Adsorption-penetration studies of glucose oxidase into phospholipid monolayers at the 1,2-dichloroethane/water interface.

The interaction between glucose oxidase (GOx) and phospholipid monolayers is studied at the 1,2-dichloroethane/water interface by electrochemical impedance spectroscopy. Electrochemical experiments show that the presence of GOx induces changes in the capacitance curves at both negative and positive potentials, which are successfully explained by a theoretical model based on the solution of the Poisson-Boltzmann equation. These changes are ascribed to a reduced partition coefficient of GOx and an increase of the permittivity of the lipid hydrocarbon domain. Our results show that the presence of lipid molecules enhances the adsorption of GOx molecules at the liquid/liquid interface. At low lipid concentrations, the adsorption of GOx is probably the first step preceding its penetration into the lipid monolayer. The experimental results indicate that GOx penetrates better and forms more stable monolayers for lipids with longer hydrophobic tails. At high GOx concentrations, the formation of multilayers is observed. The phenomenon described here is strongly dependent on 1) the GOx and lipid concentrations, 2) the nature of the lipid, and 3) the potential drop across the interface.     

SINGLE- and DOUBLE-STRAND BREAK FORMATION IN DOUBLE-STRANDED DNA UPON NANOSECOND LASER-INDUCED PHOTOIONIZATION

Double-stranded (ds) calf thymus DNA (0.4 mM), excited by 20 ns laser pulses at 248 nm, was studied in deoxygenated aqueous solution at room temperature and pH 6.7 in the presence of a sodium salt (10 mM). The quantum yields for the formation of hydrated electrons (phi c-), single-strand breaks (phi ssb) and double-strand breaks (phi dsb) were determined for various laser pulse intensities (IL). phi c- and phi ssb increase linearly with increasing IL; however, phi ssb has a tendency to reach saturation at high IL (greater than 5 X 10(6) Wcm-2). The ratio phi ssb/phi c-, representing the number of ssb per radical cation, is about 0.08 at IL less than or equal to 5 X 10(6) Wcm-2. For comparison, the number of ssb per OH radical reacting with dsDNA is 0.22. On going from argon to N2O saturation, phi ssb and phi dsb become larger by factors of approximately 5 and 10-15, respectively. This enhancement is produced by attack on DNA bases by OH radicals generated by N2O-scavenging of the photoelectrons. While phi ssb is essentially independent of the dose (Etot), phi dsb depends linearly on Etot in both argon- and N2O-saturated solutions. The linear dependence of phi dsb implies a square dependence of the number of dsb on Etot. This portion of dsb formation is explained by the occurrence of two random ssb, generated within a critical distance (h) in opposite strands. For both argon- and N2O-saturated solutions h was found to be of the order of 40-70 phosphoric acid diester bonds. On addition of electron scavengers such as 2-chloroethanol (or N2O plus t-butanol), phi dsb is similar to that in neat, argon-saturated solutions. Thus, hydrated electrons are not involved in the chemical pathway leading to laser-pulse-induced dsb of DNA.     

Über die dilatometrisch indizierten Titrationen

Dilatometrical indication can be employed to the neutralizing reactions of polybasic acids and is demonstrated by the following acid-base couples: H₂SO₄/NaOH, H₃PO₄/NaOH and H₅JO₆/NaOH. With amounts between 0.5 and 4 mMol several, frequently all, equivalence points can be determined with a deviation of less than 0.2%. The determination of the changes of molar volume of the reactions depending on the concentrations allow conclusions as to the course of the reactions.     

Improved quantitation of 2,4-dichlorophenol in plant tissues by high-performance liquid chromatography with amperometric detection

For the determination of 2,4-dichlorophenol (DCP) residues in plant tissues, the use of high-performance liquid chromatography with amperometric detection decreases the quantitation limits by a factor of five compared to those obtained with gas chromatography with Hall conductivity detection. It also avoids the clean-up and derivatization procedures required for electron-capture detection. After extraction of DCP from plant tissue by steam distillation and collection in toluene, an alumina clean-up column is used to remove electroactive interferences from the samples. The DCP is then extracted into aqueous alkaline solution, neutralized, and diluted with acetonitrile to ca. 50% (v/v). An alternative clean-up made use of an in-line, pre-column electrochemical procedure, in which case the alumina column was not used. The components were separated with a reverse-phase column and detected with a polychlorotrifluoroethylene/graphite composite electrode at an applied potential of +1.0 V vs. Ag/AgCl. The quantitation limit for DCP in the plant tissues was 100 pg per injection (0.05 mg Kg^?1).     

