Effect of residual oxygen on ionization processes of Si and Si sputtered from Si(1 1 1)-7 × 7 surface

The effect of residual oxygen impurity on ionization processes of Si⁺ and Si²⁺ has been studied quantitatively. In this study, ion sputtering experiments were carried out for a Si(1 1 1)-7 × 7 surface, irradiated with 9-11 keV Ar⁰ and Kr⁰ beam. Even if the oxygen concentration is less than the detection limit of Auger electron spectrometry, SiO⁺ and SiO₂⁺ ions have been appreciably observed. Moreover, as the SiO⁺ and SiO₂⁺ yields increases, the Si⁺ yield is slightly enhanced, whereas the Si²⁺ yield is significantly reduced. From the incidence angle dependence of secondary ion yields, it is confirmed that Si⁺* (Si⁺ with a 2p hole) created in the shallow region from the surface exclusively contributes to Si²⁺ formation. By assuming that the SiO⁺ and SiO₂⁺ yields are proportional to the residual oxygen concentration, these observations are reasonably explained: The increase of Si⁺ with the increase of residual oxygen is caused by a similar effect commonly observed for oxidized surfaces. The decrease of Si²⁺ yield can be explained by the inter-atomic Auger transition between the residual oxygen impurity and Si⁺*, which efficiently interferes the Si²⁺ formation process.     

The growth mechanism and supercapacitor study of anodically deposited amorphous ruthenium oxide films

In the present study, ruthenium oxide (RuO₂) thin films were deposited on the stainless steel (s.s.) substrates by anodic deposition. The nucleation and growth mechanism of electrodeposited RuO₂ film has been studied by cyclic voltammetry (CV) and chronoamperometry (CA). The deposited films were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM) and energy dispersive analysis by X-rays (EDAX) for structural, morphological, and compositional studies. The electrochemical supercapacitor study of ruthenium oxide thin films have been carried out for different film thicknesses in 0.5 M H₂SO₄ electrolyte. The highest specific capacitance was found to be 1190 F/g for 0.376 mg/cm² film thickness.     

Effect of Nd substitution on structural and electrical properties of nanocrystalline zinc ferrite

Polycrystalline soft ferrite samples with general formula ZnNd_xFe_2−xO₄ (where x=0, 0.01, 0.02 and 0.03) were synthesized by oxalate co-precipitation method. The samples were characterized by XRD and SEM techniques. The single phase cubic spinel structure of all the samples was confirmed by XRD. The lattice constant and grain size of the samples are found to decrease with increase in Nd³⁺ content. Room temperature DC resistivity of the Nd³⁺ substituted zinc ferrites is 10² times higher than that of zinc ferrite. The dielectric constant (ε′) and dielectric loss (tan δ) of all the samples were measured in the frequency range 20 Hz-1 MHz. The dielectric behaviour is attributed to the Maxwell-Wagner type interfacial polarization. The dielectric loss of the samples is found to decrease with increase in Nd³⁺ content. High resistivity and low dielectric loss makes these ferrites particularly suitable for high frequency applications.     

Red Emitting Monoazo Disperse Dyes with Phenyl(1H-benzoimidazol-5-yl) Methanone as Inbuilt Photostabilizing Unit: Synthesis,Spectroscopic, Dyeing and DFT Studies

Synthesis of three novel phenyl(1H-benzoimidazol-5-yl)methanone based fluorescent monoazo disperse dyes and their characterization by spectroscopic methods (¹H NMR, ¹³C NMR, IR and MS) are presented. Insertion of phenyl(1H-benzoimidazol-5-yl)methanone moiety bring about induced fluorescence properties and enhanced photostability as compared to the previously reported analogues (CI Solvent Yellow 14, 4-diethylamino-2-hydroxy-1-diazobenzene and 7-(diethylamino)-4-hydroxy-3-(phenyldiazenyl)-2H-chromen-2-one). Synthesized phenyl(1H-benzoimidazol-5-yl)methanone based dyes exhibited red-shifted absorption maxima (497–516 nm), high molar extinction coefficients and are emitting in the far-red region (565–627 nm). Moreover, naphthalene-comprising dyes showed negative solvatochromism while N,N-diethylamine comprising dyes showed positive solvatochromism and are in good agreement with solvent polarity graphs and the computed energy levels of highest occupied and lowest unoccupied molecular orbitals. Synthesised dyes have better photostability (light fastness) and sublimation fastness on dyed polyester and nylon compared to reported analogues. DFT calculated energies, electrophilicity index and Frontier Molecular Orbitals (FMO’s) enabled to evaluate the stabilities of azo and hydrazone forms of the dyes.     

