percentage error was less than 6.3.     

Determination of BTEX in Water Samples with an SPME Hollow Fiber Coated Copper Wire

A piece of copper wire coated with a polypropylene hollow fiber membrane was used as an SPME fiber and its efficiency for extraction of BTEX compounds from the headspace of water samples prior to GC analysis was evaluated. Under optimum extraction conditions, limits of detection for benzene, toluene, ethylbenzene, m-p-xylene, and o-xylene were found to be 0.11, 0.22, 0.26, 0.37, and 0.26 μg L^?1, respectively. Low detection limits, wide linear dynamic ranges, good reproducibility (RSD% <4), high fiber capacity and higher mechanical durability are some of the most important advantages of the new fiber.     

Preparation of La-Mo-V mixed-oxide systems and their application in the direct synthesis of acetic acid

In this study, mixed metal oxides developed with a perovskite-type structure that show great potential for use in catalysis. Perovskite oxide catalysts with the composition LaMoxV1-xOn （x = 0.1, 0.3, 0.5, 0.7, and 0.9） have been synthesized by the sol-gel method and then used in the ethane dry reforming reaction for the direct synthesis of acetic acid. The influence of the nature of the metallic source （metal, nitrate, acetylacetonate, and ammonium） on gel formation has been studied by Fourier-transform infrared spectroscopy （FT-IR） and thermogravimetric analysis （TGA-DTA）. After calcination, the obtained perovskites were characterized by X-ray diffraction （XRD） and energy-dispersive X-ray spectrometry （EDS） coupled with scanning electron microscopy （SEM）. The catalysts were then subjected to thermo-programmed reduction （TPR）. The surface area （BET） was found to increase from 2.6 m^2/g （x = 0.1） to 5.1 m2/g （x = 1.0） with increasing molybdenum content following calcinations at 750 °C, and pure LaMoxV1-xOn perovskite was obtained with good homogeneity. The catalysts have been characterized by XRD, SEM, EDS, and carbon analysis （CA）. The results indicate that through this synthesis it is possible to obtain highly crystalline, homogeneous and pure solids, with well-defined structures. The direct synthesis of acetic acid from ethane over the perovskite catalysts was studied at temperatures between 450 and 850 °C and elevated pressures between 1 and 8 bar. It was found that the yield of acetic acid and the selectivity of its formation could be increased by incorporating more molybdenum into the perovskite structure. The experimental studies have shown that the calcination temperature and the molybdenum content have a significant influence on the catalytic activity. Amongst the catalysts tested, LaMo0.7V0.3O4.2 exhibited the best activity and stability.     

Role of the ubiquitin proteasome system in Parkinson's disease

Parkinson's disease (PD) is the most common neurodegenerative movement disorder. Although a subject of intense research, the etiology of PD remains poorly understood. Recently, several lines of evidence have implicated an intimate link between aberrations in the ubiquitin proteasome system (UPS) and PD pathogenesis. Derangements of the UPS, which normally functions as a type of protein degradation machinery, lead to alterations in protein homeostasis that could conceivably promote the toxic accumulation of proteins detrimental to neuronal survival. Not surprisingly, various cellular and animal models of PD that are based on direct disruption of UPS function reproduce the most prominent features of PD. Although persuasive, new developments in the past few years have in fact raised serious questions about the link between the UPS and PD. Here I review current thoughts and controversies about their relationship and discuss whether strategies aimed at mitigating UPS dysfunction could represent rational ways to intervene in the disease. Publication history: Republished from Current BioData's Targeted Proteins database (TPdb; http://www.targetedproteinsdb.com).     

LC Determination of Trace Amounts of Phenoxyacetic Acid Herbicides in Water after Dispersive Liquid–Liquid Microextraction

Dispersive liquid–liquid microextraction (DLLME) for extraction and preconcentration of phenoxyacetic acid herbicides in water samples is described. After adjusting the pH to 1.5, the sample was extracted in the presence of 10% w/v sodium chloride by injecting 1 mL acetone as disperser solvent containing 25 μL of chlorobenzene as extraction solvent. The effect of parameters, such as the nature and amount of extraction and disperser solvents, ionic strength of the sample, pH, temperature and extraction time were optimized. DLLME was followed by LC for the determination of 2,4-dichlorophenoxyacetic acid and 4-chloro-2-methyl phenoxyacetic acid. The method had good linearity and a wide linear dynamic range (0.5–750 μg L^?1) with a detection limit of 0.16 μg L^?1 for both the PAAs, making it suitable for their determination in water samples.