Preparation of β-hydroxyesters from isoxazolines. A selective Nibpy-catalyzed electrochemical method

An electrocatalytic method for the reductive N-O cleavage of isoxazolines is described. Ni⁰bpy, generated in situ, was used to promote selective ring opening of 3-methoxy-5-phenylisoxazoline (1a) and 3-methoxy-[4,5]cyclohexylisoxazoline (1b). DMF and NaI were used as solvent and supporting electrolyte, and β-hydroxyesters 2a and 2b were obtained in high yields respectively, after acid hydrolysis. β-Hydroxynitriles 3a and 3b were also identified as side products.     

Mechanistic study of stereoselective gas-phase reactions of phosphenium ions with cis- and trans-1,2-diaminocyclohexanes

The 1,3-dioxolane-2-phosphenium ion, 1,3-benzodioxole-2-phosphenium ion, and o-biphenylenephosphenium ion are reported to react in a stereoselective manner with cis- and trans-1,2-diaminocyclohexanes in the gas phase in a Fourier transform ion cyclotron resonance mass spectrometer. Elimination of NH3 from an addition product was observed only for the trans isomer. Several reaction mechanisms were experimentally and computationally examined (B3LYP/6-31G(d)//HF/6-31G(d) + ZPVE level of theory). The most plausible mechanism is initiated by addition of one of the amino groups to the electrophilic phosphorus atom followed by proton transfer between the amino groups. A change to a diaxial conformation for the trans isomer facilitates anchimeric assistance by the now nucleophilic phosphorus atom as the C-N bond breaks to release NH3. Intramolecular proton transfer competes with the conformational change and ultimately leads to ethylene glycol elimination. The transition states for the critical steps of these two reactions are calculated to be nearly equal in magnitude, which rationalizes the observation of both reactions for the trans-diamine. In contrast, the adduct of the cis isomer can eliminate NH3 via a concerted 1,2-hydride shift without a need for a conformational change. However, the barrier associated with this reaction was found to be substantially greater than for proton transfer between the N- and O-atoms. The latter reaction dominates and ultimately leads to ethylene glycol elimination.     

Plutonium Activity Ratios in Plankton: New Evidence of Hold-Up Time in Irish Sea Sediments

The determination of activity ratios for radioisotopes of different half-lives can be used to estimate transit times from a point source to locations further away. For conservative elements, this time is approximately equivalent to the net hydrological transport. However, for non-conservative elements such as plutonium, the additional influence of biogeochemical processes decreases the net transport time. In this study, ²⁴¹Pu and ^239,240Pu concentrations in Irish Sea plankton samples, collected in May 1994, were determined and the ²⁴¹Pu/^239,240Pu ratios calculated. Plutonium-239,240 was measured using a standard method by ion exchange chromatography and alpha counting, and ²⁴¹Pu was determined by liquid scintillation counting using the disk-supported technique. The latter showed some methodological problems, which are briefly discussed. The ²⁴¹Pu/^239,240Pu ratios gave an estimate of the "transit time" from Sellafield to the different sampling points. In fact, this time represents the age of plutonium in plankton, i.e., the time lag between release from Sellafield and detection at the different sampling stations. The mean plutonium age was 17±2 years (n = 10) and 18.6±0.8 years (n = 13) in phytoplankton and zooplankton, respectively. The spatial distribution was reasonably homogeneous over the Irish Sea. The assimilation-elimination processes of plutonium in plankton are rather rapid. Therefore, it may be assumed that, in this time scale, the plutonium concentrations were in equilibrium with surrounding waters. Thus, it is concluded that plutonium was rather old because resuspension-sedimentation processes had occurred that delayed its transport within the Irish Sea. Therefore, the age of plutonium in plankton represented the hold-up time of plutonium in the sediments from the Irish Sea.     