A Novel Application of Indocyanine Green Immunofluorescence in Emergent Colorectal Surgery

Here, we report on the feasibility of ICG fluorescence imaging to localize lesions in emergent minimally invasive surgery. A 49-year old female presented to the emergency department with a previously unknown malignant bowel obstruction. She was taken emergently to the operating room for a laparoscopic extended right hemicolectomy, based on tumor location from imaging. With intraoperative difficulty localizing the lesion, an on-table colonoscopy was performed. When the tumor was encountered, peritumoral ICG injections were performed, and the fluorescence lymphoscintigraphy was performed intraoperatively in an attempt to visualize the primary tumor laparoscopically. Intraoperative ICG Immunofluorescence allowed precise, real-time localization of the mass in the descending colon. This information changed the course of the operation, as a laparoscopic left hemicolectomy was then performed instead of the planned extended right hemicolectomy. The patient underwent an end-to-end anastomosis without the need for a defunctioning ileostomy. From this case, we demonstrate the use of ICG fluorescence imaging for tumor localization in the emergent setting is safe, feasible, and effective. This information gained from this technology enables real-time decision making, and can even change the operative plan in the emergent setting for the best patient outcomes. What does this paper add to the existing literature? This paper offers a novel application of an emerging technology- ICG fluorescence- that in this capacity allowed precise, real-time localization of a previously unknown mass in the emergent setting, and changed the course of the operation.     

Detailed heat transfer and friction factor characteristics in a rectangular duct with alternate solid and converging-slit ribs

Liquid crystal thermography and pressure drop measurements have been carried out to study the heat transfer and frictional characteristics in a rectangular duct with solid ribs (C1), converging slit-ribs (C2), and alternate solid-slit ribs (C3) mounted transversely on the bottom wall, where C2 carries a continuous converging-slit in the flow direction. Effect of rib configurations, and rib pitch to height ratios (6, 8, 10, and 12) has been investigated at Re of 9400, 26160, 42500, and 58850. Results show that converging-slit considerably enhances the heat transfer rate in the downstream vicinity, and help in obviating the local hot spot formation.

Abbreviations: LCT: Liquid crystal thermography; HTC: Heat transfer coefficient; LHI: Laser holographic interferometry; NST: Naphthalene sublimation technique; IR: Infrared; TPF: Thermo-hydraulic performance; PIV: Particle image velocimetry.     

Synthesis and characterization of new O,O‐diethyl phosphorothioates derived from substituted tetrazolo[1,5‐a]quinolin‐ 4‐ylmethanol derivatives

A simple and convenient method is developed for the synthesis of new O,O‐diethyl O‐(substituted tetrazolo[1,5‐a]quinolin‐4‐yl)methyl phosphorothioates, which has been synthesized for the first time from tetrazolo[1,5‐a] quinolines via tetrazolo[1,5‐a]quinolin‐4‐ylmethanol derivatives. The structures of the all newly synthesized compounds were elucidated by analytical and spectral methods. © 2010 Wiley Periodicals, Inc. Heteroatom Chem 20:436–441, 2009; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/hc.20570     

Sonocatalytic degradation of methylene blue using spindle shaped cerium oxide nanoparticles

Journal of Solid State Electrochemistry - The industrial revolution has raised major concern of environmental pollution, due to excess release of hazardous chemical, dyes, etc. into water bodies....     

Continuous precipitation polymerization of vinylidene fluoride in supercritical carbon dioxide: molecular weight distribution

The surfactant-free precipitation polymerization of vinylidene fluoride (VF2) in supercritical carbon dioxide was studied in a continuous stirred autoclave. The polymerization temperature ranged from 65 to 85°C, the average residence time in the reactor varied from 10 to 50 min., and the pressure was between 210 and 305 bar. Diethyl peroxydicarbonate was used as the initiator. The fractional conversion of monomer varied from 7 to 26%, the number-average molecular weight of the polymer was between about 14,000 and 79,000, and the weight-average molecular weight was between about 21,000 and 700,000. In many cases, the polymer exhibited a bimodal molecular-weight distribution, especially at high monomer concentrations.