Determination of volatile corrosion inhibitors by capillary electrophoresis

In this work, a capillary electrophoresis (CE) method using indirect UV detection (214nm) for the simultaneous determination of monoethanolamine (MEA), diethanolamine (DEA), triethanolamine (TEA), diethylethanolamine (DEEA), monocyclohexylamine (MCHA) and dicyclohexylamine (DCHA) in water/ethanol extracts of wrapping materials containing volatile corrosion inhibitors (VCIs) was described. A running buffer consisting of 0.010 molL(-1) imidazole, 0.010 molL(-1) 2-hydroxyisobutyric acid (HIBA) and 0.010 molL(-1) 18-crown-6 ether enabled separation of the analytes in less than 7 min. A few method validation parameters were determined revealing good migration time repeatability (<0.7% RSD) and area repeatability (< 1.8% RSD). Limits of detection were in the range of 0.52-1.54 mg L(-1). Recovery values were in the range of 94.8-100.9%. The methodology was successfully applied to the analysis of three commercial products (VCI treated paper, foam and plastic). The concentration of amines in these materials varied from 0.050 to 22.3% (w/w).     

Synthesis and NMR studies of (13)C-labeled vitamin D metabolites

Isotope-labeled drug molecules may be useful for probing by NMR spectroscopy the conformation of ligand associated with biological hosts such as membranes and proteins. Triple-labeled [7,9,19-(13)C(3)]-vitamin D(3) (56), its 25-hydroxylated and 1 alpha,25-dihydroxylated metabolites (58 and 68, respectively), and other labeled materials have been synthesized via coupling of [9-(13)C]-Grundmann's ketone 39 or its protected 25-hydroxy derivative 43 with labeled A ring enyne fragments 25 or 26. The labeled CD-ring fragment 39 was prepared by a sequence involving Grignard addition of [(13)C]-methylmagnesium iodide to Grundmann's enone 28, oxidative cleavage, functional group modifications leading to seco-iodide 38, and finally a kinetic enolate S(N)2 cycloalkylation. The C-7,19 double labeling of the A-ring enyne was achieved by the Corey-Fuchs/Wittig processes on keto aldehyde 11. By employing these labeled fragments in the Wilson-Mazur route, the C-7,9,19 triple-(13)C-labeled metabolites 56, 58, and 68 as well as other (13)C-labeled metabolites have been prepared. In an initial NMR investigation of one of the labeled metabolites prepared in this study, namely [7,9,19-(13)C(3)]-25-hydroxyvitamin D(3) (58), the three (13)C-labeled carbons of the otherwise water insoluble steroid could be clearly detected by (13)C NMR analysis at 0.1 mM in a mixture of CD(3)OD/D(2)O (60/40) or in aqueous dimethylcyclodextrin solution and at 2 mM in 20 mM sodium dodecyl sulfate (SDS) aqueous micellar solution. In the SDS micellar solution, a double half-filter NOESY experiment revealed that the distance between the H(19Z) and H(7) protons is significantly shorter than that of the corresponding distance calculated from the solid state (X-ray) structure of the free ligand. The NMR data in micelles reveals that 58 exists essentially completely in the alpha-conformer with the 3 beta-hydroxyl equatorially oriented, just as in the solid state. The shortened distance (H(19Z))-H(7)) in micellar solutions as compared to that in the solid state is most easily rationalized on the basis that the 5(10)-torsion angle in 58 is decreased in micellar solutions as compared to that in the solid state.     

A combined theoretical and experimental study of efficient and fast titanocene-catalyzed 3-exo cyclizations

The mechanism of titanocene mediated 3-exo cyclizations was investigated by a combined theoretical and experimental study. A gradient corrected density functional theory (DFT) method has been scaled against titanocene dichloride, the parent butenyl radical, and in bond dissociation energy (BDE) calculations. The BP86 method using density fitting, and a basis set of triple-zeta quality emerged as a highly reliable tool for studying titanocene mediated radical reactions. The computational results revealed important kinetic and thermodynamic features of cyclopropane formation. Surprisingly, the beta-titanoxy radicals, the first intermediates of our investigations, were demonstrated to possess essentially the same thermodynamic stabilization as the corresponding alkyl radicals by comparison of the calculated BDEs. In contrast to suggestions for samarium mediated reactions, the cyclization was shown to be thermodynamically favorable in agreement with earlier kinetic studies. It was established that stereoselectivity of the cyclization is governed by the stability of the intermediates and thus the trans disubstituted products are formed preferentially. The observed ratios of products are in good to excellent agreement with the DFT results. By a combination of computational and experimental results, it was also shown that for the completion of the overall cyclopropane formation the efficiency of the trapping of the cyclopropylcarbinyl radicals is decisive.